ADVANTECH PCM-3386

PCM-3386
KB/Mouse LCD
CF Socket PCI-104
SODIMM socket
Intel® Celeron® M PCI-104 CPU Module
Features
IDE
 Intel® Pentium® M Processor 1.1 GHz/1.4 GHz/1.6 GHz or Celeron® M 600
MHz
USB
 Intel® 852 GM ICH4 Chipset
 Supports 36-bit LVDS (48-bit LVDS optional)/ VGA
 Supports six USB 2.0 ports
COM 1/2
 Supports Embedded Software API and Utility
LPT
Software APIs:
LAN
Fan
SMBus H/W Monitor Watchdog
GPIO
System Throttling Backlight On/Off
Utility:
Audio Connector
CRT
LVDS
Power
BIOS flash Monitoring
Specifications
Processor System
Memory
SSD
I/O Interface
EIDE
Expansion Slot
Ethernet
Display
Environment
Power
Watchdog Timer
Physical Characteristics
CPU
Front Side Bus
L2 Cache
Chipset
BIOS
Technology
Max. Capacity
Socket
CompactFlash
LPT
FDD
RS-232
RS-232/422/485
K/B
Mouse
USB
Audio
Mode
Channel
PCI-104
Speed
Controller
Interface
Controller
VRAM
LVDS LCD
Dual Independent Display
Operating Temperature
Operating Humidity
Power Type
Power Supply Voltage
Power Consumption:
Typical (WinXP Idle Mode)
Power Consumption:
Max, Test in HCT
Power Management
Battery
Output
Interval
Dimensions (L x W)
Weight
Intel Celeron M 600 MHz
Intel Celeron M 1 GHz
400 MHz
400 MHz
512 KB
Intel 852GM + ICH4
852GM + ICH4
Award 4-Mbit
Award 4-Mbit
DDR 200/266 MHz
1 GB
1 x 200-pin SODIMM
Card Type I, Type II (option for Micro Drive)
1 (share with FDD)
1 (share with LPT)
2
1
1
6 x USB 2.0
AC97, Line-in, Line-out, Mic-in
UDMA 33
1
1
10/100 Mbps
Intel 82562EM
1 x RJ-45 by cable
Intel 852GM/GMCH
Optimized Shared Memory Architecture up to 64 MB system memory
1 x 36-bit LVDS (1 x 48-bit optional) LCD Panel 16:9 wide screen panel supported
CRT + LVDS
0 ~ 60° C (32 ~ 140° F)
0% ~ 90% relative humidity, non-condensing
ATX
+5 V ± 5%, +12 V ± 5%
+5 V @ 2.06 A (Celeron M 600 MHz)
+5 V @ 2.16 A (Celeron M 600 MHz)
APM, ACPI
Lithium 3 V / 210 mAH
System reset
Programmable 1 ~ 255 sec
108 x 115 mm (4.3" x 4.5")
0.279 kg (0.62 lb) (with heat-sink)
Embedded Single Board Computers
All product specifications are subject to change without notice
Last updated : 09-Nov-2009
PCM-3386
Board Diagram
Intel
Celeron M CPU
CRT
Connector
Intel
852GM
Chipset
LVDS
Connector
DDR
SODIMM
LAN
IDE
6 USB
2.0
PCI Bus
Intel
ICH4
Chipset
PCI-104 connector
Audio
LPC BUS
Super
I/O
BIOS
COM1
COM2
PS2
KB/MS
LPT
Ordering Information
Part No.
CPU
ULV Celeron M
1 GHz
Celeron M
PCM-3386F-M0A2E
600 MHz
PCM-3386F-S0A2E
L2
Cache
Chipset
CRT
LVDS
LAN
USB2.0 RS-232 LPT CF
KB/MS
PCI-104
Thermal
connector Solution
Operating
Temp.
0 KB
852 GM
Yes
36-bit
1 FE
6
2
Yes
Yes
Yes
Yes
Passive
0 ~ 60° C
512 KB
852 GM
Yes
36-bit
1 FE
6
2
Yes
Yes
Yes
Yes
Passive
0 ~ 60° C
Packing List
Part No.
