ACDC 600800 Watts SMR Series xppower.com • Up to 900 W Peak Output Power • Single Outputs from 12 V to 48 V • Compact Size • Remote On/Off • SEMI F47 Compliant • Optional Current Share • 3 Year Warranty Specification Input General • 90-264 VAC (120-370 VDC) • 47-63 Hz • SMR600: 9 A at 90 VAC, 3.5 A at 230 VAC SMR800: 11 A at 90 VAC, 5 A at 230 VAC Inrush Current • 70 A at 230 VAC Power Factor • >0.9 Earth Leakage Current • <2.4 mA max at 264 VAC Input Protection • Fitted with a T12 A/250 V fuse Input Voltage Input Frequency Input Current Switching Frequency Power Density Signals Current Monitor Output See table ±5% ±1% 1% (see note 9) 1.5 s at 230 VAC 40 ms typical 16 ms min at 120 VAC ±0.5%, low line to high line ±1%, 1-100% load (see note 8) 5% max 5% max deviation, 500 µs recovery to within 1% for a 50% load change Ripple & Noise • 1% of nominal output voltage (see note 2) Overvoltage Protection • 110-130% recycle input to reset Overtemperature • Measured internally with auto recovery Protection Overload Protection • 110-140% with auto recovery Short Circuit Protection • Trip and restart (Hiccup mode) Remote Sense • Compensates for up to 0.5 V line drop (not available with current share) Remote On/Off • On = TTL Logic HIGH, or open circuit Off = TTL Logic LOW or short circuit Current Share • Optional single wire current share within 10% for up to 4 units (add suffix ‘-I’ to model number) Note that this option includes output blocking diodes. Remote sense is not available with current share. Output Voltage Output Voltage Trim Initial Set Accuracy Minimum Load Start Up Delay Start Up Rise Time Hold Up Time Line Regulation Load Regulation Over/Undershoot Transient Response Efficiency Isolation • • • • • • • • • • • MTBF • See model table • 3000 VAC Input to Output 1500 VAC Input to Ground 250 VDC Output to Ground • 60 kHz PFC, 25 kHz PWM typical • SMR600: 6.16 W/In3, SMR800: 8.2 W/In3 • Green LED for Power On, Power Good TTL HIGH within 100-500 ms and LOW ≤1 ms before loss of regulation • 0.5 V to 3 V output denoting 0-100% output current • 150 kHrs min to MIL-HDBK-217F at 25 °C, GB Environmental Operating Temperature • 0 °C to +70 °C, derates from 100% load at +50 °C to 50% load at +70 °C Cooling • Integral fan Operating Humidity • 5-90%, non-condensing Storage Temperature • -20 °C to +85 °C Operating Altitude • 3000 m Vibration • 5-50 Hz, acceleration 7.35 ms2 on X, Y and Z axis EMC & Safety Emissions Harmonic Currents Voltage Flicker ESD Immunity Radiated Immunity EFT/Burst Surge Conducted Immunity Dips & Interruptions Safety Approvals • FCC Part 15 & EN55022, level B conducted and radiated • EN61000-3-2 class A EN61000-3-2 class C for loads ≥20% • EN61000-3-3 • EN61000-4-2, level 3 Perf Criteria A • EN61000-4-3, 3 V/m Perf Criteria A • EN61000-4-4, level 2 Perf Criteria A • EN61000-4-5, installation class 3 Perf Criteria A • EN61000-4-6, 3V Perf Criteria A • EN61000-4-11, 30% 10 ms, 60% 100 ms, 100% 5000 ms Perf Criteria A, B, B • UL60950, CSA C22.2 No. 950, EN60950-1:2001, CE Mark LVD, SEMI F47 compliant (high line only) at 100% rated power output Output Power 600 600 600 750 800 800 Output Current Output Voltage(7) W W W W W W 12 24 48 12 24 48 Maximum V V V V V V 50.00 25.00 12.50 62.50 33.33 16.67 Ripple & Noise(2) Peak (1) A A A A A A 75.00 37.50 18.75 75.00 37.50 18.75 A A A A A A 120 240 480 120 240 480 mV mV mV mV mV mV Efficiency 115 VAC 230 VAC 79% 80% 81% 79% 80% 81% 83% 85% 86% 83% 85% 86% Model Number SMR600PS12 SMR600PS24 SMR600PS48 SMR800PS12 SMR800PS24 SMR800PS48 Notes 5. For U-channel versions replace SMR with SMS. 6. For output currents >50 A please use remote sense to meet load regulation ratings. 7. Other output voltages available in OEM quantities, please contact sales. 8. Minimum load required to meet ripple and noise specification. 1. Peak current can be taken for 500 µs, average power should not exceed the maximum power. 2. Ripple & Noise is measured using 0.1 µF ceramic and 22 µF electrolytic capacitor, 20 MHz bandwidth. 3. Load regulation increases to 2% for 0-100% load change. 