Keylocks Programmable Illuminated PB Pushbuttons Rockers Toggles Series G A General Specifications Electrical Capacity (Resistive Load) Logic Level: Other Ratings Contact Resistance: Insulation Resistance: Dielectric Strength: Mechanical Life: Electrical Life: Nominal Operating Force: Angle of Throw: Materials & Finishes Indicators Touch Tilt Tactiles Slides Rotaries Actuator: Case: Sealing Rings: Movable Contacts: Stationary Contacts: Base: Power Terminals: Lamp Terminals: Environmental Data Operating Temperature Range: Humidity: Vibration: Shock: PCB Processing Soldering: Cleaning: 0.4VA maximum @ 28V AC/DC maximum (Applicable Range 0.1mA ~ 0.1A @ 20mV ~ 28V) Note: Find additional explanation of operating range in Supplement section. 80 milliohms maximum 500 megohms minimum @ 500V DC 500V AC minimum for 1 minute minimum 100,000 operations minimum 100,000 operations minimum 10,000 operations minimum @ 0.1A @ 28V AC/DC 1.30N 28° Polyamide Glass fiber reinforced polyamide Nitrile butadiene rubber Phosphor bronze with gold plating Phosphor bronze with gold plating Glass fiber reinforced polyamide Phosphor bronze with gold plating Phosphor bronze with gold plating –25°C through +55°C (–13°F through +131°F) 90 ~ 95% humidity for 240 hours @ 40°C (104°F) 10 ~ 500Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning in 1 minute; 3 right angled directions for 2 hours 50G (490m/s2) acceleration (tested in 6 right angled directions, with 5 shocks in each direction) Wave Soldering recommended. See Profile A in Supplement section. Manual Soldering: See Profile A in Supplement section. Automated cleaning. See Cleaning specifications in Supplement section. Standards & Certifications The G Series toggles have not been tested for UL recognition or CSA certification. These switches are designed for use in a low-voltage, low-current, logic-level circuit. When used as intended in a logic-level circuit, the results do not produce hazardous energy. Supplement Accessories Fully Illuminated Ultra-Miniature Toggles A38 www.nkkswitches.com Series G A Rockers Distinctive Characteristics Toggles Fully Illuminated Ultra-Miniature Toggles Pushbuttons Fully illuminated toggle for highly visible status indication with LED in red, green, or amber for single color and red/green for bicolor. Programmable Illuminated PB Ultra-miniature size allows high density mounting, and extremely light weight makes these switches ideal for handheld equipment. Keylocks Totally sealed body construction prevents contact contamination and allows time- and money-saving automated soldering and cleaning. Rotaries Molded-in, epoxy sealed terminals lock out flux, solvents, and other contaminants. Tactiles Slides Award-winning STC contact mechanism with benefits unavailable in conventional mechanisms: smooth, positive detent actuation, increased contact stability, and unparalleled logic-level reliability. (Additional STC details in Terms & Acronyms; see Supplement section.) Indicators Touch Tilt .100” x .100” (2.54mm x 2.54mm) terminal spacing conforms to standard PC board grid spacing. Round terminals facilitate easier throughhole mounting on PC boards. Supplement Accessories Actual Size www.nkkswitches.com A39 TYPICAL SWITCH ORDERING EXAMPLE G Pushbuttons 1 2 SPDT ON Rotaries H ON J Clear Combines with single color or bicolor LEDs 3 ON OFF C LEDS PC Terminals Actuator NONE ON Single Color P Straight H Right Angle