ANADIGICS AWS5506S14

AWS5506
GaAs IC SPDT Reflective Switch
Positive Control DC - 2.5 GHz
Data Sheet - Rev 2.1
FEATURES
•
•
•
•
•
Low Insertion Loss (0.4 dB @ 0.9 GHz)
Complementary Positive Control Voltages (0/
+3V to 0/+5V)
Positive Voltage Supply (+3 to +5 V)
Low DC Power Consumption
Ultra Miniature 6 Lead SOT-6 Package
APPLICATIONS
•
S14
SOT-6
6 Pin Plastic Package
Typical applications include: selection of
synthesizers, filters, amplifiers in dual mode,
and dual band handsets.
DESCRIPTION
The AWS5506 is a Single Pole Double Throw GaAs
MMIC switch assembled in a SOT-6 plastic package.
The AWS5506 is designed for analog and digital
application that require for insertion loss, small size,
and low cost. State selection is achieved with a
complimentary positive voltage (requires positive bias
Vs, and blocking caps) or negative voltage (no Vs or
blocking caps required).
Table 1: Pin Description
C1
V1
5
4
C2
3
RF2
(J3)
2
GND
6
1
RF1
(J2)
V2
RFCOM
(J1)
C4
10KΩ
Vs
DC blocking capacitors (C1, 2, 4) and biasing resistor (R1)
must be supplied externally for positive voltage operation.
C1, 2, 4 = 100 pF for operation >500 MHz.
Figure 1: Pin Out Diagram
PIN
NAME
1
RF 1 (J2)
2
GND
3
RF2 (J3)
4
V2
5
RF COM
(J1)/Vs
6
V1
08/2001
DESCRIPTION
RF port (can be used as an input and as an output)
Ground connection (keep as short as possible)
RF port (can be used as an input or as an output)
Control voltage 2 (low 0V, High 3V to 5V)
RF common port and bias voltage for positive control
(3V to 5V)
Control voltage 1 (low 0V, High 3V to 5V)
AWS5506
ELECTRICAL CHARACTERISTICS
Table 2: Absolute Minimum and Maximum Ranges
PARAMETER
MIN
MAX
UNIT
-
2
W
Control Voltage
-0.2
+8
V
Operating Temperature
-40
+125
°C
Storage Temperature
-50
+150
°C
-
25
° C/W
RF Input Power
> 500 MHz, 0/+7 V Control
Θ JC
Stresses in excess of the absolute ratings may cause
permanent damage. Functional operation is not implied under
these conditions. Exposure to absolute ratings for extended
periods of time may adversely affect reliability. (8 pt bold)
Table 3: Operating Ranges at 25° C (0, +3V)
PARAMETER
CONDITION
FREQUENCY
MIN
TYP
MAX
UNIT
Switching Characteritics 5
Rise, Fall (10/90% or 90/10% RF)
On, Off (50% CTL to 90%/10% RF)
Video Feedthru
-
-
10
20
25
-
ns
ns
mV
Intermodulation Intercept Point (IP3)
For Two-tone Input Power +10 dBm
0.5 - 2.0 GHz
-
+45
-
dBm
Input Power for 1dB Compression
@ +3V
@ +5V
0.5 - 2.0 GHz
0.5 - 2.0 GHz
-
+21
+28
-
dBm
Control Voltage
V LOW = 0 to 0.2 V @ 20 uA Max
V HIGH = +3 V @ 100 uA Max to +5 V @ 200 uA Max
V S = VHIGH + 0.2V
The device may be operated safely over these conditions; however, parametric performance is guaranteed
only over the conditions defined in the electrical specifications.
Notes:
1. All measurements made in a 50 ohm system, unless otherwise specified.
2. DC = 300 kHz.
3. Insertion loss changes by 0.003 dB/°C.
4. Insertion loss state.
5. Video feedthru measured with 1 ns rise time pulse and 500 MHz bandwidth.
2
Data Sheet - Rev 2.1
08/2001
AWS5506
Table 4: Electrical Specifications at 25 °C (0, +3V)
1
PARAMETER
Insertion Loss
FREQUENCY 2
MIN
TYP
MAX
UNIT
DC - 0.5 GHz
DC - 1.0 GHz
DC - 2.0 GHz
DC - 2.5 GHz
-
0.4
0.45
0.6
0.9
0.5
0.6
0.8
1.1
dB
dB
dB
dB
DC - 0.5 GHz
DC - 1.0 GHz
DC - 2.0 GHz
DC - 2.5 GHz
22
17
11
10
25
20
14
13
-
dB
dB
dB
dB
DC - 1.0 GHz
DC - 2.5 GHz
-
1.2:1
1.5:1
1.3:1
1.7:1
-
3
Isolation
VSWR
4
Table 5: Truth Table
Positive Operation
V1
V2
J1 - J2
J1 - J3
VHigh
0
Insertion
Isolation
0
VHigh
Isolation
Insertion
VHigh = +3 to +5 V (VS = VHigh + 0.2 V)
Data Sheet - Rev 2.1
08/2001
3
AWS5506
Figure 2: Test Circuit Schematic
4
Data Sheet - Rev 2.1
08/2001
AWS5506
PACKAGE OUTLINE
θ
SYMBOLS
A
A1
A2
b
C
D
E
e
H
L
θ1
DIMENSIONS IN MILLIMETERS
MIN
1.00
0.00
0.70
0.35
0.10
2.70
1.40
2.60
0.37
1°
NOM
1.10
−−−
0.80
0.40
0.15
2.90
1.60
1.90(TYP)
2.80
−−−
5°
MAX
1.30
0.10
0.90
0.50
0.25
3.10
1.80
3.00
−−−
9°
DIMENSIONS IN INCHES
MIN
0.039
0.00
0.027
0.014
0.004
0.106
0.055
NOM
0.043
−−−
0.031
0.016
0.006
0.114
0.063
0.075(TYP)
0.102
0.110
0.015
−−−
1°
5°
MAX
0.051
0.004
0.035
0.020
0.010
0.122
0.071
0.118
−−−
9°
NOTES:
1. Package body sizes exclude mold flash and gate burrs.
2. Dimension L is measured in gage plane
3. Coplanarity: 0.1000 mm
4. Tolerance + 0.1000 mm (4 mil) unless otherwise specified.
Figure 3: Package Outline
Data Sheet - Rev 2.1
08/2001
5
AWS5506
NOTES
6
Data Sheet - Rev 2.1
08/2001
AWS5506
NOTES
Data Sheet - Rev 2.1
08/2001
7
AWS5506
ORDERING INFORMATION
ORDER NUMBER
PACKAGE DESCRIPTION
AWS5506S14
S14
COMPONENT PACKAGING
6 Pin Plastic Package
ANADIGICS, Inc.
35 Technology Drive
Warren, New Jersey 07059
Tel: (908) 668-5000
Fax: (908) 668-5132
http://www.anadigics.com
Mktg@anadigics.com
IMPORTANT NOTICE
ANADIGICS, Inc. reserves the right to make changes to its products or to discontinue any product at any time without
notice. The product specifications contained in Advanced Product Information sheets and Preliminary Data Sheets are
subject to change prior to a product’s formal introduction. Information in Data Sheets have been carefully checked and are
assumed to be reliable; however, ANADIGICS assumes no responsibilities for inaccuracies. ANADIGICS strongly urges
customers to verify that the information they are using is current before placing orders.
WARNING
ANADIGICS products are not intended for use in life support appliances, devices, or systems. Use of an ANADIGICS
product in any such application without written consent is prohibited.
8
Data Sheet - Rev 2.1
08/2001