AMEL10 Series 10 watt encapsulated ac-dc converter • SWITCHING POWER MODULES FOR PCB MOUNTING • FULLY ENCAPSULATED PLASTIC CASE • UNIVERSAL INPUT RANGE 90 ... 260VAC , 47 ... 440 Hz • REGULATED OUTPUT • LOW RIPPLE & NOISE • HIGH EFFICIENCY • CE, cUL APPROVALS All specifications valid at nominal Input voltage, full load and +25°C after warm-up time unless otherwise stated. Model No. (Single Output) AMEL10-3.3S AMEL10-5S AMEL10-12S AMEL10-15S AMEL10-24S Max output wattage (W) 10W 10W 10W 10W 10W Voltage 90 ... 260 VAC Frequency (Hz) 47 ... 440 Hz Current (Full Load) 220mA max. (115 VAC) / 150mA max. (230 VAC) Input Current (No Load) 12mA max. (115 VAC) / 14mA max. (230 VAC) Inrush Current (<2ms) 10 A max. (115 VAC) / 20 A max. 230 VAC) External Fuse (recommended) 1.5 A slow blow type Voltage (VDC) 3.3V 5V 12V 15V 24V Voltage Accuracy ±2% Current (mA) max. 2500 2000 833 667 417 Line Regulation (typ.) ±0.3% ±0.5% Load Regulation (5%-100%)(typ.) Output Minimum Load 0% Maximum Capacitive Load 470-23,000m F depending on model Ripple <0.2% Vout +40mV max (Vp-p) Noise <0.5% Vout +50mV max (Vp-p) Efficiency 70% 72% 79% 79% 79% Hold-up Time 15 ms min. Switching Frequency 125 kHz Over Current Protection Hiccup technique, auto-recovery Protection Over Voltage Protection Zener diode clamp Short Circuit Protection Hiccup mode, indefinite (automatic recovery) Isolation Input-Output (VAC) 3000V Operating Temperature -25°C ... +71°C Storage Temperature -40°C ... +85°C Environment Temperature Coefficient 0.02% / °C Humidity 20-85% RH MTBF >310,000 h @ 25°C (MIL-HDBK-217F) Dimension (L x W x H) 2.05 x 1.06 x 0.91 inches (52 x 27 x 23 mm) Case Material Plastic resin + Fiberglass (flammability to UL 94V-0) Physical Weight 54g Cooling Method Free air convection Vibration 10-55 Hz 0.5 mm width / 1 minute cycle General Shock 20 G (3 directions each 3 times) Safety Agency Approvals cUL, CE EMI (Conducted & Radiated Emission) EN 55022 class B EMC EMS (Noise Immunity) EN 55024 Specifications are subject to change without notification Continued on next page VISIT US AT WWW.AIMTEC.CA AC-DC CONVERTERS ELECTRICAL SPECIFICATIONS 107 AMEL10 Series OUTLINE DIMENSIONS & PIN CONNECTIONS MECHANICAL DIMENSION (Top View) Pin Single N L +V -V AC Input AC Input +DC Output -DC Output DERATING AC-DC CONVERTERS BLOCK DIAGRAM 108 TO ORDER CALL 1-888-9-AIMTEC