TT OP755D Npn silicon phototransistor Datasheet

OP550, OP552, OP555, OP560, OP565,
OP750 Series
OP552
Features:






OP555
OP565
OP550
OP560
OP750
OP770
Wide receiving angle
Four sensitivity ranges
Side-looking package
Ideal for space-limited applications
Ideal for PCBoard mounting
Choice of clear, opaque or blue-tinted package
Description:
OP550, OP552, OP555, OP750, and OP770 series consists of a NPN silicon phototransistor molded in an epoxy package with
a wide receiving angle that provides relatively even reception over a large area. The OP750 and OP770 have additional
circuitry to enhance the operation of the device for stray light levels.
OP560 and OP565 series consists of a NPN silicon photodarlington transistor molded in an epoxy package with a wide
receiving angle that provides relatively even reception over a large area.
The side-looking package design allows easy PCBoard mounting of slotted optical switches or optical interrupt detectors.
The OP550, OP560, OP750 and OP770 devices have an external lens in a clear epoxy package.
The OP552 device has an integral lens in an opaque plastic package that is optically transparent to infrared light but opaque
to visible wavelengths. This feature allows the device to be used under high ambient light conditions – or anywhere
external light sources could interfere with the intended sensing application (visible light immunity).
The OP555 and OP565 devices have an internal lens in a blue-tinted package. The lensing effect of this package allows an
acceptance half-angle of 28° when measured from the optical axis to the half-power point.
These devices are 100% production tested using infrared light for close correlation with OPTEK’s GaAs and GaAIAs emitters.
All of these sensors are mechanically and spectrally matched to the OP140, OP142, OP145, OP240 and OP245 series of
infrared emitting diodes.
Please refer to Application Bulletins 208 and 210 for additional design information and reliability (degradation) data.
For custom versions please contact your OPTEK representative.
Applications:
OP __ __ __ __
 Applications requiring







