TRSYS CP308 Single-phase silicon bridge-p.c. mtg 2a, heat-sink mtg 3a Datasheet

CP300 THRU CP3010
SINGLE-PHASE SILICON BRIDGE-P.C. MTG 2A, HEAT-SINK MTG 3A
VOLTAGE - 50 to 1000 Volts CURRENT - 3.0 Amperes
CP-3
FEATURES
l
Surge overload rating—50 Amperes peak
l
Low forward voltage drop and reverse leakage
l
Small size, simple installation
l
Plastic package has Underwriter Laboratory
Flammability Classification 94V-O
l
Reliable low cost construction utilizing molded
plastic technique
MECHANICAL DATA
Terminals: Leads solderable per MIL-STD-202,
Method 208
Weight: 0.08 ounce, 2.5 grams
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
At 25 ambient temperature unless otherwise noted; resistive or inductive load at 60Hz.
Max Recurrent Peak Rev Voltage
Max Bridge Input Voltage RMS
Max Average Rectified Output at TC=50 *
See Fig.2
at TA=25 **
Peak One Cycle Surge Overload Current
Max Forward Voltage Drop per element at
1.5A DC & 25 . See Fig.3
Max Rev Leakage at Rated DC Blocking
Voltage per element at 25
See Fig.4
at 100
I2t Rating for fusing ( t<8.3ms)
CP300
CP301
CP302
CP304
CP306
50
35
100
70
200
140
400
280
3.0
2.0
50
1.0
600
420
Typical Junction capacitance per leg(Note 4)CJ
Typical Thermal Resistance per leg(Note 2) R JA
(Note 3) R JL
Operating Temperature Range
Storage Temperature Range
CP308 CP3010 UNITS
800
560
10.0
1.0
15.0
21.0
12.0
8.0
-55 TO +125
-55 TO +150
NOTES:
1. Bolt down on heat-sink with silicon thermal compound between bridge and mounting surface for
maximum heat transfer with #6 screw.
2. Unit mounted on 4.0×4.0×0.11” thick (10.5×10.5×0.3cm) AL. Plate.
3. Unit mounted on P.C.B at 0.375”(9.5mm) lead length with 0.5×0.5” (12×12mm) copper pads.
4. Measured at 1 MHz and applied reverse voltage of 4.0 Volts.
1000
700
V
V
A
A
V
A
mA
A2Sec
PF
/W
RATING AND CHARACTERISTIC CURVES
CP300 THRU CP3010
Fig. 1-NON-RECURRENT SURGE RATING
Fig. 2-DERATING CURVE FOR OUTPUT
RECTIFIED CURRENT
Fig. 3-TYPICAL FORWARD CHARACTERISTICS
Fig. 4- TYPICAL FORWARD CHARACTERISTICS
Similar pages