EVERLIGHT ELECTRONICS CO., LTD. MODEL NO: Device Number: DMO-841-001 REV: IRM-8410/N ECN: Page: 1.1 1/9 ■ PACKAGE DIMENSIONS： OFFICE: NO 25,Lane 76,Chung Yang Rd, Sec.3 Tucheng, Taipei 236, Taiwan, R.O.C. TEL : 886-2-2267-2000,2266-9936 ( 22 Lines ) FAX : 886-2-2267-6189 http://www.everlight.com EVERLIGHT ELECTRONICS CO., LTD. MODEL NO: Device Number: DMO-841-001 REV: IRM-8410/N ECN: Page: 1.1 2/9 ■ NOTES： 1. This drawing measure is a standard value. All dimensions are in millimeter. 2. In case of designation is tolerance ± 0.3mm. 3. Lead spacing is measured where the lead emerge from the package. 4. Above specification may be changed without notice. EVERLIGHT will reserve authority on material change for above specification. 5. These specification sheets include materials protected under copyright of EVERLIGHT corporation. Please don't reproduce or cause anyone to reproduce them without EVERLIGHT consent. 6. When using this produce, please observe the absolute maximum ratings and the instructions for use outlined in these specification sheets. EVERLIGHT assumes no responsibility for any damage resulting from use of the product which does not comply with the absolute maximum ratings and the instructions included in these specification sheets. EVERLIGHT ELECTRONICS CO., LTD. MODEL NO: Device Number: DMO-841-001 REV: IRM-8410/N ECN: Page: 1.1 3/9 ■ Description： 1. The module is a small type infrared remote control system receiver which has been developed and designed by utilizing the latest hybrid technology. 2. This single unit type module incorporates a photo diode and a receiving preamplifier IC. 3. The demodulated output signal can directly be decoded by a microprocessor. ■ Feature： 1. 2. 3. 4. 5. 6. 7. 8. 9. High protection ability to EMI and metal case can be customized. Mold type and metal case type to meet the design of front panel. Elliptic lens to improve the characteristic against Line-up for various center carrier frequencies. Low voltage and low power consumption. High immunity against ambient light. Photodiode with integrated circuit. TTL and CMOS compatibility. Long reception distance. 10. High sensitivity. ■ Application： 1. Optical switch 2. Light detecting portion of remote control • AV instruments such as Audio, TV, VCR, CD, MD, etc. • Home appliances such as Air-conditioner, Fan , etc. • The other equipments with wireless remote control. • CATV set top boxes • Multi-media Equipment EVERLIGHT ELECTRONICS CO., LTD. MODEL NO: Device Number: DMO-841-001 REV: IRM-8410/N ECN: Page: ■ Absolute maximum ratings： Parameter Symbol Ratings Supply Voltage Vcc 4.3~5.7 -10〜+60 Operating Temperature Topr -20〜+70 Storage Temperature Tstg Soldering Temperature Tsol ■ Electro Optical Characteristics： Parameter TYP Symbol MIN Vcc 4.7 5 Supply Voltage Icc Supply Current B.P.F Center Frequency Peak Wavelength Transmission Distance Half Angle High Level Pulse Width Low Level Pulse Width High Level Output Voltage Low Level Output Voltage (Ta=25℃) Notice Unit V ℃ ℃ 4mm from mold body less than 5 seconds ℃ 260 MAX 5.3 3 Unit V mA fo - 37.9 - KHz λp L0 L45 θ 6 3 - 940 45 - nm - deg TH 400 - 800 µs TL 400 - 800 µs VH 4.5 - - V 0.5 V VL 1.1 4/9 m (Ta=25℃) Condition DC voltage No signal input At the ray axis *1 At the ray axis *2 *1:The ray receiving surface at a vertex and relation to the ray axis in the range of φ= 0° and φ=45°. *2:A range from 30cm to the arrival distance. Average value of 50 pulses. EVERLIGHT ELECTRONICS CO., LTD. MODEL NO: Device Number: DMO-841-001 REV: IRM-8410/N ECN: Page: 1.1 5/9 ■ TEST METHOD： The specified electro-optical characteristics is satisfied under the following Conditions at the controllable distance. cMeasurement place A place that is nothing of extreme light reflected in the room. dExternal light Project the light of ordinary white fluorescent lamps which are not high Frequency lamps and must be less then 10 Lux at the module surface. (Ee≦10Lux) eStandard transmitter A transmitter whose output is so adjusted as to Vo=400mVp-p and the output Wave form shown in Fig.