Power-One FE5A-1F-0 Front-end power supply provides a single isolated output of up to 5000-watt Datasheet

FE5A AC-DC Front End Data Sheet
Three-Phase Input, 5000 Watts
Features
• Three-phase Ac input
• High efficiency: 90% at full load
• 11.8 Watts/cubic inch power density
• Power factor corrected
• No minimum load required
• Single-wire current sharing
• Current limit and over-voltage protection
• Full power up to 50º C
• Compact size: 5” x 5” x 17”
• LED supply status indicators
• TUV, cTUVus & CB report
Model Number
FE5A-1D-0
FE5A-1E-0
FE5A-1F-0
FE5A-1G-0
FE5A-1H-0
FE5A-1J-0
Output Rating
12V/400A
15V/330A
24V/208A
28V/180A
36V/140A
48V/104A
Options O = M (Output power good – TTL high);
N (Power fail – TTL high); R (Reverse airflow)
Description
The ultra-compact FE5A Series Front-End Power Supply provides a single isolated output of up to 5000-Watts
with inputs ranging from 365 Vac to 528 Vac, 3 phase, and can handle frequencies from 47 Hz to 63 Hz. Designed
for high current applications requiring a compact size. The FE5A series operates either as a standalone unit or as
part of rack-mounted power systems. The supply provides true front-end capability to automatic test equipment,
telecom, data communications, and other distributed power designs.
Input Specifications
Output Specifications
Input voltage range: 380 to 498 Vac, 480 Vac Nominal,
Three Phase, 47 to 63 Hz.
Power Factor: >0.95 at full load and nominal line
Inrush Current: 40 A peak hot and cold start
Input Protection: 15A internal fuse per line is provided
Output Power: 5000 W maximum
Output Voltage & Current Ratings: See chart shown above
Overshoot/Undershoot: Less than 1% at turn-on or turn-off.
Less than 2% for 50% to 100% load step.
Start-Up Time: Less than 3 seconds
Efficiency: 90% typical measured at full load, nominal input
Hold-up Time: 20 ms minimum at full load and low line
Overcurrent Protection: Set to 105-130% of full rated load
with automatic recovery
Overtemperature Protection: Automatic shutdown with auto
recovery.
Remote Sense: Compensates for voltage drop of up to 0.5 V
to the load. Shorted sense lead protection.
Overvoltage Protection: Set at 120%-130% of nominal;
reset by cycling input power.
Output Noise and Ripple: PARD: 1% of output voltage
measured at 20 Mhz bandwidth.
Single Wire Current Share: 5% full load rating
Load Regulation: 0.5% with remote sense, 2% without
Line Regulation: 0.2% over entire operating range
Minimum Load: No minimum load required
Signals and Controls
LED Output Good Indicator: Front panel green LED
indicates power supply is good; amber indicates fault.
LED AC Good Indicator: Front panel green LED indicates
Ac input voltage is present and above minimum level.
Output Good Signal*: TTL compatible signal, normally high.
Goes low when power supply is out of specified range.
Power Fail Signal*: TTL compatible signal, normally high
(indicating Vin is present and above minimum level).
Enable*: Normally TTL High, drive low to enable.
*All interface signals are TTL compatible
Nov 7, 2006
Page 1 of 3
www.power-one.com
FE5A AC-DC Front End Data Sheet
Three-Phase Input, 5000 Watts
Safety & Environmental
Safety & Environmental (continued)
Temperature Range:
Operating: 0 to 50°C
Storage: -40°C to +85°C
Operating Humidity: Maximum 95% RH non-condensing
Operating Altitude: 10,000 feet
Non-operating Altitude: 40,000 feet
Temperature Coefficient: 0.01% per °C within rated load
Safety Agency Compliance: TUV, cTUVus & CB report
EMI: Meets EN55022, Class A
Harmonic Suppression: Meets EN6100-3-2
Input Transient Protection:
Electrostatic Discharge: EN61000-4-2, Criteria B
Radiated, Radio-Frequency, Electromagnetic Field:
EN61000-4-3, Criteria A
Electrical Fast Transients/Burst: EN61000-4-4, Criteria B
Voltage Fluctuations and Flickers: EN61000-3-3, Criteria B
Surge Test: EN61000-4-5, Criteria B
Conducted Immunity: EN61000-4-6, Criteria A
Dielectric Withstand:
Input-to-ground: 2121 Vdc
Input-to-output: 4242 Vdc
Output-to-case: 50 Vdc
Ac Leakage Current: 2mA maximum at 480 Vac, 60 Hz
Mechanical Specifications
Size: 5” H x 5” W x 17” D
Input/Output Connector: Elcon Double Drawer male
connector
Mating Connector: Elcon Double Drawer female connector
MTBF: 100,000 hours calculated at 50°C, Bellcore Standard
Warranty: Two years from date of shipment, standard
product only
Specifications are subject to change without notice.
Outline Drawing and Dimensions
Nov 7, 2006
Page 2 of 3
www.power-one.com
FE5A AC-DC Front End Data Sheet
Three-Phase Input, 5000 Watts
Connector Pin Descriptions
Pin Number
1
2
3
4
9
17
18
19
Signal Name
Output (+)
Output (+)
Output (-)
Output (-)
Chassis Ground
I_Share_M
Remote Sense S+
DC_Enable (See Note 1)
20
26
27
28
37
38
39
PF_HI (See Note 2)
Remote Sense SLogic_Rtn
Pwr_OK (See Note 3)
Input Line A
Input Line B
Input Line C
Notes
1. To turn on output, short Dc-Enable pin # 19 to Logic_Rtn, Pin #27
and short pin 29 to pin 21
2. Ac Good: PF_Hi Pin #20 ref. to Logic_Rtn Pin #27
3. Output Good: Pwr_OK Hi Pin #28 ref. to Logic_Rtn Pin #27
NUCLEAR AND MEDICAL APPLICATIONS - Power-One products are not designed, intended for use in, or authorized for use as critical
components in life support systems, equipment used in hazardous environments, or nuclear control systems without the express written
consent of the respective divisional president of Power-One, Inc.
TECHNICAL REVISIONS - The appearance of products, including safety agency certifications pictured on labels, may change depending on
the date manufactured. Specifications are subject to change without notice.
Nov 7, 2006
Page 3 of 3
www.power-one.com
Similar pages