RUILON 3.0SMC12CA

ELECTRONICS
Transient
Voltage
Suppressors
3.0SMC Series
Circuit Protection
System
Specifications are subject to change without notice.
Please refer to http://www.ruilon.com for current information.
Transient Voltage Suppressors - 3.0SMC Series
Features
UNI
1. Halogen-free
2. Rohs compliant
3. Typical maximum temperature coefficient
4. ΔVBR = 0.1% x [email protected]°C x ΔT
5. Glass passivated Chip junction in DO-214AB package
BI
6. 3000W peak pulse capadility at 10×1000μs waveform, repetition rate (duty
cycles):0.01%
7. Fast response time:typically less than 1.0ps from 0 Volts to BV min
8. Excellent clamping capability
9. Low incremental surge resistance
10. Typical IR less than 5μA above 12V
BI
Cathode
11. High temperature soldering guaranteed:260°C/40seconds/0.375”,(9.5
Anode
mm) lead length, 5lbs., (2.3kg) tension
12. Plastic package has underwriters laboratory flammability classification
UNI
94v-0
Applications
TVS devices are ideal for the protection of I/O interfaces,VCC bus and other vulnerable circuits used in telecom, computer,
industrial and consumer electronic applications.
Mechanical Characteristics
Rating
Symbol
Value
Units
PPPM
3000
Watts
PD
6.5
Watts
IFSM
300
Amps
VF
3.5
V
Operating junction and Storage Temperature Range.
TJ,TSTG
-55°C to 175°C
°C
Typical Thermal Resistance Junction to Lead
RuJL
15
°C/W
Typical Thermal Resistance Junction
to Ambient
RuJA
75
°C/W
Peak Pulse Power Dissipation by 10x1000μs test
waveform (Fig.1)(Note 1)
Steady State Power Dissipation on
inifinite heat sink at TL=75°C (Fig. 5)
Peak Forward Surge Current, 8.3ms Single Half
Sine Wave Unidirectional only (Note 2)
Maximum Instantaneous Forward Voltage at 25A for
Unidirectional only (Note 3)
Notes:
1. Non-repetitive current pulse , per Fig. 3 and derated above TA = 25°C per Fig. 2.
2. Mounted on copper pad area of 0.31x0.31” (8.0 x 8.0mm) to each terminal.
3. Measured on 8.3ms single half sine wave or equivalent square wave for unidirectional device only, duty cycle=4 per minute
maximum.
Circuit Protection
System
Specifications are subject to change without notice.
Please refer to http://www.ruilon.com for current information.
Page:1
Transient Voltage Suppressors - 3.0SMC Series
Electriacl Characteristics
Reverse StandOff Voltage
Type Number
(UNI)
(BI)
3.0SMC6.8A
3.0SMC6.8CA
VRWM(V)
5.80
3.0SMC7.5A
3.0SMC7.5CA
6.40
Breakdown [email protected]
VBR MIN.(V) VBR MAX.(V)
Test
Current
6.40
7.25
IT(mA)
10
7.22
8.30
10
Maximum
Clamping
[email protected]
VC(V)
Peak Pulse
Current
9.2
IPP(A)
326.1
11.2