-1.According to the measurement method shown in Fig.-2 the standard transmitter is specified. However, the infrared photodiode to be used for the transmitter should be λp=940nm, ∆λ=50nm. Also, photo diode is used of PD438B (VR=5V). (Standard light / Light source temperature 2856°K). fMeasuring system According to the measuring system shown in Fig.-3 EVERLIGHT ELECTRONICS CO., LTD. Device Number: DMO-841-001 REV: IRM-8410/N ECN: Page: MODEL NO: 1.1 6/9 ■ Module schematic & circuit： 130K OHM 47uF + R2 Pre-A M P 4 fo - V cc 3 1 22K OH M 47 OHM PD 438B IN + DEM O DUR ATION LIM ITER 8 Vcc B .P.F. + TRA P AM P W AV E FORM AR RA NGEM ENT 2 OUT O UT AB LC 7 IN C1 5 GND 6 CD C2 10nF GN D Fig.-1 Transmitter Wave Form D.U.T Output Pulse Carrier frequency is adjusted to center frequency of each product. OUTPUT PULSE OF DEVICE IR TANSMITTER OUTPUT WAVE FORM Duty=0.5 Fig.-2 Measuring Method Fig.-3 Measuring System 20cm 10k +5.0± 0.1V L: Transmission Distance Vcc θ θ 10uF OUT Standard Transmitter 100k Vout Standard Transmitter D.U.T Vout GND Oscilloscope θ: Angle Of Horizontal & Vertical Direction EVERLIGHT ELECTRONICS CO., LTD. MODEL NO: Device Number: DMO-841-001 REV: IRM-8410/N ECN: Page: 1.1 7/9 ■ TYPICAL ELECTRICAL/OPTICAL/CHARACTERISTICS CURVES Fig.-4 Relative Spectral Sensitivity vs. Wavelength Fig.-5 Relative Transmission Distance vs. Direction θ Fig.-6 Output Pulse Length vs. Arrival Distance Fig.-7 Arrival Distance vs. Supply Voltage Fig.-8 Relative Transmission Distance vs. Center Carrier Frequency Fig.-9 Arrival Distance vs. Ambient Temperature EVERLIGHT ELECTRONICS CO., LTD. MODEL NO: Device Number: DMO-841-001 REV: IRM-8410/N ECN: Page: 1.1 8/9 ■ Reliability test item and condition： The reliability of products shall be satisfied with items listed below. Confidence level: 90% LTPD: 10% Failure Judgement Criteria Test Items Test Conditions Operation life Vcc=5V,Ta:25℃ 1000hrs 1 cycle -20℃ +25℃ +70℃ (30min) 5min (30min) L ≦ L× 0.8 0 50 cycle test L45≦ L× 0.8 -10℃ to +70℃ (5min) (10sec) (5min) 50 cycle test Temperature cycle Thermal shock High temperature Temp: +70℃ 1000hrs storage Low temperature Temp: -20℃ 1000hrs storage High temperature Ta: 85℃ RH:85% 1000hrs High humidity Temp: 260± 5℃ 5sec Solder heat 4mm Form the bottom of the package. Temp: 230± 5℃ 5sec Solderability 4mm Form the bottom of the package. Samples(n) Defective(c) n=22,c=0 n=22,c=0 n=22,c=0 n=22,c=0 n=22,c=0 L: Lower specification limit n=22,c=0 n=22,c=0 More than 90% of Lead to be covered n=22,c=0 by soldering EVERLIGHT ELECTRONICS CO., LTD. Device Number: DMO-841-001 REV: IRM-8410/N ECN: Page: MODEL NO: 1.1 9/9 ■ Packing Specifications 1.Plastic Case 14.5 2.0 21 2.Box 15 22 9 EVERLIGHT Opto-electronic,Compoments Label 3.Carton E V E R L I G H T 24 33 CPN : Customer’s Production Number P/N : Production Number QTY : Packing Quantity CAT : Ranks HUE : Peak Wavelength Label 48 Label UNIT：cm Packing Quantity Specification 1. 40 Pcs/1Plastic Case，4Plastic Cases/1Box 2. 10 Boxes/1Carton REF : Reference LOT NO : Lot Number MADE IN TAIWAN : Production place