Preliminary TB31296FT TOSHIBA SiGe-BiCMOS LINEAR INTEGRATED CIRCUIT SILICON MONOLITHIC TB31296FT Bluetooth RF IC FEATURES BlueRF RXMODE1 Power Consumption：TX mode 27.0mA (Typ.) RX mode 42.0mA (Typ.) Operating Voltage Range： 2.7V ~ 3.5 V Small Package：FBGA 48in Build-in LNA Build-in VCO Build-in PA ：0dBm output ( typ. controllable) External PA control voltage supply for Class1 Very slight current consumption in Deep Sleep mode BLOCK DIAGRAM PA_CONT GNDTX1 TXout VccTX ANTSW ANTSWX GNDTX2 NC RXin GNDRXPA1 VccRX GNDRXPA2 MIX_C MIXout NC Iref1 VccIF1 IFref2 FLLRC GNDIF1 FLLGC AFout GNDIF2 Cin PASW LFIL2 RSSI VccIF2 LNA DA LFIL1 PLL MIX VccVCO C Doubler GNDVCO FLLLPF VCO ResetX TXLPF LD RSSI NC BSX VccPLL XOin GNDPLL2 XOout BPF Vdd LPF Serial data cont. SSTB SCLK DET ADC SDATA RFbus1 GNDPLL1 Cout RFbus2 BB13M (Top View) The information contained herein is subject to change without notice. -The information contained herein is presented only as a guide for the applications of our products. No responsibility is assumed by TOSHIBA for any infringements of patents or other rights of the third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of TOSHIBA or others. -TOSHIBA is continually working to improve the quality and the reliability of its products. Nevertheless, semiconductor devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to observe standards of safety, and to avoid situations in which a malfunction or failure of a TOSHIBA product could cause loss of human life, bodily injury or damage to property. In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as set forth in the most recent products specifications. Also, please keep in mind the precautions and conditions set forth in the TOSHIBA Semiconductor Reliability Handbook. -The products described in this document may include products subject to the foreign exchange and foreign trade laws. - 1 - June 26, 2003 - TENTATIVE 1 TB31296FT Pinning 1 2 XOout Vdd 3 4 5 6 7 8 BB13M RSS1 VccIF2 H SCLK GNDPLL1 Cout G XOin GNDPLL2 SSTB SDATA RFbus1 RFbus2 PASW LFIL2 F BSX VccPLL GNDIF2 Cin LD NC FLLGC AFout E D GNDVCO ResetX FLLRC GNDIF1 C VccIF1 LFIL1 VccVCO IFref2 B ANTSW ANTSWX GNDTX2 NC VccRX GNDRXPA2 NC IFref1 A PA_CONT GNDTX1 TXout VccTX - 2 - RXin GNDRXPA1 MIX_C MIXou June 26, 2003 TENTATIVE 2 TB31296FT Package Dimensions (FBGA48[5.0mm x 5.0mm x 1.2mm]) - 3 - June 26, 2003 TENTATIVE 3 TB31296FT Pin description PIN NO. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 PIN NAME Moni1 VccIF1 IFref FLLRC FLLGC Moni2 NC1 LFIL2 VccIF2 VrefC RSSI BB13M RFbus2 RFbus1 NC2 DATA CLK STB Vdd XOout XOin BSX LD VccPLL ResetX LFIL1 VccVCO ANTSW ANTSWX PACONT TXout VccTX VccRX RXin MIXC Moni3 GND1 GND2 PASW GND3 GND4 GND5 GND6 GND7 FUNCTION Internal signal monitor terminal Power supply terminal IF decoupling terminal for DC bias FLL decoupling terminal for DC bias FLL decoupling terminal for