POWER DS650/DS850 Data Sheet Distributed Power Bulk Front-End Total Input 650/850 Watts Power: +3.3 Vdc Standby Output Wide Range 90 - 264 Vac Output Voltage: 12, 24 and 48 V SPECIAL FEATURES Active power factor correction EN61000-3-2 harmonic compliance Inrush control 1U X 2U form factor 15.4 W/ in3 12 Vdc, 24 Vdc and 48 Vdc output Available in +3.3 V and +5.0 V standby output versions No minimum load required Hot plug operation N + 1 redundant Internal OR’ing fets Active current sharing (10 - 100% load) Built-in cooling fans (40 mm x 28 mm) I2C communication interface bus EEPROM for FRU data Amber/Green bi-color LED status Internal fan speed control Fan Fail Tach output signal One year warranty SAFETY UL/cUL 60950 (UL Recognized) NEMKO+ CB Report EN60950 EN60950 CE Mark China CCC Electrical Specifications Input Input range 90 - 264 Vac (wide range) Frequency 47 - 63 Hz, single phase AC Inrush current 55 A maximum inrush current Efficiency > 82% typical at full load, high line Conducted EMI FCC Subpart J EN55022 Class B Radiated EMI FCC Subpart J EN55022 Class B Power factor 0.99 typical Leakage current 1.40 mA @ 240 Vac Hold up time 20 ms minimum Output Main DC voltage +12 V @ 52.5 A/70.0 A +24 V @ 26.3 A/35.0 A +48 V @ 13.1 A/17.5 A Standby +3.3 vsb @ 6 A (5 V @ 4 A available) Adjustment range Factory Set, no pot adjustments Regulation Main output; +5%/-5% +3.3 vsb; +5%/-5% Overcurrent 110% - 150% of nominal Latches off if overcurrent lasts over 1 second, otherwise it is auto recovery. +3.3 vsb, 9 A max (hiccup mode) Over oltage 110% - 120% of nominal +3.3 vsb; 3.76 - 4.30 Vdc Undervoltage 75% - 90% of nominal Turn-on delay 2 Second max, 5 - 50 mS, Monotonic Rise Main output rise time 5 - 50 mS, Monotonic Rise DS650/DS850 Data Sheet Logic Control PS_SEATED TTL logic LOW if power supply is seated into system connector. This is a short pin. A logic HIGH if the PSU is removed. PWR GOOD Active TTL HiIGH when output is within regulation limits. AC OK A LOW logic level if the input voltage is within allowable limits. A TTL logic HIGH level, and a 5mS early warningsignal before main output loss of regulation. Temp OK A TTL logic HIGH, when operating within allowable temperature range. PS_INHIBIT/PS_KILL This signal is connected to a short pin on the PSU When left open power supply operation will be inhibited. When the power supply is inserted into the system, this pin will be pull low by the system and turn the power supply on only after all other power supply pins have seated. Environmental Specifications Operating temperature: 0 to 50° C, unimpeded airflow Storage temperature: -40 °C to +85 °C Altitude, operating 10,000ft. Electromagnetic susceptibility/Input transients: -EN61000-3-2, -3-3 -EN61000-4-2, 4.3, 4-4, -4-5, 4-11 -EN55024: 1998 RoHS & lead-free compliant (no tantalum caps.) Humidity: 20 to 90% RH, non-condensing Shock and vibration specificatons complies with Astec Std. Specifications. MTBF (Demonstrated) 500K Hrs at full load, 40 °C Ordering Information Output Nominal Output Voltage Set Point Set Point Tolerance** Total Regulation Minimum Current