AC-DC PCB Mount 5-10 Watts THE XPERTS IN POWER CPF Series • PCB Mounting • Low Cost • Universal Input • Small Footprint • Rugged Design • Surface Mount Technology • Accessory Mounting Boards Specification Input General Input Voltage Input Frequency Input Current • • • 85-264 VAC (110-370 VDC) 47-440 Hz 0.3 A max (110 VAC Io = 100%) Inrush Current • 15 A typical (110 VAC Io = 100%), 30 A typical (230 VAC = Io 100%) Switching Frequency • Earth Leakage Current • at cold start 0.5 mA max at 230 VAC 60 Hz Environmental Output Output Voltage Minimum Load Start-Up Delay Hold-Up Time Initial Set Accuracy Drift Line Regulation Load Regulation Ripple & Noise Overvoltage Protection Overcurrent Protection Temperature Coefficient • • • • • • • • • • • • See Table No minimum load required 700 ms max at rated input & load 10 ms min -3%, +6% max 0.6% max See Table See Table 260 mV pk-pk max, 20 MHz bandwidth Operates >115% Vnom, clamps by zener diode Operates >125% of rating, auto recovery 0.04%/°C Efficiency Isolation • • Operating Temperature Storage Temperature Humidity Shock Vibration • • See Table 3000 VAC Input to Output 2000 VAC Input to Ground 500 VAC Output to Ground 100 kHz typical -10 °C to +55 °C (derate linearly above +55 °C to 25% at +70 °C) -20 °C to +75 °C • • • 20-95% RH non-condensing 20 G 11 ms once each X, Y & Z axis 2 G 10-55 Hz 3 min period for 60 mins along X, Y & Z axis Emissions • ESD Susceptibility • Radiated Susceptibility EFT/Burst Surge • EN55022 Level B conducted EN55022 Level B radiated EN61000-4-2 Level 3 Air, Level 2 Contact EN61000-4-3 Level 3 • • Safety Approvals • EMC & Safety EN61000-4-4 Level 3 EN61000-4-5 Level 3 line to line, Level 4 line to ground UL1950, C-UL, EN60950, VDE 0160 • • www.xpplc.com [email protected] OUTPUT VOLTAGE & CURRENT RATINGS Output Voltage 3.3 V 5.0 V 12.0 V 15.0 V 24.0 V 3.3 V 5.0 V 12.0 V 15.0 V 24.0 V Output Current 1.00 A 1.00 A 0.45 A 0.35 A 0.22 A 2.00 A 2.00 A 0.90 A 0.70 A 0.45 A Peak (1) Current 1.20 A 1.20 A 0.54 A 0.42 A 0.27 A 2.40 A 2.04 A 1.08 A 0.84 A 0.54 A Efficiency Typical 68% 77% 78% 77% 81% 65% 74% 78% 81% 81% CPF Line (2) Regulation 20 mV 20 mV 48 mV 60 mV 96 mV 20 mV 20 mV 48 mV 60 mV 96 mV Load (3) Regulation 40 mV 40 mV 100 mV 120 mV 150 mV 40 mV 40 mV 100 mV 120 mV 150 mV Model Number CPF5US03 CPF5US05 CPF5US12 CPF5US15 CPF5US24 CPF10US03 CPF10US05 CPF10US12 CPF10US15 CPF10US24 Notes 1. Peak rating duration ≤10 seconds with a max duty cycle of 35%.. 2. Measured low line to high line. 3. Measured no load to full load. • Mechanical Details 5 W MODEL 10 W MODEL Dimensions in inches (mm). Weight 30g CPF Board Weight 40g The CPF board is designed to accept any of the CPF Series models. Order CPFBOARD-M for molex connectors or CPFBOARD-T for screw terminals. CPFBOARD-M CPFBOARD-T Max height 17.5 mm Mounting hole M3 clearance. Mating Housing Molex 09-91-0500 Crimp Pins Molex 15-04-0219 www.xpplc.com Mounting hole M3 clearance. All connections screw terminals 10 mm pitch [email protected] Rev 3.0