Multi-Rate SFP Transceiver(IR1) SP-MR-IR1 Features • Single 3.3V supply • 15 km reach • 15dB min, 19.5 typical link budget • Commercial and Reduced Industrial temperature available • 1310nm DFB laser • SFP MSA SFF-8074i compliant • GR 253/STM G.957 compliant • Digital Diagnostic SFF-8472 Rev.9.3 compliant • Telcordia GR-468 compliant • RoHS 5/6 compliant (Lead Exemption) General Operating Parameter Symbol Min. Typ. Max. Supply Voltage Vcc 3.135 3.3 3.465 Unit V Total Current ICC - - 300 mA Power Supply Noise Rejectiona RSP 100 - - mVp-p Operating Temperature(Cxx) Top -5 - 70 ºC Operating Temperature(-Rxx) Top -20 - 85 ºC Storage Temperature Tstg -40 - 85 ºC Data Rate DR 100 - 2700 Mbps a) 20Hz to 155MHz Transmitter Specifications, Optical Parameter Symbol Min Typical Max Unit Optical power Pop -5 -2.5 0 dBm Average Launch power of off Tx Poff - - -30 dBm Extinction Ratio ER 8.2 - - dB Eye Mask IEEE 802.3z, SONET/SDH compliant Optical Jitter generation Jgen - - 0.007 UI timeb tr - - 160 ps Optical Fall timeb tf - - 160 ps Optical Rise λ 1260 - 1360 nm Spectral width (20 dB) ∆λ - - 1 nm Dispersion penalty(15Km)c dp - 0.5 1 dB Relative Intensity Noise RIN - - -120 dB/Hz Reflectance Tolerance rp -24 - - dB Mean Wavelength b) 20%-80% values c) Measured at BER of 1e-12, PRBS of 223-1, at eye center d) 1 dB degradation of receiver sensitivity LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 1 LUMNDS1527-FEB2206 rev.A.0 Multi-Rate SFP Transceiver(IR1) SP-MR-IR1 Transmitter Specifications , Electrical Parameter Symbol Min Typical Max Unit Rin 80 100 120 Ω Vin, p-p 250 - 1200 mV Vfault 2 - Vcc V Vnormal Vd Vee - Vee + 0.5 V TxDisable_Disable 2 - Vcc V TxDisable_Enable Ven Vee - Vee + 0.8 V Parameter Symbol Min Typical Max Unit Receiver Power Lowe Rsens,low - -22 -20 dBm Receiver Power Highe Rsens,high 0 - - dBm Damage Threshold for Receiver Pin, damage 5 - - dBm λ 1260 1310 1360 nm RX_r - - -27 dB LOS Assert - -30 - - dBm LOS De-assert - - - -20 dBm LOS hysteresis - 0.5 - - dB Input Differential Impedence PECL Single Ended data input swing TxFault_Fault TxFault_Normal Receiver Specifications, Optical Wavelengthf Maximum Reflectance of Receiver e) at 10-10 BER, PRBS 223-1 for SONET, 10-12 BER, PRBS 27-1 for Gigabit ethernet f) Operational over 1200-1625 nm range Electrical Output Parameter Symbol Min Typical Max Unit PECL Single ended data output swing Vout,p-p 185 - 800 mV tr - - 175 ps tf - - 175 ps Data output rise time Data output fall time LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 2 LUMNDS1527-FEB2206 rev.A.0 Multi-Rate SFP Transceiver(IR1) SP-MR-IR1 Timing and Electrical Parameter Symbol Min Typical Max Unit Tx Disable Negate time t_on - Tx Disable assert time t_off - - 1 ms - 10 Time to initialize, including reset of Tx fault t_init µs - - 300 ms Tx fault Assert time t_fault - - 100 µs Tx Disable to reset t_reset 10 - - µs t_loss_on - - 100 µs t_loss_off f_serial_clock Rx_LOSH 2 - 100 100 - µs KHz V LOS Assert time LOS De-assert time Serial ID Clock Rate RX_LOS Voltage (high) RX_LOS Voltage (low) RX_LOSL - - 0.8 V LOS output voltage-Fault VLOS fault 2 - Vcc V VLOS normal Vee - Vee + 0.5 V MOD_DEF (0:2)-High Vh 2 - VI Vee - Vcc Vee + 0.5 V MOD_DEF (0:2)-Low LOS output voltage-Normal V Diagnostics Parameter Range Accuracy Unit Calibration Bit Value Formula Temperature(-CDx) -5 to 70 ±3 ºC Internal 1/256 C Tc(C) = Tad(16 bit signed twos complement)/256 Temperature(-RDx) -20 to 85 ±3 ºC Internal 1/256 C Tc(C) = Tad(16 bit signed twos complement)/256 Voltage 0 to Vcc 0.1 V Internal 100µV V(Volts) = Vad(16 bit unsigned integer)*0.1 Bias Current 0 to 120 5 mA External - I(mA) = Islope * Iad(16 bit unsigned integer)+Ioffset Tx Power -5 to 0 ±3dB dBm External - Tx_PWR(µW) = Tx_PWRslope*Tx_PWRad(16 bit unsigned integer)+Tx_PWRoffset Rx Power -24 to 0 ±3dB dBm External - Rx_PWR(µW) = A0+A1*x+A2*x^2+A3*x^3+A4*x^4 LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 3 LUMNDS1527-FEB2206 rev.A.0 Multi-Rate SFP Transceiver(IR1) SP-MR-IR1 EEPROM Serial ID Name of Field Discription of Field SFPVendor name (ASCII) Vendor Name IEEE vendor OUI code for LuminentOIC Inc. Vendor OUI Part number in ASCII, e.g. SP-MR-IR1-CDA Vendor PN