Kingbright DC56-11SYKWA 14.22mm (0.56inch) dual digit numeric display Datasheet

14.22mm (0.56INCH) DUAL DIGIT
NUMERIC DISPLAY
Part Number: DC56-11SYKWA
Super Bright Yellow
Features
Description
z 0.56 inch digit height.
The Super Bright Yellow device is made with AlGaInP (on
z Low current operation.
GaAs substrate) light emitting diode chip.
z Excellent character appearance.
z Easy mounting on P.C. boards or sockets.
z Two digit package simplifies alignments & assembly.
z Mechanically rugged.
z Standard : gray face, white segment.
z RoHS compliant.
Package Dimensions& Internal Circuit Diagram
Notes:
1. All dimensions are in millimeters (inches), Tolerance is ±0.25(0.01")unless otherwise noted.
2. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice.
SPEC NO: DSAM8361
REV NO: V.2A
DATE: MAR/19/2015
PAGE: 1 OF 6
APPROVED: WYNEC
CHECKED: Joe Lee
DRAWN: P.Cheng
ERP: 1302000373
Selection Guide
Part No.
Dice
DC56-11SYKWA
Iv (ucd) [1]
@ 10mA
Lens Type
Super Bright Yellow (AlGaInP)
Min.
Typ.
52000
130000
*21000
*40000
White Diffused
Description
Common Cathode,
Rt.Hand Decimal.
Notes:
1. Luminous intensity/ luminous Flux: +/-15%.
*Luminous intensity value is traceable to the CIE127-2007 compliant national standards.
Electrical / Optical Characteristics at TA=25°C
Symbol
Parameter
Device
Typ.
λpeak
Peak Wavelength
Super Bright Yellow
λD [1]
Dominant Wavelength
Δλ1/2
Max.
Units
Test Conditions
590
nm
IF=20mA
Super Bright Yellow
590
nm
IF=20mA
Spectral Line Half-width
Super Bright Yellow
20
nm
IF=20mA
C
Capacitance
Super Bright Yellow
20
pF
VF=0V;f=1MHz
VF [2]
Forward Voltage
Super Bright Yellow
2.0
2.5
V
IF=20mA
IR
Reverse Current
Super Bright Yellow
10
uA
Notes:
1. Wavelength: +/-1nm.
2. Forward Voltage: +/-0.1V.
3. Wavelength value is traceable to the CIE127-2007 compliant national standards.
4. Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or
premature failure.
Absolute Maximum Ratings at TA=25°C
Parameter
Super Bright Yellow
Units
Power dissipation
75
mW
DC Forward Current
30
mA
Peak Forward Current [1]
175
mA
5
V
Reverse Voltage
Operating / Storage Temperature
Lead Solder Temperature[2]
-40°C To +85°C
260°C For 3-5 Seconds
Notes:
1. 1/10 Duty Cycle, 0.1ms Pulse Width.
2. 2mm below package base.
SPEC NO: DSAM8361
REV NO: V.2A
DATE: MAR/19/2015
PAGE: 2 OF 6
APPROVED: WYNEC
CHECKED: Joe Lee
DRAWN: P.Cheng
ERP: 1302000373
Super Bright Yellow
DC56-11SYKWA
SPEC NO: DSAM8361
REV NO: V.2A
DATE: MAR/19/2015
PAGE: 3 OF 6
APPROVED: WYNEC
CHECKED: Joe Lee
DRAWN: P.Cheng
ERP: 1302000373
PACKING & LABEL SPECIFICATIONS
DC56-11SYKWA
Terms and conditions for the usage of this document
1. The information included in this document reflects representative usage scenarios and is intended for technical reference only.
2. The part number, type, and specifications mentioned in this document are subject to future change and improvement without
notice. Before production usage customer should refer to the latest datasheet for the updated specifications.
3. When using the products referenced in this document, please make sure the product is being operated within the environmental
and electrical limits specified in the datasheet. If customer usage exceeds the specified limits, Kingbright will not be responsible
for any subsequent issues.
4. The information in this document applies to typical usage in consumer electronics applications. If customer's application has
special reliability requirements or have life-threatening liabilities, such as automotive or medical usage, please consult with
Kingbright representative for further assistance.
5. The contents and information of this document may not be reproduced or re-transmitted without permission by Kingbright.
6. All design applications should refer to Kingbright application notes available at http://www.KingbrightUSA.com/ApplicationNotes
SPEC NO: DSAM8361
REV NO: V.2A
DATE: MAR/19/2015
PAGE: 4 OF 6
APPROVED: WYNEC
CHECKED: Joe Lee
DRAWN: P.Cheng
ERP: 1302000373
SPEC NO: DSAM8361
REV NO: V.2A
DATE: MAR/19/2015
PAGE: 5 OF 6
APPROVED: WYNEC
CHECKED: Joe Lee
DRAWN: P.Cheng
ERP: 1302000373
SPEC NO: DSAM8361
REV NO: V.2A
DATE: MAR/19/2015
PAGE: 6 OF 6
APPROVED: WYNEC
CHECKED: Joe Lee
DRAWN: P.Cheng
ERP: 1302000373
Similar pages