Mean Well LPL-18 18w single output switching power supply Datasheet

18W Single Output Switching Power Supply
LPL-18
series
Features :
90-132VAC input only
Fully encapsulated with IP67 level (Note.5)
Protections:Short circuit/Over load/Over voltage/Over temperature
Cooling by free air convection
Pass LPS
100% full load burn-in test
Suitable for LED lighting and moving sign applications
High reliability/Low cost
2 years warranty
LPS IP67
SPECIFICATION
MODEL
OUTPUT
LPL-18-12
LPL-18-24
LPL-18-36
DC VOLTAGE
12V
24V
36V
RATED CURRENT
1.5A
0.75A
0.5A
CURRENT RANGE
0 ~ 1.5A
0 ~ 0.75A
0 ~ 0.5A
RATED POWER
18W
18W
18W
150mVp-p
200mVp-p
83%
84%
RIPPLE & NOISE (max.) Note.2 120mVp-p
VOLTAGE TOLERANCE Note.3
3.0%
LINE REGULATION
1.0%
LOAD REGULATION
INPUT
2.0%
SETUP, RISE TIME
1500ms, 30ms / 115VAC
HOLD UP TIME (Typ.)
20ms/115VAC at full load
VOLTAGE RANGE
90 ~ 132VAC
FREQUENCY RANGE
47 ~ 63Hz
EFFICIENCY(Typ.)
80%
AC CURRENT
INRUSH CURRENT(max.)
0.5A/115VAC
Cold start 40A/115VAC
127 ~ 186VDC
LEAKAGE CURRENT
0.25mA / 115VAC
OVER CURRENT
Above 105% rated output power
Protection type : Hiccup mode, recovers automatically after fault condition is removed
PROTECTION OVER VOLTAGE
13.8~ 16.2V
WORKING TEMP.
WORKING HUMIDITY
ENVIRONMENT STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
VIBRATION
27.6~ 32.4V
41.4 ~ 48.6V
Protection type : Shut off o/p voltage, clamping by zener diode
Tj 140
OVER TEMPERATURE
(LVD)
typically (U1) detect on main control IC
Protection type :Shut down, recovers automatically after temperature goes down
-30 ~ 70
(Refer to output load derating curve)
20 ~ 90% RH non-condensing
-40 ~ +80
0.03%/
, 10 ~ 95% RH
(0 ~ 50
)
10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
SAFETY STANDARDS
IP67 approved; design refer to UL1310 Class 2,TUV EN60950-1, EN61347-2-13, CAN/CSA C22.2 No. 223-M91
WITHSTAND VOLTAGE
I/P-O/P:3KVAC
SAFETY & ISOLATION RESISTANCE
I/P-O/P:>100M Ohms / 500VDC / 25 / 70% RH
EMC
EMI CONDUCTION & RADIATION Compliance to EN55022 (CISPR22) Class B, FCC Part 15
HARMONIC CURRENT
EMS IMMUNITY
MTBF
OTHERS
DIMENSION
PACKING
NOTE
Compliance to EN61000-3-2 Class A,EN61000-3-3
Compliance to EN61000-4-2,3,4,5,6,8,11; ENV50204, EN55024, light industry level, criteria A
1207.4Khrs min. MIL-HDBK-217F(25
140*30*22(L*W*H)
0.175Kg; 70pcs/13.3Kgs/0.71CUFT
)
1. All parameters NOT specially mentioned are measured at 115VAC input, rated load and 25 of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
5. Suitable for indoor use or outdoor use without direct sunlight exposure.
File Name: LPL-18-SPEC 2011-03-09
LPL-18
18W Single Output Switching Power Supply
Mechanical Specification
series
Unit:mm
300 20
300 20
140
3.6
3.5
30
3.6
DC OUT
AC IN
18AWG 1015
AC/N(Blue)
AC/L(Brown)
3.5
3.5
18AWG
1015
-V(Black)
+V(Red)
22
3.5
Block Diagram
I/P
fosc : 60KHz
EMI FILTER
RECTIFIERS
&
FILTER
POWER
SWITCHING
RECTIFIERS
+V
-V
DETECTION
CIRCUIT
PWM
CONTROL
Derating Curve
Static Characteristics
Ta=25
100
100
90
80
80
70
LOAD (%)
LOAD (%)
60
40
20
-30
0
10
20
30
40
50
AMBIENT TEMPERATURE ( )
60
70
(HORIZONTAL)
60
50
40
90
100
110
120
132
INPUT VOLTAGE (VAC) 60Hz
File Name: LPL-18-SPEC 2011-03-09
Similar pages