ETC2 BLED12W-043-C0280 Budget series switch mode led driver Datasheet

BLED-12W Series
Budget Series Switch Mode LED Drivers
Constant Current with Isolation
Black Magic Thermal Advantage™ Plastic Housing
Electrical Specifications
Input Voltage Range:
100-277 Vac Nom. (90-305 V Min/Max)
Frequency:
50/60 Hz Nom. (47-63 Hz Min/Max)
Power Factor:
>0.90 @ full load, 120V; >0.80 @ full load, 277V
Inrush Current:
<10.0 A max @ 230 Vac, cold start 25ºC
Input Current:
0.18 A max @ 120 Vac; 0.10 A max @ 230 Vac
Maximum Power:
12W
Line Regulation:
± 4%
Load Regulation:
± 5%
THD:
<
_ 20% @ full load
Leakage Current:
300 µA Typical
Hold Up Time:
Half Cycle
Start-up Time:
< 1.0 S
Output Protection:
Over-Voltage, Over-Current, Short Circuit (auto-recovery)
Environmental Specifications
Minimum Starting Temp:
-30ºC
Storage Temperature:
-40ºC to +85ºC
Maximum Case Temp.
90°C
Humidity:
5% to 95%
Cooling:
Convection
Sound Rating:
Class A
Vibration Frequency:
5 to 55 Hz/2g, 30 minutes
MTBF:
580,000 Hours @ full load, 40ºC per MIL-217F Notice 2
Impact Resistance:
1g/s
Weight:
3.9 oz. (110 g)
• Smaller footprint than our standard drivers
• Total Power: 12 Watts
• Input Voltage: 100-277 Vac
• Indoor Applications, IP64
• UL Dry or Damp Location Rated
• 2 year Warranty
Constant Current - Product Specifications
Model Number
Output Current Output Voltage
(mA ±5%)
Range (Vdc)
Max. Output
Typical
Power (W) Efficiency
BLED12W-150-C0080
80
90-150
12
89%
BLED12W-100-C0120
120
60-100
12
89%
BLED12W-048-C0250
250
28-48
12
88%
BLED12W-043-C0280
280
26-43
12
87%
BLED12W-036-C0350
350
21-36
12.6
86%
BLED12W-024-C0500
500
15-24
12
85%
BLED12W-018-C0660
660
11-18
12
84%
BLED12W-016-C0800
800
10-16
12.8
83%
BLED12W-012-C1000
1000
7-12
12
82%
Class 2:
US/Canada
US Only
E332160
Note:
LED drivers are designed and intended to operate LED loads only.
Non-LED loading may be outside the specified design limits of our
LED drivers, and therefore cannot be covered by any warranty.
If you desire to use our LED drivers to operate non-LED loads
please contact us to discuss compatibility.
Specifications subject to change without notice.
Rev 8-12-15
Thomas Research Products • 1215 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com
BLED12W Series
SSL Solutions Faster Than The Speed Of Light®
Pg 2 of 2
0.14 [3.5]
2 x Ø 0.137 [3.5]
HOT SPOT
5.91 Min [150 Min]
5.91 Min [150 Min]
0.39±0.04 [10.0±1]
Output
Red (+)
Blue (-)
1.5 [38.1]
WIRE SPECS:
Input Leads: 18 AWG, rated 600 V, 105C, min.
Output Leads: 18 AWG, rated 300 V, 105C, min.
All wires are stranded with solder dipped ends.
4
0.98 [25]
Input
White (N)
Black (L)
0.51 [13]
3.0 [75.9]
0.14 [3.5]
0.7 [18]
0.65 [16.5]
0.39±0.04 [10.0±1]
Dimensions - mm
1.23 [31.2]
Lifetime / Case Temperature
135
Safety and EMC Compliance
UL/CUL
CE
FCC, 47CFR Part 15
EN61000-3-2
EN61000-3-3
Lifetime (kHrs)
120
105
90
75
UL8750, CSA-C22.2
EN61347
Class B
Class C
60
45
30
15
0
40
45
50
55
60
65
70
75
80
Case Hotspot Temperature (°C)
85
90
Note:
Life calculations are based on reliability with confidence using
a 90% confidence level and <5% failure rate. At a confidence
level of 90% it is expected that <5% of the parts will fail at
the rated life provided. (Failure is defined as a driver drifting
outside specification, rather than fail to operate)
UL Conditions of Acceptability
See website for additional information
Note:
Disconnect power to LED driver for at least 30 seconds before connecting or disconnecting Driver output and LED Engine. This prevents potential arcing transients
that can damage the Engine and Driver. See Hot Plugging in our Driver Application Guide for more information.
Thomas Research Products • 1215 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com
Similar pages