267.3
Reverse
Leakage
@VRWM
IR(µA)
800
800
3.0SMC8.2A
3.0SMC8.2CA
7.02
7.78
8.95
10
12.0
250.0
200
3.0SMC9.1A
3.0SMC9.1CA
7.78
8.33
9.58
1
12.9
232.6
100
3.0SMC10A
3.0SMC10CA
8.55
9.44
10.82
1
13.6
220.6
50
3.0SMC11A
3.0SMC11CA
9.40
10.00
11.50
1
18.2
164.8
5
3.0SMC12A
3.0SMC12CA
10.20
11.10
12.80
1
19.9
150.8
5
3.0SMC13A
3.0SMC13CA
11.10
12.20
14.00
1
21.5
139.5
5
3.0SMC15A
3.0SMC15CA
12.80
14.40
16.50
1
24.4
123.0
5
3.0SMC16A
3.0SMC16CA
13.60
15.60
17.90
1
26.0
115.4
5
3.0SMC18A
3.0SMC18CA
15.30
16.70
19.20
1
29.2
102.7
5
3.0SMC20A
3.0SMC20CA
17.10
18.90
21.70
1
32.4
92.6
5
3.0SMC22A
3.0SMC22CA
18.80
20.00
23.30
1
35.5
84.5
5
3.0SMC24A
3.0SMC24CA
20.50
22.20
25.50
1
38.9
77.1
5
3.0SMC27A
3.0SMC27CA
23.10
24.40
28.00
1
42.1
71.3
5
3.0SMC30A
3.0SMC30CA
25.60
28.90
33.20
1
48.4
62.0
5
3.0SMC33A
3.0SMC33CA
28.20
31.10
35.80
1
53.3
56.3
5
3.0SMC36A
3.0SMC36CA
20.80
33.30
38.30
1
58.1
51.6
5
3.0SMC39A
3.0SMC39CA
33.30
36.70
42.20
1
64.5
46.5
5
3.0SMC43A
3.0SMC43CA
36.80
40.00
46.00
1
69.4
43.2
5
3.0SMC47A
3.0SMC47CA
40.20
44.40
51.10
1
72.7
41.3
5
3.0SMC51A
3.0SMC51CA
43.60
47.80
54.90
1
82.4
36.4
5
3.0SMC56A
3.0SMC56CA
47.80
50.00
57.50
1
87.1
34.4
5
3.0SMC62A
3.0SMC62CA
53.00
56.70
65.20
1
96.8
31.0
5
3.0SMC68A
3.0SMC68CA
58.10
64.40
74.10
1
103.0
29.1
5
3.0SMC75A
3.0SMC75CA
64.10
71.10
81.80
1
121.0
24.8
5
3.0SMC82A
3.0SMC82CA
70.10
77.80
89.50
1
137.0
20.8
5
3.0SMC91A
3.0SMC91CA
77.80
86.70
99.70
1
146.0
20.6
5
3.0SMC100A
3.0SMC100CA
85.50
94.40
108.20
1
162.0
18.6
5
3.0SMC110A
3.0SMC110CA
94.00
100.00
115.50
1
177.0
16.8
5
3.0SMC120A
3.0SMC120CA
102.00
111.00
128.00
1
193.0
15.6
5
3.0SMC130A
3.0SMC130CA
111.00
122.00
140.50
1
209.0
14.4
5
3.0SMC150A
3.0SMC150CA
128.00
144.00
165.50
1
243.0
12.4
5
3.0SMC180A
3.0SMC180CA
154.00
167.00
192.60
1
292.0
10.3
5
3.0SMC200A
3.0SMC200CA
171.00
189.00
217.50
1
324.0
9.3
5
3.0SMC220A
3.0SMC220CA
185.00
209.00
243.20
1
356.0
8.4
5
Circuit Protection
System
Specifications are subject to change without notice.
Please refer to http://www.ruilon.com for current information.
Page:2
Transient Voltage Suppressors - 3.0SMC Series
Ratings and Characteristic Curves
Figure 1 - Peak Pulse Power Rating Curve
Figure 2 - Pulse Derating Curve
A
Figure 3 - Pulse Waveform
Figure 4 - Typical Junction Capacitance
Figure 5 - Steady State Power Derating Curve
Figure 6 - Maximum Non-Repetitive Peak Forward
Surge Current Uni-Directional Only
Circuit Protection
System
Specifications are subject to change without notice.
Please refer to http://www.ruilon.com for current information.
