ECLIPTEK E15C7H2F

E15C7 Series
E15C7
• RoHS Compliant (Pb-Free)
• LVPECL output oscillators
• 2.5V supply voltage
• Ceramic 6-pad SMD package
• Stability to ±25ppm
• Tri-State output
• Complementary output
• Available on tape and reel
• Wide range of available frequencies
H
L
W
2.0
7.0
5.0
OSCILLATOR
ELECTRICAL SPECIFICATIONS
Nominal Frequency (MHz)
Operating Temperature Range
Storage Temperature Range
Supply Voltage (VCC)
Input Current
Frequency Tolerance / Stability
Output Voltage Logic High (VOH)
Output Voltage Logic Low (VOL)
Rise Time / Fall Time
Duty Cycle
Load Drive Capability
Logic Control / Additional Output
Tri-State Input Voltage
Standby Current
Start Up Time
RMS Phase Jitter
Typical Phase Noise
77.760M, 78.125M, 80M, 80.157M, 85M, 87.125M, 90M, 100M, 106.25M, 110M, 119M, 120M, 122.888M,
124.4M, 125M, 127M, 128M, 133M, 133.333M, 137.472M, 150M, 155.52M, 156.25M, 159.375M,
161.1328M, 162.5M , 166M, 170M, 175M, 176.83816M, 187.5M, 187.509375M, 200M, or 212.5MHz
Inclusive of All Conditions: Calibration Tolerance at 25°C,
Frequency Stability over the Operating Temperature Range,
Supply Voltage Change, Output Load Change, 1st Year
Aging at 25°C, Shock, and Vibration
0°C to 85°C
-40°C to 0°C
0°C to 85°C
-40°C to 0°C
20% to 80% of waveform
at 50% of waveform
VIH of 70% of VCC Minimum
No Connection
VIL of 30% of VCC Maximum
Without Load
FJ = 12kHz to 20MHz
Fo=156.250MHz
0°C to 70°C, or -40°C to +85°C
-55°C to 125°C
2.5VDC ±5%
75mA Maximum
±100ppm, ±50ppm, or
±25ppm Maximum
VCC-1.025VDC Minimum
VCC-1.085VDC Minimum
VCC-1.405VDC Maximum
VCC-1.305VDC Maximum
300pSec Typical, 700pSec Maximum
50 ±5(%)
50 Ohms into VCC-2.0VDC
Complementary Output and Tri-State
Enables Output
Enables Output
Disables Output: High Impedance
30µA Maximum
10 mSeconds Maximum
0.4pSec Typical, 1 pSec Maximum
-60dBc/Hz at 10Hz Offset
-95dBc/Hz at 100Hz Offset
-125dBc/Hz at 1kHz Offset
-143dBc/Hz at 10kHz Offset
-145dBc/Hz at 100kHz Offset
-145dBc/Hz at 1MHz Offset
-146dBc/Hz at 10MHz Offset
MANUFACTURER
CATEGORY
SERIES
PACKAGE
VOLTAGE
CLASS
REV.DATE
ECLIPTEK CORP.
OSCILLATOR
E15C7
CERAMIC
2.5V
OS1C
01/07
800-ECLIPTEK www.ecliptek.com for latest revision
Specifications subject to change without notice.
PART NUMBERING GUIDE
E15C7 E 2 F - 155.520M TR
FREQUENCY TOLERANCE & STABILITY/
OPERATING TEMPERATURE RANGE
C=±100ppm Maximum over 0°C to +70°C
D=±50ppm Maximum over 0°C to +70°C
E=±25ppm Maximum over 0°C to +70°C
G=±100ppm Maximum over -40°C to +85°C
H=±50ppm Maximum over -40°C to +85°C
J=±25ppm Maximum over -40°C to +85°C (*)
AVAILABLE OPTIONS
Blank=Tubes
TR=Tape and Reel (Standard)
FREQUENCY
LOGIC CONTROL/ADDITIONAL OUTPUT
F=Complementary Output and Tri-State
DUTY CYCLE
2=50 ±5(%)
(*) Not available over Nominal Frequency range of 176.83816MHz to 212.500MHz
MECHANICAL DIMENSIONS
SUGGESTED SOLDER PAD LAYOUT
ALL DIMENSIONS IN MILLIMETERS
ALL DIMENSIONS IN MILLIMETERS
5.00
±0.20
2.00
MAX
2.60 +0.40/-0.60
MARKINING
ORIENTATION
2.54
±0.10
7.00
+0.70/ 5.08
-0.15 ±0.20
6
1
5
2
4
Pin 1: Tri-State
Pin 2: No Connect
Pin 3: Case Ground
TAPE AND REEL DIMENSIONS
3
1.2
+0.3/
-0.2
1.4
±0.2
Pin 4: Output
Pin 5: Complementary Output
Pin 6: Supply Voltage
Tolerances= +0.1
ALL DIMENSIONS IN MILLIMETERS
TAPE
A
B
C
D
E
16±.3-.1
7.5±.1
6.75±.1
4 ±.1
2±.1
F
G
H
J
K
8±.1
B0*
1.5 +.1-0
A0*
.3 ±.05
F
M
N
O
P
Q
1.5 MIN
50 MIN
20.2 MIN
13±.2
40 MIN
QTY/REEL
1,000
REEL
L
K0*
R
S
T
U
V
2.5 MIN
10 MIN
22.4 MAX
360 MAX
16.4+2-0
*Compliant to EIA 481A
ENVIRONMENTAL/MECHANICAL SPECIFICATIONS
MARKING SPECIFICATIONS
Line 1: ECLIPTEK
Characteristic
Specification
Fine Leak Test
Gross Leak Test
Mechanical Shock
Vibration
Solderability
Temperature Cycling
Resistance to Soldering Heat
Resistance to Solvents
MIL-STD-883, Method 1014, Condition A
MIL-STD-883, Method 1014, Condition C
MIL-STD-202, Method 213, Condition C
MIL-STD-883, Method 2007, Condition A
MIL-STD-883, Method 2002
MIL-STD-883, Method 1010
MIL-STD-202, Method 210
MIL-STD-202, Method 215
Line 2: XX.XXX M
Frequency in MHz (5 Digits Maximum + Decimal)
Line 3: XX Y ZZ
Week of Year
Last Digit of Year
Ecliptek Manufacturing Identifier
MANUFACTURER
CATEGORY
SERIES
PACKAGE
VOLTAGE
CLASS
ECLIPTEK CORP.
OSCILLATOR
E15C7
CERAMIC
2.5V
OS1C
800-ECLIPTEK www.ecliptek.com for latest revision
REV.DATE
01/07
Specifications subject to change without notice.