wide receiving angle
Applications requiring
PCBoard mounting
Space-limited applications
Optical switches
Optical interrupt detectors
Optical encoders
Non-contact position
sensing
Machine automation
55 = Phototransistor
56 = Photodarlington
75 = Phototransistor with RBE
A = Highest sensitivity level
B = Sensitivity Level with Min. Max.
C = Middle Sensitivity Level
77 = Phototransistor with CCE
D = Lowest Sensitivity Level
0 = Extended Lens - Clear Package
2 = Extended Lens - Blue Tinted Package
5 = Integral Lens - Blue Tinted Package
OP550A
OP550B
OP550C
OP550D
OP552A
OP552B
OP552C
OP552D
OP555A
OP555B
OP555C
OP555D
Available Part Numbers
OP560A OP565A OP750A
OP560B OP565B OP750B
OP560C OP565C OP750C
OP750D
OP755A
OP755B
OP755C
OP755D
OP770A
OP770B
OP770C
OP770D
OP775A
OP775B
OP775C
OP775D
RoHS
General Note
TT Electronics reserves the right to make changes in product specification without
notice or liability. All information is subject to TT Electronics’ own data and is
considered accurate at time of going to print.
© TT electronics plc
OPTEK Technology, Inc.
1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200
www.optekinc.com | www.ttelectronics.com
Issue A
08/2016
Page 1
OP550, OP552, OP555, OP560, OP565,
OP750 Series
OP550, OP552, OP560, OP750, OP770 (A, B, C, D)
DIMENSIONS ARE IN:
[MILLIMETERS]
INCHES
OP555, OP565 (A, B, C, D)
DIMENSIONS ARE IN:
[MILLIMETERS]
INCHES
2
Pin #
Sensor
1
2
Emitter
Collector
OP555 - CONTAINS POLYSULFONE
To avoid stress cracking, we suggest using
ND Industries’ Vibra-Tite for thread-locking.
Vibra-Tite evaporates fast without causing structural failure in
OPTEK'S molded plastics.
1
Notes:
1. RMA flux is recommended. Duration can be extended to 10 seconds maximum when flow soldering. A maximum 20 grams force may be applied
to the leads when soldering.
2. For OP550, OP560, OP555 and OP565, derate linearly 1.33 mW/° C above 25° C. For OP552, derate linearly 1.25 mW/° C above 25° C.
3. For all phototransistors in this series, the light source is an unfiltered GaAs LED with a peak emission wavelength of 935 nm. For OP550 and
OP555 only, a radiometric intensity level that varies less than 10% over the entire lens surface of the phototransistor being tested applies.
4. To calculate typical collector dark current in µA, use the formula ICEO=10 (0.040 TA - 3.4), where TA is ambient temperature in °C.
General Note
TT Electronics reserves the right to make changes in product specification without
notice or liability. All information is subject to TT Electronics’ own data and is
considered accurate at time of going to print.
© TT electronics plc
OPTEK Technology, Inc.
1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200
www.optekinc.com | www.ttelectronics.com
Issue A
08/2016
Page 2
OP550, OP552, OP555, OP560, OP565,
OP750 Series
Electrical Specifications
Absolute Maximum Ratings (TA = 25° C unless otherwise noted)
-40o C to +100o C
Storage Temperature Range
Operating Temperature Range
-40o C to +100o C
OP550, OP555, OP560, OP565, OP750
-40o C to +85o C
OP552
Collector-Emitter Voltage
OP550, OP552, OP555, OP560, OP750
30 V
OP565
15 V
Emitter-Collector Voltage
5V
260° C(1)
Lead Soldering Temperature [1/16 inch (1.6 mm) from case for 5 seconds with soldering iron]
Power Dissipation
OP550, OP552, OP555, OP560, OP565
100 mW(2)
OP750
200 mW(2)
General Note
TT Electronics reserves the right to make changes in product specification without
notice or liability. All information is subject to TT Electronics’ own data and is
considered accurate at time of going to print.
© TT electronics plc
OPTEK Technology, Inc.
1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200
www.optekinc.com | www.ttelectronics.com
Issue A
08/2016
Page 3
OP550, OP552, OP555, OP560, OP565,
OP750 Series
Electrical Specifications
Electrical Characteristics (TA = 25° C unless otherwise noted)
SYMBOL
PARAMETER
MIN
TYP
MAX
2.55
1.30
0.25
0.25
-
4.70
2.40
-
OP560A
OP565B
OP560C
6.6
3.3
1.1
-
9.8
-
OP750A
OP750B
OP750D
2.25
1.50
0.85
-
7.00
4.20
7.00
On-State Collector Current
OP550A, OP555A
OP550B, OP555B
OP550C, OP555C
OP550D, OP552D
IC(ON)
UNITS
TEST CONDITIONS
VCE = 5.0 V, EE = 1.0 mW/cm2(3)
VCE = 2.0 V, EE = 0.1 mW/cm2(3)
mA
VCE = 5.0 V, EE = 1.0 mW/cm2(3)
OP770A
IC/∆ T
ICEO
V(BR)CEO
2.25
-
7.00
Relative IC Charge with Temperature
-
1.00
-
%/°C
Collector-Dark Current
-
-
100
nA
30
-
-
15
-
-
5.0
-
-
-
-
0.40
-
-
1.10
Collector-Emitter Breakdown Voltage
OP550, OP552, OP555, OP750, OP770
OP560, OP565
V(BR)ECO
Emitter-Collector Breakdown Voltage
VCE(SAT)
Collector-Emitter Saturation Voltage
OP550, OP552, OP555, OP750, OP770
OP560, OP565
VCE = 5.0 V, EE = 1.0 mW/cm2, λ = 935 nm
VCE = 10.0 V, EE = 0(4)
IC = 100 µA, EE = 0(4)
V
IC = 1 mA, EE = 0(4)
V
IE = 100 µA
IC = 100 µA, EE = 1.0 mW/cm2(3)
V
IC = 0.4 mA, EE = 0.1 mW/cm2(3)
See page 2 for Notes
General Note
TT Electronics reserves the right to make changes in product specification without
notice or liability. All information is subject to TT Electronics’ own data and is
considered accurate at time of going to print.
© TT electronics plc
OPTEK Technology, Inc.
1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200
www.optekinc.com | www.ttelectronics.com
Issue A
08/2016
Page 4
OP550, OP552, OP555, OP560, OP565,
OP750 Series
Performance
Switching Test Circuit
IF
VCC = 5 V
VRL
100
RL
Adjust IF to obtain
OP552 - On-State Collector Current
vs Irradiance
100
12
80
10
On-State Collector Current (IC(ON)) (mA)
Relative Collector Current (%)
OP552 - Angular Response
60
40
20
-45
-30
-15
0
15
30
λ = 935 nm
8
6
4
λ = 880 nm
2
45
0
Angular Displacement (Degrees)
General Note
TT Electronics reserves the right to make changes in product specification without
notice or liability. All information is subject to TT Electronics’ own data and is
considered accurate at time of going to print.
© TT electronics plc
0.5
1.0
1.5
2.0
2.5
3.0
3.5
Irradiance (EE) (mW/cm2)
OPTEK Technology, Inc.
1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200
www.optekinc.com | www.ttelectronics.com
Issue A
08/2016
Page 5
OP550, OP552, OP555, OP560, OP565,
OP750 Series
Performance
OP552 - Rise and Fall Time vs
Load Resistance
OP552 - Output Vs Frequency
100
250
200
80
RL = 1 K
Relative Collector Current (V)
RL = 10 K
Relative Output (%)
VCC = 5 V
VRL = 1 V
f = 100 Hz
PW = 1 ms
60
40
150
tr
100
20
50
1
10
100
1000
0
2K
Frequency (KHz)
4K
6K
8K
10 K
Load Resistance (Ohms)
OP552 - Coupling Characteristic
OP552 - Typical Spectral Response
100
100
80
80
Emitter: OP142
IF: 20mA
VCE: 5V
Relative Response (%)
Relative Response (%)
tf
60
40
20
60
40
20
600
700
800
900
1000
Wavelength (nm)
General Note
TT Electronics reserves the right to make changes in product specification without
notice or liability. All information is subject to TT Electronics’ own data and is
considered accurate at time of going to print.
© TT electronics plc
1100
0
0.2
0.4
0.6
0.8
1.0
Distance (inches)
OPTEK Technology, Inc.
1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200
www.optekinc.com | www.ttelectronics.com
Issue A
08/2016
Page 6
Similar pages