1703060053
1701440350
1701440504
1703200380
1701100202
1700060202
1701200220
1700000897
1700000898
1700000916
1700000918
Description
PCM-3386 SBC
Y -Cable external cable
IDE 44P/44P/40P cable 35cm
IDE cable(44pin to 40/44pin)
Wire ATX power
Ethernet RJ-45 Conn.conversion cable
KB / mouse Y-cable
COM port cable
USB Cable 26cm
VGA cable
LPT port cable
Audio cable (Line-in, Line-out, Mic-in)
Quantity
1
1
1
1
1
1
1
1
1
1
1
1
Online Download www.advantech.com/products
Value-Added Software Services
Software API: An interface that defines the ways by which an application program may request services from libraries and/or operating systems. Provides not only the underlying
drivers required but also a rich set of user-friendly, intelligent and integrated interfaces, which speeds development, enhances security and offers add-on value for Advantech platforms.
It plays the role of catalyst between developer and solution, and makes Advantech embedded platforms easier and simpler to adopt and operate with customer applications.
Software APIs
Control
GPIO
SMBus
I2C
Monitor
General Purpose Input/Output is a flexible parallel interface
that allows a variety of custom connections. It allows users
to monitor the level of signal input or set the output status to
switch on/off a device. Our API also provides Programmable
GPIO, which allows developers to dynamically set the GPIO
input or output status.
SMBus is the System Management Bus defined by Intel®
Corporation in 1995. It is used in personal computers and
servers for low-speed system management communications.
The SMBus API allows a developer to interface a embedded
system environment and transfer serial messages using the
SMBus protocols, allowing multiple simultaneous device
control.
I2C is a bi-directional two wire bus that was developed by
Philips for use in their televisions in the 1980s.
The I2C API allows a developer to interface with an embedded
system environment and transfer serial messages using the I2C
protocols, allowing multiple simultaneous device control.
Display
Watchdog
Hardware
Monitor
Hardware
Control
A watchdog timer (WDT) is a device that performs a specific
operation after a certain period of time if something goes wrong
and the system does not recover on its own.
A watchdog timer can be programmed to perform a warm boot
(restarting the system) after a certain number of seconds.
The Hardware Monitor (HWM) API is a system health
supervision API that inspects certain condition indexes, such as
fan speed, temperature and voltage.
The Hardware Control API allows developers to set the PWM
(Pulse Width Modulation) value to adjust fan speed or other
devices; it can also be used to adjust the LCD brightness.
Power Saving
Make use of Intel SpeedStep technology to reduce power power
consumption. The system will automatically adjust the CPU
Speed depending on system loading.
The Brightness Control API allows a developer to interface with
an embedded device to easily control brightness.
Brightness
Control
CPU Speed
The Backlight API allows a developer to control the backlight
(screen) on/off in an embedded device.
System
Throttling
Backlight
Refers to a series of methods for reducing power consumption in
computers by lowering the clock frequency. These APIs allow the
user to lower the clock from 87.5% to 12.5%.
Software Utilities
BIOS Flash
The BIOS Flash utility allows customers to update the flash
ROM BIOS version, or use it to back up current BIOS by
copying it from the flash chip to a file on customers’ disk. The
BIOS Flash utility also provides a command line version and
API for fast implementation into customized applications.
Embedded
Security ID
The embedded application is the most important property of
a system integrator. It contains valuable intellectual property,
design knowledge and innovation, but it is easily copied! The
Embedded Security ID utility provides reliable security functions
for customers to secure their application data within embedded
BIOS.
Monitoring
The Monitoring utility allows the customer to monitor system
health, including voltage, CPU and system temperature and fan
speed. These items are important to a device; if critical errors
happen and are not solved immediately, permanent damage may
be caused.
eSOS
The eSOS is a small OS stored in BIOS ROM. It will boot up in
case of a main OS crash. It will diagnose the hardware status,
and then send an e-mail to a designated administrator. The
eSOS also provides remote connection: Telnet server and FTP
server, allowing the administrator to rescue the system.
Flash Lock
Flash Lock is a mechanism that binds the board and CF card
(SQFlash) together. The user can “Lock” SQFlash via the Flash
Lock function and “Unlock” it via BIOS while booting. A locked
SQFlash cannot be read by any card reader or boot from other
platforms without a BIOS with the “Unlock” feature.
Embedded Single Board Computers
All product specifications are subject to change without notice
Last updated : 09-Nov-2009