C Red V Vertical D Amber F Green Combines with bicolor LED only ON-NONE-ON only Bicolor CF SPDT ON-NONE-ON Circuit DESCRIPTION FOR TYPICAL ORDERING EXAMPLE Clear Toggle, Red LED G12JHC Red/Green ON-NONE-ON & ON-OFF-ON Right Angle PC Terminals POLES & CIRCUITS Toggle Position Up Pole Throw Model SPDT Center Connected Terminals Down Up Center Down Schematics Note: Terminal numbers are not actually on the switch. LED circuit is isolated and requires an external power source. Slot Slot G12 ON NONE ON 2-3 NONE 2-1 G13 ON OFF ON 2-3 OPEN 2-1 2 (COM) 3 (5) 1 (4) Red (6) (5) Single Color (6) Green Bicolor ACTUATOR Tactiles Slides J Circuits Pole 1 2 Keylocks Programmable Illuminated PB Fully Illuminated Ultra-Miniature Toggles A Rockers Toggles Series G J 28° (1.7) Dia .067 Clear Toggle Tilt (3.8) .150 (4.0) Dia .157 Supplement Accessories Indicators Touch LED COLORS & SPECIFICATIONS Single Color LEDs are an integral part of the switch and not available separately. The electrical specifications shown are determined at a basic temperature of 25°C. If the source voltage exceeds the rated voltage, a ballast resistor is required. The resistor value can be calculated by using the formula in the Supplement; see Supplement Index. Colors C D F CF Red Amber Green Red/Green Maximum Forward Current I FM 30mA 30mA 25mA 30mA/25mA Typical Forward Current IF 20mA 20mA 20mA 20mA/20mA Forward Voltage VF 2.0V 2.0V 2.1V 2.0V/2.1V Maximum Reverse Voltage VRM 5V 5V 5V 5V/5V Current Reduction Rate Above 25°C ∆I F Ambient Temperature Range A40 Bicolor www.nkkswitches.com 0 - No current Reduction Rate within Ambient Temperature Range –25° ~ +55°C A (2.54) Typ .100 (0.5) Typ .020 (4.5) .177 (2.54) Typ .100 (7.0) .276 (4.5) .177 (2.54) Typ .100 (0.4) Dia Typ .016 (7.0) .276 Pushbuttons (2.6) .102 (7.0) .276 Vertical (0.5) Typ .020 (0.4) Dia Typ .016 (2.54) Typ .100 (2.54) Typ .100 (2.54) Typ .100 (0.4) Dia Typ .016 V Right Angle (4.5) .177 TYPICAL SWITCH DIMENSIONS (0.4) Dia Typ .016 (2.54) .100 4 5 1 2 28° 6 3 Slot (4.5) .177 (3.8) .150 (1.6) .063 (7.0) .276 (7.0) .276 4 1 5 2 6 3 (2.54) Typ .100 Keylocks (4.0) Dia .157 (0.6) Dia Typ .024 (2.54) Typ .100 (2.6) .102 (2.54) .100 5 & 6 are LED terminals; 4 is a support pin on single color models & an LED terminal on bicolor models. G12JPC Right Angle PC Slides Rotaries (1.7) Dia .067 Straight PC (4.0) Dia .157 3 2 (0.4) .016 1 (4.9) .193 (2.6) .102 (2.54) .100 (5.08) .200 (0.4) Dia Typ .016 (2.54) Typ .100 Tilt (3.8) .150 6 (0.6) Dia Typ .024 4 (0.5) .020 (2.54) .100 3 5 (7.0) .276 5 & 6 are LED terminals; 4 is a support pin on single color models & an LED terminal on bicolor models. (1.7) Dia .067 (0.4) .016 (4.0) Dia .157 4 5 1 2 28° 3 (7.4) .292 6 (2.6) .102 Slot (0.4) Dia Typ .016 (2.54) .100 (5.3) .209 (1.6) .063 (3.8) .150 (1.0) .039 (5.08) .200 (12.76) .502 (0.5) Typ .020 (2.54) Typ .100 (2.54) .100 (0.6) Dia Typ .024 G12JHD Vertical PC 4 1 5 2 6 3 Indicators (5.08) .200 (7.8) .307 (5.08) .200 (1.6) .063 (10.22) .402 5 2 4 (2.54) Typ .100 (5.08) .200 Accessories (0.4) Dia Typ .016 6 (2.54) Typ .100 1 (0.4) Dia Typ .016 (2.54) .100 (4.5) .177 5 & 6 are LED terminals; 4 is a support pin on single color models & an LED terminal on bicolor models. www.nkkswitches.com Supplement (1.7) Dia .067 Tactiles 28° Slot Programmable Illuminated PB H Straight Touch P Rockers PC TERMINALS Toggles Series G Fully Illuminated Ultra-Miniature Toggles G12JVCF A41