RLCO-808-500G TECHNICAL DATA High Power Infrared Laser Diode Features • • • • Lasing Mode Structure: multi mode Peak Wavelength : typ. 808 nm Optical Output Power: 500 mW Package: 9 mm Electrical Connection Pin Configuration Bottom View n-type PIN 1 2 3 Function LD Cathode LD Anode, PD Cathode PD Anode Absolute Maximum Ratings (TC=20°C) Item CW Output Power Operating Case Temperature Storage Temperature Symbol PO TC Tstg Value 500 -10 … +50 -40 … +85 Unit W °C °C Specifications (TC=20°C) Item Optical Specifications CW Output Power Center Wavelength Spectral Width (FWHM) Wavelength Temperature Coefficient FWHM Beam Divergence Polarization Electrical Specifications Threshold Current Operating Current Slope Efficiency Operating Voltage Series Resitance Symbol Min. Typ. Max. Unit PO λC Δλ ∂λ / ∂T θ║ θ┴ 803 - 500 808 2 0.3 6 32 TE 813 5 12 40 W nm nm nm/°C deg deg Ith Iop η Vop Rd 1 - 0.15 1.1 1.8 - 0.26 1.2 2.2 0.3 A A W/A V Ω The above specifications are for reference purpose only and subjected to change without prior notice. 10.04.2013 RLCO-808-500G 1 of 3 Package Dimensons 9 mm Package (Unit:mm) 10.04.2013 RLCO-808-500G 2 of 3 Safety of Laser light • • Laser Light can damage the human eyes and skin. Do not expose the eye or skin directly to any laser light and/or through optical lens. When handling the LDs, wear appropriate safety glasses to prevent laser light, even any reflections from entering to the eye. Focused laser beam through optical instruments will increase the chance of eye hazard. This LD is emitting invisible light. Cautions 1. Operating methode • This LD shall change its forward voltage requirement and optical ouput power according to temperature change. Also, the LD will require more operation current to maintain same ouput power as it degrades. In order to maintain output power, use of APC (Automatic Power Control) is recommended. Which use monitor feedback to adjust the operation current. • Confirm that electrical spike current generated by switching on and off does not exceed the maximum operating current level specified herein above as absolute maximum rating. Also, employ appropriat countermeasures to reduce chattering and/or overshooting in the circuit. 2. Static Electricity • Static electricity or electrical surges will reduce and degrade the reliability of the LDs. It is recommended to use a wrist trap or anti-electrostatic glove when handeling the product. 3. Absolute Maximum Rating • Active layer of LDs shall have high current density and generate high electric field during its operation. In order to prevent excessive damage, the LD must be operated striclty below absolute maximum rating. 10.04.2013 RLCO-808-500G 3 of 3