2.4 x 5mm Rectangular ® Optopipe® Optical Light Pipe, 5 Array 22.61 [.890] 2.44 [.096] TYP 4.98 [.196] TYP 8.38 [.33] MicroLED SMT LEDs for use with 515-1029 FRONT PANEL Polished DIFFUSED Front FRONT Surface PANEL 3.48 [.137] 11.73 [.462] PART NO. 5.84 [.230] 2.54 [.100] 5.08 [.200] Break-offPOINTS Points BREAK-OFF For “BlankingOUT Out FOR “BLANKING ” ” POSITIONS Positions 10.16 [.400] 4.09 4.57 [.161] [.180] 20.32 [.800] 15.24 [.600] 10.16 [.400] 6.35 [.251] 1.09 [.043] 5.08 [.200] 1.52 [.060] 1.45 [.057] TYP 7.59 [.299] .41 [.016] TYP ±.08 10.16 10.16 ±.003] [.400 [.400] ±.003 Ø1.93 ±.05 [.076 ±.002] TYP; 2 PLCS 515-1029 DIRECTION OF LIGHT Direction NOTE: designed for post-reflow PC board insertion. of Light Dimensions in mm [inches] Recommended 597-3xx1-2xx 597-77x1-2xx Alternatives 597-3xx1-5xx 597-77x1-5xx PAGE # 1-21 1-23 & 1-24 1-30 1-31 LED alternatives may not produce optimum light output Solder Pad/Holes layout shown is for bi-color LEDs listed under “Recommended” category Contact factory for other layouts RECOMMENDED SOLDER PAD/HOLES LAYOUT Features • • • • • • High transmissivity polycarbonate material UL94V-0 compliance ESD protection (circuit isolation from front panel) Wide viewing angle Arrays reduce insertion costs Secures to PCB by press-fit LED Data Operating/Storage Temperature For absolute maximum ratings and other electrical and optical data on the recommended LEDs, refer to LED data sheets. –30°C to +100°C Dialight Optopipe® Light Pipe Description This Optopipe® mimics a 5-position array of 2 x 5mm LEDs, and functions as a through-the-panel indicator. Each element has a diffused viewing surface and a shallow V-groove that permits easy customer removal of unwanted elements. The array is held in place by 2 press-fit pins located beneath the second and fourth elements. The recommended light sources are Dialight's 597 Series PLCC-2 or PLCC-4 Type SMT LEDs. The SMT LEDs are mounted in a straight line under the rear of the part on a 5.08mm pitch. The light pipe material is water clear transmissive polycarbonate rated UL94-V0, and has a 35% oxygen index. Dialight can provide custom Optopipe® solutions for your applications. Dialight Corporation • 1501 Route 34 South • Farmingdale, NJ 07727 • TEL: (732) 919-3119 • FAX: (732) 751-5778 •www.dialight.com