Address Hex ASCII 20 4C L 21 55 U 22 4D M 23 49 I 24 4E N 25 45 E 26 4E N 27 54 T 28 4F O 29 49 I 30 43 C 37 00 38 06 39 B5 40 53 41 50 P 42 4D M 43 52 R 44 49 I 45 52 R 46 31 1 47 43 C 48 44 49 41 D A S Pinout Definitions Pin Function Notes 1 VeeT TX GND 2 TX_FAULT Open Collector 3 TX_DISABLE Internally Pulled High 4 MOD_DEF2 Serial Data Input 5 MOD_DEF1 Serial Clock Input 6 MOD_DEF0 Internally Grounded 7 NC Not Connected 8 LOS Open Collector 9 VeeR RX Ground 10 VeeR RX Ground 11 VeeR RX Ground 12 RXD- RX Data Negative 13 RXD+ RX Data Positive 14 VeeR RX GND 15 VCCR RX Power 16 VCCT TX Power 17 VeeT TX GND 18 TXD+ TX Data Positive 19 TXD- TX Data Negative 20 VeeT TX GND LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 4 LUMNDS1527-FEB2206 rev.A.0 Multi-Rate SFP Transceiver(IR1) SP-MR-IR1 Outline Drawing Units in mm(inch) Suggested Transceiver Interface 1µH V CC 10 µF Protocol IC 0.1 µF 1µH VCC .01µF R1 LuminentOIC SFP 10k Ω TX_DISABLE TX_DISABLE T TX_FAULT TX_FAULT Laser Driver .01µF TD + SerDes 100Ω TD .01µF VEE T VCC R 10µF Receiver Amplifier 0.1µF RD + .01µF 100Ω RD .01µF RX_LOS RX_LOS V CC VEE R1 R1 R EEPROM R1 R1 MOD_DEF 2 MOD_DEF 1 MOD_DEF 0 R 1 = 4.7Κ to 10ΚΩ LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 5 LUMNDS1527-FEB2206 rev.A.0 Multi-Rate SFP Transceiver(IR1) SP-MR-IR1 Ordering Information A vailable Options: SP-M R-IR1-CDA SP-M R-IR1-CNA SP-M R-IR1-RDA SP-M R-IR1-RNA Part numbering Definition: SP - M R - IR1 - Temperature Diagnostic Revision • SP = Small Form Pluggable M R = M ulti Rate IR1 = Intermediate reach 15km • Operating Temperature C = Commeracial (-5 to 70) R = Reduced industrial (-20 to 85) • D = Digital Diagnostic N = No Digital Diagnostic • Design Revision Warnings: Handling Precautions: This device is susceptible to damage as a result of electrostatic discharge (ESD). A static free environment is highly recommended. Follow guidelines according to proper ESD procedures. Laser Safety: Radiation emitted by laser devices can be dangerous to human eyes. Avoid eye exposure to direct or indirect radiation. Legal Notes: IMPORTANT NOTICE! All information contained in this document is subject to change without notice, at LuminentOIC’s sole and absolute discretion. LuminentOIC warrants performance of its products to current specifications only in accordance with the company’s standard one-year warranty; however, specifications designated as “preliminary” are given to describe components only, and LuminentOIC expressly disclaims any and all warranties for said products, including express, implied, and statutory warranties, warranties of merchantability, fitness for a particular purpose, and non-infringement of proprietary rights. Please refer to the company’s Terms and Conditions of Sale for further warranty information. LuminentOIC assumes no liability for applications assistance, customer product design, software performance, or infringement of patents, services, or intellectual property described herein. No license, either express or implied, is granted under any patent right, copyright, or intellectual property right, and LuminentOIC makes no representations or warranties that the product(s) described herein are free from patent, copyright, or intellectual property rights. Products described in this document are NOT intended for use in implantation or other life support applications where malfunction may result in injury or death to persons. LuminentOIC customers using or selling products for use in such applications do so at their own risk and agree to fully defend and indemnify LuminentOIC for any damages resulting from such use or sale. THE INFORMATION CONTAINED IN THIS DOCUMENT IS PROVIDED ON AN “AS IS” BASIS. Customer agrees that LuminentOIC is not liable for any actual, consequential, exemplary, or other damages arising directly or indirectly from any use of the information contained in this document. Customer must contact LuminentOIC to obtain the latest version of this publication to verify, before placing any order, that the information contained herein is current. © LuminentOIC, Inc. 2003 All rights reserved LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 6 LUMNDS1527-FEB2206 rev.A.0