Maximum Current Output Ripple P/P DS650-3 12.0 Vdc 3.3 vsb* ±0.2% ±1% ±5% ±5% 0A 0A 52.5 A 6.0 A 120 mV 50 mV DS650-5 24.0 Vdc 3.3 vsb* ±0.2% ±1% ±5% ±5% 0A 0A 26.3 A 6.0 A 240 mV 50 mV DS650-9 48.0 Vdc 3.3 vsb* ±0.2% ±1% ±5% ±5% 0A 0A 13.1 A 6.0 A 480 mV 50 mV DS850-3 12.0 Vdc 3.3 vsb* ±0.2% ±1% ±5% ±5% 0A 0A 70.0 A 6.0 A 120 mV 50 mV DS850-5 24.0 Vdc 3.3 vsb* ±0.2% ±1% ±5% ±5% 0A 0A 35.0 A 6.0 A 240 mV 50 mV DS850-9 48.0 Vdc 3.3 vsb* ±0.2% ±1% ±5% ±5% 0A 0A 17.5 A 6.0 A 480 mV 50 mV *For 5 vsb, please contact marketing department. **Set point tolerance is measured at nominal voltage, 50% load and room temperature. DS650/DS850 Data Sheet Mechanical Drawing Power Supply Condition LED Green/Amber No AC power to all PSU OFF AC present/Standby outpus ON, Main output OFF Blinking Green Power supply DC outputs ON and OK Solid Green Main output failure (OCP, OVP, UVP) Blinking Amber Fan Fail, OTP, Standby output OCP/UVP Solid Amber DS650/DS850 Data Sheet DC Output Connector Pinout Assignment Male connector as viewed from the rear of the supply: D1 D2 D3 D4 D5 D6 C1 C2 C3 C4 C5 C6 B1 B2 B3 B4 B5 B6 A1 A2 A3 A4 A5 A6 PB1 PB2 PB3 PB4 PB5 P1 - Power Supply Side Mating Connector (System Side) 1 FCI Power Blade 51721 series 51721-10002406AA 1 FCI Power Blade 51741-10002406CC Strait Pins 2 Molex Power Connector SD-87667 series 87667-7002 2 FCI Power Blade 51761-10002406AA Right Angle Pin Assignments PB6 Pin Assignments Pin Signal Name Pin Signal Name PB 1 MAIN O/P RETURN C1 SDA (I2C Data Signal) PB 2 MAIN O/P RETURN C2 SCL (I2C Clock Signal)* PB 3 MAIN O/P RETURN C3 POWER GOOD PB 4 + MAIN O/P C4 FAN FAIL (Fan Fail Signal) PB 5 + MAIN O/P C5 +3V3 STAND-BY PB 6 + MAIN O/P C6 +3V3SB RETURN A1 PS_ON D1 A0 (I2C Address BIT 0 Signal) A2 MAIN O/P V RMT SENSE RETURN D2 A1 (I2C Address BIT 1 Signal) A3 TEMP_OK D3 S_INT (Alarm) A4 PS_SEATED ( Power Supply Seated) D4 +3V3 STAND-BY RMT SENSE A5 +3V3 STAND-BY D5 +3V3 STAND-BY A6 +3V3SB RETURN D6 +3V3SB RETURN B1 AC_OK (AC Input Present) B2 MAIN O/P RMT SENSE B3 MAIN O/P CURRENT SHARE B4 PS_INHIBIT B5 +3V3 STAND-BY B6 +3V3SB RETURN *Supports I2C standard mode (100 kHz) only WORLDWIDE OFFICES Americas Europe (UK) Asia (HK) 2900 S.Diablo Way Tempe, AZ 85282 USA +1 888 412 7832 Waterfront Business Park Merry Hill, Dudley West Midlands, DY5 1LX United Kingdom +44 (0) 1384 842 211 14/F, Lu Plaza 2 Wing Yip Street Kwun Tong, Kowloon Hong Kong +852 2176 3333 While every precaution has been taken to ensure accuracy and completeness in this literature, Artesyn Embedded Technologies assumes no responsibility, and disclaims all liability for damages resulting from use of this information or for any errors or omissions. Artesyn Embedded Technologies, Artesyn and the Artesyn Embedded Technologies logo are trademarks and service marks of Artesyn Embedded Technologies, Inc. All other names and logos referred to are trade names, trademarks, or registered trademarks of their respective owners. © 2015 Artesyn Embedded Technologies, Inc. www.artesyn.com For more information: www.artesyn.com/power For support: [email protected] DS650/DS850-DS 08May2015