WRN78XX-1000 Series NONISOLATED REGULATED SINGLE OUTPUT SIP WIDE INPUT, INPUT,NONNON-ISOLATED SIP33 DC/DC CONVERTER SELECTION GUIDE Input order code WRN7803-1000 FEATURES WRN7805-1000 ◆RoHS compliant ◆Efficiency up to 96% WRN786.5-1000 ◆SIP Package WRN7809-1000 ◆Wide temperature range:-40°C to 85°C ◆Short circuit protection,Thermal Shutdown ◆No heatsink required ◆ Low ripple and noise WRN7812-1000 Voltage Range Voltage Current (VDC) (VDC) (MA) 4.75-28 3.3 4.75-25 -3.3 6.5-32 Vin(min) Vin(max) 1000 90 83 -600 80 82 5.0 1000 93 88 7.0-27 -5.0 -600 85 87 9-32 6.5 1000 94 90 7.0-25 -6.5 -400 88 90 12-32 9.0 1000 95 92 7.0-23 -9.0 -400 89 91 16-32 12 1000 96 94 89 91 7.0-20 -12 -300 *Input voltage can't exceed this value,or will cause the permanent damage. Parameter Test conditions ◆MTBF>2,000,000 hours Output Voltage accuracy 100% full load ◆Only two extra capacitors are required Line regulation Load regulation Ripple＆Noise* ◆ Input voltage range can be lower than the output voltage for higher output voltages MODEL SELECTION ③ WRN78 05 -1000 Typ. Max. Units ±2 ±3 % Vin= min. to max. at full load ±0.2 ±0.4 % 10% to 100% load ±0.4 ±0.6 % 20MHZ Bandwidth 25 35 % 0.5 1.8 W Short Circuit Input Power Continuous, automatic recovery Switching frequency 100% full load 330 450 Quiescent current Positive Output 5 8 Quiescent current Negative Output 7 13 Thermal Shutdown 280 Internal IC junction ②Output Voltage Khz mA ℃ 150 Output Current Limit Temperature coefficient ①Product Series ③Output Current Min. Short circuit protection in negative application ② Efficiency(%,Typ) OUTPUT SPECIFICATIONS ◆ Industry standard pinout ① Output -40 °C to +85 °C ambient Max capacitance load 2000 mA 0.02 %/℃ 1000 µF * Test ripple and noise by "parallel cable" method. COMMON SPECIFICATIONS DESCRIPTION Parameter The WRN78xx-1000 Series high efficiency switching Regulators are ideally suited to replace WRN78xx linear regulators and are pin compatible. The efficiency of up to 96% means that very little energy is wasted as heat so there is no need fo any heat sinks with their additional space and mounting costs. Test conditions Min. Operating Temp. Range Typ. -40 Operating Case Temp. Storage Temp. Range -55 Cooling Max. Units 85 ℃ 100 ℃ 125 ℃ Free Air Convection Case Material Lead Temperature Plastic (UL94-V0) 1.5mm from case for 10 seconds Storage Humidity Range MTBF +25°C MIL-HDBK-217F 300 ℃ 95 % 2000 Package Weight K hours 3.7 g Note: 1. All specifications measured at TA=25°C, humidity<75%, nominal input voltage and rated output load unless otherwise specified. MICRODC reserves the copyright 2. Only typical models listed. If you need other model, please confirm the power, input voltage and output voltage, then phone us. http://www.microdc.cn Technical Enquiries-Email:[email protected] Tel:0086-20-86000646 Page 1 of 2 WRN78XX-1000 Series TYPICAL CHARACTERISTICS EXTERNAL CAPACITOR TABLE Part Number C1,C3 (ceramic capacitor) C2,C4 (ceramic capacitor) WRN7803-1000 10uF/50V 22uF/6.3V WRN7805-1000 10uF/50V 22uF/10V WRN786.5-1000 10uF/50V 10uF/10V WRN7809-1000 10uF/50V 10uF/16V WRN7812-1000 10uF/50V 10uF/25V WRN7815-1000 10uF/50V 10uF/25V Temperature Derating Graph STANDARD APPLICATION CIRCUIT APPLICATION EXAMPLE MECHANICAL DIMENSIONS RECOMMENDED FOOTPRINT RECOMMENDED FOOTPRINT Top view,grid:2.54mm(0.1inch) diameter:1.00mm(0.039inch) TUBE OUTLINE DIMENSIONS Note: Unit:mm[inch] Pin section:0.50*0.30mm(0.020*0.012inch) Pin section tolerances:±0.10mm[±0.004inch] General tolerances:±0.25mm[±0.010inch] http://www.microdc.cn Note: Unit :mm[inch] General tolerances: ±0.50mm[±0.020inch] L=530mm[20.866inch] Tube Quantity: 22pcs L=220mm[8.661inch] Tube Quantity: 8pcs Technical Enquiries-Email:[email protected] Tel:0086-20-86000646 Page 2 of 2