ML4335 Quad Latch (Open Collector) Legacy Device: Motorola MC4335 This monolithic device consists of four latch circuits with open collector outputs common Strobe input, and output enable input. The output of each latch will follow the data input when the Strobe input is in a logical “1” state. When the Strobe is in a logical “0” state, the latch will store the logic state of the data input just prior to the change of the Strobe from a “1” level to a “0” level. The open collector outputs make this device useful for bussing or wire ORing outputs together. Two 5.0 k ohm resistor are available in the package to provide the passive pullup function in wired–OR or bussed operation. The output enable is useful where it is desirable to gate information out of the latches according to a predetermined timing scheme. Input Loading Factor (MTTL 1 Loads): Data Input (Strobe High) – 4335 = 4.2 Data Input (Strobe Low) – Output Enable – 4335 = 1.1 4335 = 4.0 Output Loading Factor ( TTL 1 Loads): 4335 = 7 (1OL = 9.3 mAdc) Total Power Dissipation = 140 mW typ/pkg Propegation Delay Time - 25 ns typ Page 1 of 4 www.lansdale.com Issue 0 LANSDALE Semiconductor, Inc. ML4335 Page 2 of 4 www.lansdale.com Issue 0 LANSDALE Semiconductor, Inc. ML4335 VOLTAGE WAVEFORMS Strobe Input Data Inputs Enable Inputs Page 3 of 4 www.lansdale.com Issue 0 LANSDALE Semiconductor, Inc. ML4335 Lansdale Semiconductor reserves the right to make changes without further notice to any products herein to improve reliability, function or design. Lansdale does not assume any liability arising out of the application or use of any product or circuit described herein; neither does it convey any license under its patent rights nor the rights of others. “Typical” parameters which may be provided in Lansdale data sheets and/or specifications can vary in different applications, and actual performance may vary over time. All operating parameters, including “Typicals” must be validated for each customer application by the customer’s technical experts. Lansdale Semiconductor is a registered trademark of Lansdale Semiconductor, Inc. Page 4 of 4 www.lansdale.com Issue 0