DC bias Internal signal monitor terminal Non connection 13MHz CLK PLL loop filter terminal Power supply terminal decoupling terminal for DC bias RSSI 13MHz clock output for BB RX data signal in or TX PA control signal out RX or TX Data signal in/out Non connection Data input terminal for serial data Clock input terminal for serial data Strobe input terminal for serial data Power supply terminal Crystal output terminal Crystal input terminal or External Clock input terminal External BS signal input terminal Lock detect output Power supply terminal External reset signal input terminal Main PLL loop filter terminal Power supply terminal Antenna control signal Antenna control signal (inverted ANTSW) External PA voltage control signal for gain PA output terminal Power supply terminal Power supply terminal LNA input terminal MIX decoupling terminal for DC bias Internal signal monitor terminal GND terminal GND terminal External PA on/off control signal GND terminal GND terminal GND terminal GND terminal GND terminal - 4 - June 26, 2003 TENTATIVE 4 TB31296FT MAXIMUM RATINGS ( Ta=25℃ ) CHARACTERISTICS Power Supply Voltage Power Dissipation Input terminal Voltage Storage Temperature Range SYMBOL RATING UNIT VCC 3.6 V PD 530 mW CLK、DATA、STB、BS、LD 3.4 V Tstg -50 ∼ 150 ℃ Maximum ratings indicate the limits, which the device must not be beyond 5 OPERATING RANGES CHARACTERISTICS SYMBOL Analog supply voltage TEST CONDITION MIN TYP. MAX UNIT Vcc* 2.7 3.3 3.4 V Digital interface I/O supply voltage Vdd 1.8 3.3 3.4 V Operating temperature -35 85 ℃ Topr Operating ranges indicate the conditions for which the device is intended to be functional even with the electrical changes 6 ELECTRICAL CHARACTERISTICS ( Unless otherwise specified, Ta=25℃ ,VCC=3.3V , f=2450MHz) This spec is IC design target value and in mass production these may be updated. POWER SUPPLY CHARACTERISTICS SYMBOL Current Consumption Rx (*2) ICCRX RX mode, BS=H - 42.0 60.0 mA Current Consumption Tx ICCTX TX mode, BS=H, PAout=0[dBm] - 26.9 40.0 mA - 15.5 - mA 0.01 10 uA TEST CONDITION Current Consumption tune ICCwait2 During synthesizer tuning Current Consumption BS ICC BS Battery save mode, BS=L " H " level input/output level VIH " L " level input/output level VIL CLK, DATA, STB, BS, RFbus1, RFbus2, BB13M CLK, DATA, STB, BS, RFbus1, RFbus2, BB13M INPUT SIGNAL REGURATION CHARACTERISTICS SYMBOL Reference Clock frequency Reference Clock level Serial data bus input frequency Fclk Vclk Dbus-freq. PLL CHARACTERISTICS CHARACTERISTICS SYMBOL Operating frequency range Lock Up Time VCO phase noise TEST CONDITION MIN Vdd× 0.8 -0.2 MIN 200[kHz] step TEST CONDITION TYP. 4 TBD - MIN MAX Vdd Vdd+ V 0.2 0 Vdd× V 0.2 TYP. MAX 13 110 13 TYP. Pn1 Pn2 Pn3 Phase comparison ref: 500kHz CP current= 2mA @500kHz @1MHz @2MHz - 5 - - 85 107 113 119 UNIT 50 MHz TBD dBuV 20 MHz MAX 2380 t-lock UNIT UNIT 2500 MHz - us dBc/Hz dBc/Hz dBc/Hz June 26, 2003 TENTATIVE RX CHARACTERISTICS CHARACTERISTICS Sensitivity Maximum input range RSSI output level 1 (*6) RSSI output level 2 (*6) C/I performance SYMBOL Sense maxRange V (RSSI-1) V (RSSI-2) InterCo Inter+1MHz Inter-1MHz Inter+2MHz Inter-2MHz Inter+3MHz Inter-3MHz Inter+4MHz Inter<-3MHz Inter+5MHz Inter+6MHz Inter+7MHz Inter>7MHz Intermodulation Receiver spurious emission Out of band blocking TB31296FT TEST CONDITION MIN BER=0.1%、RXin TYP. -10 TBD TBD Vin(LNA)=-60dBm, no mod. Vin(LNA)=-40dBm, no mod. (*1) (*1) (*1) (*2) (*2) Image –1MHz frequency Image frequency Image +1MHz frequency From Bluetooth spec. 30MHz to 1GHz 1GHz to 12.75GHz -39 OBB1 OBB2 OBB3 OBB4 MAX -83 TBD 1.28 2.04 8.8 2.0 0.1 -24 -31 -31 -41 -41 -42 -30 -20 -30 -42 TBD TBD TBD TBD TBD TBD TBD UNIT TBD TBD TBD 14 4 4 TBD -30 TBD -40 -40 -40 -20 -9 -20 -40 dBm dBm V V dB dB dB dB dB dB dB dB dB dB dB dB dB dBm dBm dBm dBm dBm dBm dBm (*1) use relaxed regulation (*2) use relaxed regulation from spurious response TX CHARACTERISTICS CHARACTERISTICS TX output signal level TX Output Signal control range TX max output TX minimum output 20dB bandwidth Frequency deviation Frequency Drift In-band spurious emission Out of band spurious External PA control voltage SYMBOL TEST CONDITION PAOUT(max Nominal setting ) PArange 17 step controlled PAmax PAmin Dev(Tx) Fdrift OBS1 OBS2 OBS3 OBS4 OBS5 OBS6 EPA1 EPA2 EPA3 N (*9) DH1 packet 2MHz offset >= 3MHz offset 30MHz to 1GHz with operating 30MHz to 1GHz with BS 1 to 12.75GHz with op. 1GHz to 12.75GHz with BS 1.8GHz to 1.9GHz 5.15GHz to 5.3GHz Cont. steps - 6 - MIN TYP. TBD -13 TBD TBD 140 MAX 0 5 -13 807 160 1.6 0 N/30 x Vcc Vcc 30 UNIT TBD dBm 5 TBD TBD 1000 175 25 -20 -40 dBm dBm dBm MHz kHz kHz dBm dBm dBm dBm dBm dBm dBm dBm V V V step June 26, 2003 TENTATIVE Nominal DATA 7.1 Vcc – Icc TB31296XBG Vcc-Icc 60.00 13MCLK WAIT1 WAIT2 TX1 TX2 RX(BB) RX(RSSI) ALL BS 50.00 Icc(mA) 40.00 30.00 20.00 10.00 0.00 0.0 7.2 1.0 2.0 Vcc(V) 3.0 4.0 PA output Power TX Power Characteristics 15.00 10.00 TX Power(dBm) 7 TB31296FT 5.00 3.0V 0.00 -5.00 -10.00 -5 0 5 Resister Setting - 7 - 10 15 June 26, 2003 TENTATIVE 7.3 TB31296FT RX Sensitivity RX Sensitivity 10 Room Temp BER （％） 1 0.1 0.01 0.001 0.0001 -90 -80 -70 -60 -50 -40 -30 -20 -10 0 10 RF Input Level （dBm） RX Sensitivity 10 BER （％） 1 0.1 Room Temp 0.01 0.001 0.0001 -90 -88 -86 -84 -82 -80 -78 -76 -74 -72 -70 RF Input Level （dBm） - 8 - June 26, 2003 TENTATIVE 7.4 TB31296FT RSSI RXin- RSSI Characteristics（Vcc：3.0V） 2.5 RSSI Voltage （V） 2 1.5 1 0.5 0 -120 7.5 -100 -80 -60 -40 RXIN level（dBm） -20 0 20 X’tal Turning Circuit Characteristics X'tal Turning Characteristics 13.000200 X'tal Frequency (MHz) 13.000150 13.000100 Vcc=3.0V,Room 13.000050 13.000000 12.999950 12.999900 12.999850 -8 -7 -6 -5 -4 -3 -2 -1 0 1 2 3 4 5 6 7 Resister Setting - 9 - June 26, 2003