KINGBRIGHT AM27YC08

SUBMINIATURE SOLID STATE LAMP
$0<&
YELLOW
Features
Description
OWIDE VIEWING ANGLE.
The Yellow source color devices are made with Gallium
OSUBMINIATURE PACKAGE.
Arsenide Phosphide on Gallium Phosphide Yellow Light
OYOKE LEAD.
OLONG LIFE-SOLID STATE RELIABILITY.
Emitting Diode.
OLOW PACKAGE PROFILE.
OPACKAGE : 1000PCS / REEL.
ORoHS COMPLIANT.
Package Dimensions
Notes:
1. All dimensions are in millimeters (inches).
2. Tolerance is ±0.25(0.01") unless otherwise noted.
3. Lead spacing is measured where the lead emerge from the package.
4. Specifications are subject to change without notice.
SPEC NO: DSAD1317
REV NO: V.2
DATE: MAR/10/2005
PAGE: 1 OF 4
APPROVED: J. Lu
CHECKED: Allen Liu
DRAWN: S.H.CHEN
ERP:1202000438
Selection Guide
Part No.
Dice
$0<&
Iv (mcd)
@ 20mA
Lens Type
YELLOW (GaAsP/GaP)
WATER CLEAR
Viewing
Angle
Min.
Typ.
2θ1/2
10
30
20°
Note:
1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value.
Electrical / Optical Characteristics at TA=25°C
Symbol
Parameter
Device
λpeak
Peak Wavelength
Yellow
λD
Dominant Wavelength
∆λ1/2
Typ.
Max.
Units
Test Conditions
590
nm
IF=20mA
Yellow
588
nm
IF=20mA
Spectral Line Half-width
Yellow
35
nm
IF=20mA
C
Capacitance
Yellow
20
pF
VF=0V;f=1MHz
VF
Forward Voltage
Yellow
2.1
2.5
V
IF=20mA
IR
Reverse Current
Yellow
10
uA
VR = 5V
Absolute Maximum Ratings at TA=25°C
Parameter
Yellow
Units
Power dissipation
105
mW
DC Forward Current
30
mA
Peak Forward Current [1]
140
mA
5
V
Reverse Voltage
-40°C To +85°C
Operating/Storage Temperature
Note:
1. 1/10 Duty Cycle, 0.1ms Pulse Width.
SPEC NO: DSAD1317
REV NO: V.2
DATE: MAR/10/2005
PAGE: 2 OF 4
APPROVED: J. Lu
CHECKED: Allen Liu
DRAWN: S.H.CHEN
ERP:1202000438
Yellow
AM27YC08
SPEC NO: DSAD1317
REV NO: V.2
DATE: MAR/10/2005
PAGE: 3 OF 4
APPROVED: J. Lu
CHECKED: Allen Liu
DRAWN: S.H.CHEN
ERP:1202000438
AM27YC08
Recommended Soldering Pattern
(Units : mm)
Tape Specifications
(Units : mm)
Remarks:
If there is sorting requirement (eg. forward voltage, luminous intensity or wavelength), the condition as follows:
1.Wavelength: +/-1nm (Test condition is based on the sorting standard).
2.Luminous intensity: +/-15% (Test condition is based on the sorting standard).
3.Forward voltage: +/-0.1V (Test condition is based on the sorting standard).
SPEC NO: DSAD1317
REV NO: V.2
DATE: MAR/10/2005
PAGE: 4 OF 4
APPROVED: J. Lu
CHECKED: Allen Liu
DRAWN: S.H.CHEN
ERP:1202000438