4. For Top Fan versions replace SMR with SMT. Mechanical Details Covered Version A Mounting Hole 8 Places B Mounting Hole 8 Places 1.59 (40.4) 5.00 (127.0) 0.22 (5.6) CN3 Pin 7 1.59 (40.3) 6.00 (152.4) 0.22 (5.6) 0.25 (6.4) M4 (Zn (yellow) -plated) 2.50 (63.5) 0.25 (6.4) 0.07 (1.9) 0.02 (0.6) 2.09 (53.0) A 0.02 (0.6) B B 0.07 (1.9) A 2.00 (50.8) 2.50 (63.5) UNC6-32 (Zn-plated) 2.50 (63.5) Pin 1 A A B 1.75 (44.45) 2.50 (63.6) B 4.25 (108.0) Voltage Trim B 1.25 (31.9) VO+ A A 0.88 (22.25) L N 1.62 0.32 (8.25) (41.25) VO- B 0.59 (15.0) OPTION ‘-D’ IEC320 or equivalent Option ‘-E’ Molex Part No. 09-91-2000 (20 pins) Terminal Blocks M3.5 Screw 8 Pins 9.5 mm center 9.17 (233.0) A B B STANDARD Terminal Block M3 Screw 3 Pins 8.25 mm center 2.50 (63.5) A 2.00 (50.8) 9.17 (233.0) Option CN3 (Signals) Pin Function 1 Current monitor 2* Current share 3 Return 4 Power good 5 Remote On/Off 6* -Remote sense 7* +Remote sense Options *If optional current share is fitted then remote sense function is excluded. SMR SMT SMS Current Share + output blocking diodes(1) -I -I -I Molex Output Connector(1) -E -E -E Molex Input Connector(1) -F -F Molex Input Molex Output(1) IEC320 Inlet -G -G -D IEC Inlet Molex Outlet(1) -F (1) Available for OEM quantities, contact Sales. For multiple option codes, place codes in alphabetical order, e.g SMR800PS12-EI Notes 1. All dimensions are in inches (mm). 2. Weight: 3.30 lbs (1.5 kg) approx. 3. Tolerance: ±0.012 (±0.3) 4. Logic connector CN3 mates with: JST XHP-7 or equivalent & JST SXH-002T-P0.6 crimp terminals. 5. Maximum mounting screw penetration: 0.12 (3.0) on base & 0.25 (6.3) on each side. 6. Maximum screw terminal torque: Output: 15.7 lbs-in (1.8 Nm) Input: 7 lbs-in (0.8 Nm) ACDC SMR600800 Models and Ratings Top Fan Version SMT 2.00 (50.8) 2.50 (63.5) B A 3.40 (86.4) A B CN3 1.50 (38.1) 5.00 (127.0) 3.40 (86.4) 1.00 (25.4) Pin 1 6.00 (152.4) 2.50 (63.5) 0.92 (23.3) A A B B 0.37 (9.5) pin 1 2.50 1.75 POT (63.5) (44.5) CN1 B B A A 1.29 (32.8) 0.33 (8.3) 8.00 (203.2) Option ‘-F’ Molex Part No. 09-91-0700 (7 pins, 5 used) Pin No.3,6 NC V adjust 4.33 (110.0) 0.42 (10.6) 2.50 (63.5) Pin 7 1.00 (25.4) Option ‘-E’ Molex Part No. 09-91-2000 (20 pins) Terminal Block M3.5 Screw 3Pins 9.5mm Center Terminal Block M3.5 Screw 3Pins 9.5mm Center A B B 3.40 (86.4) A 2.50 (63.5) 2.00 (50.8) U Channel Version SMS Pin 1 2* 3 4 5 6* 7* 2.00 (50.8) 2.50 (63.5) A A B B CN3 Pin 7 1.50 (38.1) 5.00 (127.0) 1.00 (25.4) 6.00 (152.4) 1.00 (25.4) CN3 (Signals) Function Current monitor Current share Return Power good Remote On/Off -Remote sense +Remote sense *If optional current share if fitted then remote sense function is excluded. Pin 1 2.50 (63.5) A 0.37 (9.5) 1.29 (32.8) B pin 1 1.75 (44.5) CN1 2.50 (63.5) 0.92 (23.3) A 2.50 (63.5) POT B B 0.42 (10.6) ACDC SMR Series Mechanical Details B A 1.29 (32.8) Option ‘-F’ Molex Part No. 09-91-0700 (7 pins, 5 used) Pin No.3,6 NC 0.92 (23.3) 8.00 (203.2) V adjust A 0.33 (8.3) Option ‘-E’ Molex Part No. 09-91-2000 (20 pins) Terminal Block M3.5 Screw 3 Pins 9.5 mm Center Terminal Block M3.5 Screw 3 Pins 9.5 mm Center A 4.33 (110.0) B B 2.56 (65.0) height with optional ‘-C’ cover A 2.50 (63.5) 2.00 (50.8) Notes All dimensions are in inches (mm). Weight: 3.30 lbs (1.5 kg) approx. Maximum mounting screw penetration: 0.12 (3.0) on base & 0.25 (6.3) on each side. Logic connector CN3 mates with: JST XHP-7 or equivalent & JST SXH002T-P0.6 crimp terminals. SMR Series Application Notes Remote Sense Output + CD CN3 Pin 7 Sense + + Twisted Pair Supply LOAD CL CN3 Pin 6 Sense CD Output - Note: 1. CL is 47 µF electrolytic capacitor. 2. CD is 0.1 µF ceramic capacitor. Remote On/Off PSU CN3 Pin 5, control connector ON/OFF CN3 Pin 3, control connector Return Note: 1. Applying <0.3 V or short between pins 5 and 3 turns the output OFF. 2. Applying >4.5 V or open circuit between pins 5 and 3 turns output ON. Power Good +5 V 1K POWER GOOD CN3 Pin 4, control connector DC OK CN3 Pin 3, control connector Return POWER NOT GOOD Parallel Connection with Current Share Option Supply 1 Output Return CN3 Pin 2 Current Share V1 LOAD Com Supply 2 Output Return CN3 Pin 2 Current Share 25-Mar-13