25- 30 WATT SWITCHING POWER SUPPLIES DESCRIPTION PUP30 SERIES (LVD+EMC) The PUP30 series of AC/DC switching power supplies are for 25 to 30 watts of continuous output power. They are enclosed in a 94V-1 rated polyphenylene-oxide case with an IEC 320 inlet to mate with interchangeable cord for world-wide use. All models meet CISPR 22 and FCC class B emission limits, and comply with UL, CSA, IEC and CE requirements. F E ATU R E S ‧ ‧ ‧ ‧ ‧ ‧ ‧ ‧ ‧ 15 standard desktop models Single, dual or triple outputs Optional output connectors Optional on/off switch 100﹪ burn-in W i d e i n p u t r a n g e 8 5 t o 2 6 4 VA C Input surge current protection Overvoltage protection Overcurrent protection S a f e t y St a n d a r d A p p ro v a ls ： UL 60950-1 CSA C22.2 No. 60950-1 I N P U T S P E C I F I C ATI O N S Input voltage： Input frequency： Input current： Leakage current： 8 5 t o 2 6 4 VA C 47 to 63 Hz 0 . 8 0 A （ r m s ） f o r 11 5 VA C 0 . 5 0 A （ r m s ） f o r 2 3 0 VA C 0 . 4 7 m A m a x . @ 11 5 VA C , 6 0 H z 0 . 8 5 m A m a x . @ 2 3 0 VA C , 5 0 H z TÜV EN60950-1 OUTPUT SPECIFICATIONS GENERAL SPECIFICATIONS Output voltage/current： Output power range： Ripple and noise： Overvoltage protection： See rating chart 30 watts maximum 1﹪ peak to peak maximum Provided on output #1 only; set at 112 - 132 ﹪ of its nominal output voltage Switching frequency： 30KHz ±5KHz Efficiency： 70﹪ minimum on single output models with Vo ≥ 12V, 65% minimum on the others 10 msec minimum at 110VAC ±0.5﹪ maximum at full load All outputs protected to short circuit conditions All outputs ±0.04 ﹪ / ℃ maximum Maximum excursion of 4 ﹪ or better on all models, recovering to 1 ﹪ of final value within 500us after a 25 ﹪ step load change Inrush current： Overcurrent protection： Temperature coefficient： Transient response： ENVIRONMENTAL SPECIFICATIONS Operating temperature： 0℃ to +70℃ St o r a g e t e m p e r a t u r e ： -40℃ to +85℃ Relative humidity： 5﹪ to 95﹪ non-condensing Derate from 100% at +50℃ linearly Derating： to 50﹪at +70℃ Hold-up time： Line regulation： 15 amps @ 115VAC, or 30 amps @ 230VAC, at 25℃ cold start Withstand voltage： 3000VAC from input to output 1500VAC from input to ground 500VAC from output to ground MTBF： 400,000 hours minimum at full load at 25℃ ambient , calculated per MIL-HDBK-217F EMC performance (EN55024) EN55022: Class B conducted, class B radiated FCC: Class B conducted, Class B radiated VCCI: Class B conducted, Class B radiated EN61000-3-2: Harmonic distortion, Class A and D EN61000-3-3: Line flicker EN61000-4-2: ESD, ± 8KV air and ± 4KV contact EN61000-4-3: Radiated immunity, 3V/m EN61000-4-4: Fast transient/burst, ± 1KV EN61000-4-5: Surge, ± 1KV diff., ± 2KV com. EN61000-4-6: Conducted immunity, 3Vrms EN61000-4-8: Magnetic field immunity, 1A/m E N 6 1 0 0 0 - 4 - 11 : Voltage dips, 30 ﹪ reduction for 500ms and >95﹪ reduction for 10ms Tumbler Technologies + TRUMPower 3 3 5 0 S c o t t B l vd . , B l d g . 1 3 , S a n ta C l a r a , C a l i f o r n i a 9 5 0 5 4 , U S A P h o n e : 4 0 8 - 9 8 8 - 6 6 1 6 ● s a l e s @ t r u m p o w e r. c o m ● w w w.T R U M Po w e r.c o m PUP30 SERIES UNIVERSAL INPUT OUTPUT VOLTAGE/CURRENT RATING CHART (1)(2) Model PUP30-10 PUP30-10-1 PUP30-11 PUP30-12 PUP30-13 PUP30-13-1 PUP30-14 PUP30-16 PUP30-17 PUP30-18 PUP30-23 PUP30-24 PUP30-25 PUP30-31 PUP30-32 Notes: Output #1 Imin. Imiax. 0A 5.0A 0A 4.5A 0A 3.3A 0A 2.7A 0A 2.3A 0A 1.7A 0A 1.4A 0A 1.1A 0A 0.9A 0A 0.7A 0.3A 3.0A 0.3A 3.0A 0.3A 3.0A 0.3A 3.0A 0.3A 3.0A Vnom. 5-6V 6-8V 9-11V 11-13V 13-17V 17-21V 21-27V 27-33V 33-39V 48V +5V +5V +5V +5V +5V Tol. 5% 2% 2% 2% 2% 2% 2% 2% 2% 2% 5% 5% 5% 5% 5% Vnom. +12V +15V +24V +12V +15V Output #2 Imin. Imax. (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) 0.1A 2.0A 0.1A 1.5A 0.1A 1.0A 0A 0.8A 0A 0.8A Tol. Vnom. 5% 5% 5% 5% 5% -12V -15V Output #3 Imin. Imax. (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) 0A 0.8A 0A 0.8A Tol. 5% 5% Maximum Output Power 25W 27W 30W 30W 30W 30W 30W 30W 30W 30W 30W 30W 30W 30W 30W (1) The output voltage of a single output model, except PUP30-18, can be adjusted by user in the stated range, or set by factory to a wanted value in the range at the request of a user when ordering. (2) Output #2 and #3 are with low drop voltage regulators. The output #1 of the multiple output models need a minimum current of 0.3A to support the other outputs at their maximum rated loads to be within voltage tolerance. MECHANICAL SPECIFICATIONS 5-PIN DIN PLUG NOTES: 1. Dimensions shown in inch [mm] 2. Tolerance 0.02 [0.5] maximum 3. Weight: 550 grams approx. 4. See pages 6-1 to 6-8 for optional output connectors. Add the suffix assigned for a selected connector to a wanted model number, e.g. PUP30-10-B1, for ordering. PIN CHART PIN 1 2 3 4 5 RETURN RETURN OUTPUT #1 RETURN OUTPUT #1 COMMON RETURN COMMON RETURN COMMON RETURN COMMON RETURN OUTPUT #1 OUTPUT #1 COMMON RETURN OUTPUT #3 OUTPUT #2 OUTPUT #2 MODEL PUP30-10 PUP30-13 PUP30-17 PUP30-23 PUP30-10-1 PUP30-11 PUP30-12 PUP30-13-1 PUP30-14 PUP30-16 PUP30-18 PUP30-24 PUP30-25 PUP30-31 PUP30-32 Tumbler Technologies + TRUMPower 3 3 5 0 S c o t t B l v d . , B l d g . 1 3 , S a n ta C l a r a , C a l i f o r n i a 9 5 0 5 4 , U S A P h o n e : 4 0 8 - 9 8 8 - 6 6 1 6 ● s a l e s @ t r u m p o w e r. c o m ● w w w . T R U M P o w e r. c o m