Page:3
Transient Voltage Suppressors - 3.0SMC Series
Soldering Parameters
Feflow Condition
Pre Heat
Lead-free assembly
- Temperature Min (T s(min))
150°C
- Temperature Max (T s(min))
200°C
- Time (min to max) (t s)
60-180 secs
Average ramp up rate (Liquidus Temp (TL) to peak
3°C/second max
TS(max) to TL - Ramp-up Rate
3°C/second max
- Temperature (T L) (Liquidus)
Reflow
217°C
- Time (min to max) (t s)
60-150 seconds
260+0/-5 °C
Peak Temperature (T P)
Time within 5°C of actual peak Temperature (t p)
20-40 seconds
Ramp-down Rate
6°C/second max
Time 25°C to peak Temperature (T P)
8 minutes Max.
Do not exceed
280°C
Physical Specifications
tp
TP
one
Ramp-up
Temperature (T)
TL
tL
Critical Z P
TL to T
Weight
0.007 ounce, 0.21 grams
JEDEC DO214AB. Molded plastic body
over glass passivated junction
Color band denotes cathode except
Bidirectional.
Matte Tin-plated leads, Solderable per
JESD22-B102D
Case
Ts(max)
Ts(min)
Ramp-down
ts
Polarity
Termina
Preheat
Time (t)
Circuit Protection
System
Environmental Specifications
Temperature Cycle
JESD22-A104
Pressure Cooker
JESD 22-A102
High Temp. Storage
JESD22-A103
HTRB
JESD22-A108
Thermal Shock
JESD22-A106
Specifications are subject to change without notice.
Please refer to http://www.ruilon.com for current information.
Page:4
Transient Voltage Suppressors - 3.0SMC Series
Dimensions
Unit:mm
DO-214AB (SMC -Bend)
DIM
Inches
Millimeters
Min
Max
Min
Max
A
0.114
0.126
2.900
3.200
B
0.260
0.280
6.600
7.110
C
0.220
0.245
5.590
6.220
D
0.079
0.103
2.060
2.620
E
0.030
0.060
0.760
1.520
F
-
0.008
-
0.203
G
0.305
0.320
7.750
8.130
H
0.006
0.012
0.152
0.305
I
0.129
-
3.300
-
J
0.094
-
2.400
-
K
-
0.165
-
4.200
L
0.094
-
2.400
-
Warehouse Storage Conditions of Products
· Storage Conditions:
1. Storage Temperature: -10°C~+40°C
2. Relative Humidity:≤75%RH
3. Keep away from corrosive atmosphere and sunlight.
· Period of Storage: 1 year
Circuit Protection
System
Specifications are subject to change without notice.
Please refer to http://www.ruilon.com for current information.
Page:5
RuiLongYuan Electronics Co., Ltd.
· Reproducing and modifying information of the document is prohibited without permission from
Ruilongyuan International Inc.
· Ruilongyuan International Inc. reserves the rights to make changes of the content herein the document anytime
without notification. Please refer to our website for the latest document.
· Ruilongyuan International Inc. disclaims any and all liability arising out of the application or use of any product
including damages incidentally and consequentially occurred.
· Ruilongyuan International Inc. does not assume any and all implied warranties, including warranties of fitness
for particular purpose, non-infringement and merchantability.
· Applications shown on the herein document are examples of standard use and operation. Customers are responsible
in comprehending the suitable use in particular applications.Ruilongyuan International Inc. makes no representation or
warranty that such applications will be suitable for the specifed use without further testing or modifcation.
· The products shown herein are not designed and authorized for equipments requiring high level of reliability or relating to
human life and for any applications concerning life-saving or life-sustaining, such as medical instruments, transportation
equipment,aerospace machinery et cetera. Customers using or selling these products for use in such applications do so at
their own risk and agree to fullyindemnify Ruilongyuan International Inc. for any damages resulting from such improper use or
sale.
Tel: +86-755-8290 8296
Circuit Protection
System
Fax: +86-755-8290 8002
E-mail: [email protected]
Specifications are subject to change without notice.
Please refer to http://www.ruilon.com for current information.
Page:6