SKYWORKS SKY77198-12

PRODUCT SUMMARY
SKY77198-12 Power Amplifier Module for TD-SCDMA
(1880–1920 MHz, 2010-2025 MHz)
Applications
Description
• TD-SCDMA handsets
The SKY77198-12 Power Amplifier Module (PAM) is a fully matched, 10-pad, surface mount module
developed for Time Division Synchronous Code Division Multiple Access (TD-SCDMA) applications.
Skyworks’ SKY77198-12 also supports TD-SCDMA multi-slot operation.
Features
• Low voltage positive bias
supply
- 3.2 V to 4.2 V
• Supports low collector
voltage operation
• Good linearity
• High efficiency
- 40% @ 28 dBm
• Large dynamic range
• Small, low profile package
- 3 mm x 3 mm 0.85 mm
- 10-pad configuration
• Power-down control
• Low power-state control
This small and efficient module packs full 1880–1920 MHz and 2010-2025 MHz bandwidth coverage
into a single compact package. The PAM meets the stringent spectral linearity requirements of
TD-SCDMA transmission, with high power added efficiency for power output of up to 28 dBm.
A single Gallium Arsenide (GaAs) Microwave Monolithic Integrated Circuit (MMIC) contains all active
circuitry in the module such as on-board bias circuit and input and interstage matching circuits.
Output match is realized off-chip within the module package to optimize efficiency and power
performance into a 50 Ω load.
This device is manufactured with Skyworks’ InGaP GaAs Heterojunction Bipolar Transistor (HBT) BiFET
process that provides for all positive voltage DC supply operation while maintaining high efficiency
and good linearity.
Power-down is accomplished by setting the voltage on VENABLE to zero volts. No external supply side
switch is needed as typical “off” leakage is a few microamperes with full primary voltage supplied
from the battery.
• InGaP
• CMOS Compatible Control
• Integrated Directional
Coupler
Figure 1. SKY77198-12 Functional Block Diagram
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • [email protected] • www.skyworksinc.com
201223A • Skyworks Proprietary and Confidential information. • Products and product information are subject to change without notice. • January 25, 2010
1
© 2010, Skyworks Solutions, Inc. All Rights Reserved.
Information in this document is provided in connection with Skyworks Solutions, Inc. (“Skyworks”) products or services. These materials, including the information contained herein, are provided by
Skyworks as a service to its customers and may be used for informational purposes only by the customer. Skyworks assumes no responsibility for errors or omissions in these materials or the
information contained herein. Skyworks may change its documentation, products, services, specifications or product descriptions at any time, without notice. Skyworks makes no commitment to
update the materials or information and shall have no responsibility whatsoever for conflicts, incompatibilities, or other difficulties arising from any future changes.
No license, whether express, implied, by estoppel or otherwise, is granted to any intellectual property rights by this document. Skyworks assumes no liability for any materials, products or
information provided hereunder, including the sale, distribution, reproduction or use of Skyworks products, information or materials, except as may be provided in Skyworks Terms and Conditions of
Sale.
THE MATERIALS, PRODUCTS AND INFORMATION ARE PROVIDED “AS IS” WITHOUT WARRANTY OF ANY KIND, WHETHER EXPRESS, IMPLIED, STATUTORY, OR OTHERWISE, INCLUDING FITNESS FOR A
PARTICULAR PURPOSE OR USE, MERCHANTABILITY, PERFORMANCE, QUALITY OR NON-INFRINGEMENT OF ANY INTELLECTUAL PROPERTY RIGHT; ALL SUCH WARRANTIES ARE HEREBY EXPRESSLY
DISCLAIMED. SKYWORKS DOES NOT WARRANT THE ACCURACY OR COMPLETENESS OF THE INFORMATION, TEXT, GRAPHICS OR OTHER ITEMS CONTAINED WITHIN THESE MATERIALS. SKYWORKS
SHALL NOT BE LIABLE FOR ANY DAMAGES, INCLUDING BUT NOT LIMITED TO ANY SPECIAL, INDIRECT, INCIDENTAL, STATUTORY, OR CONSEQUENTIAL DAMAGES, INCLUDING WITHOUT LIMITATION,
LOST REVENUES OR LOST PROFITS THAT MAY RESULT FROM THE USE OF THE MATERIALS OR INFORMATION, WHETHER OR NOT THE RECIPIENT OF MATERIALS HAS BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGE.
Skyworks products are not intended for use in medical, lifesaving or life-sustaining applications, or other equipment in which the failure of the Skyworks products could lead to personal injury,
death, physical or environmental damage. Skyworks customers using or selling Skyworks products for use in such applications do so at their own risk and agree to fully indemnify Skyworks for any
damages resulting from such improper use or sale.
Customers are responsible for their products and applications using Skyworks products, which may deviate from published specifications as a result of design defects, errors, or operation of
products outside of published parameters or design specifications. Customers should include design and operating safeguards to minimize these and other risks. Skyworks assumes no liability for
applications assistance, customer product design, or damage to any equipment resulting from the use of Skyworks products outside of stated published specifications or parameters.
Skyworks, the Skyworks symbol, “Breakthrough Simplicity,” DCR, Helios, HIP3, Innovation to Go, Intera, iPAC, LIPA, Polar Loop, and System Smart are trademarks or registered trademarks of
Skyworks Solutions, Inc., in the United States and other countries. Third-party brands and names are for identification purposes only, and are the property of their respective owners. Additional
information, including relevant terms and conditions, posted at www.skyworksinc.com, are incorporated by reference.