PIN Silicon Photodiode OP913 Series OP913SL Features: • • • • • OP913WSL TO-05 herme cally sealed package Linear response vs. irradiance Fast switching me Narrow receiving angle Enhanced temperature range Description: OP913SL and OP913WSL consist of a PIN silicon photodiode mounted in a two-leaded TO-05 herme cally sealed package. OP913SL has a dome lens with an acceptance angle of 10° when measured from the op cal axis to the half power point. OP913WSL has a flat lens with an acceptance half angle of 30°. This large ac ve area allows very low light level detec on. Please refer to Applica on Bulle ns 208 and 210 for addi onal design informa on and reliability (degrada on) data. Applications: • • • • • • Ordering Information Non-contact reflec ve object sensor Assembly line automa on Machine automa on Machine safety End of travel sensor Door sensor Part Number OP913SL OP913WSL Sensor Photodiode Viewing Angle 20° 80° Lead Length 0.50” OP913SL, OP913WSL OP913SL, OP913WSL 1 2 Pin# Sensor 1 Cathode 2 Anode DIMENSIONS ARE IN: [MILLIMETERS] INCHES RoHS General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. © TT electronics plc OPTEK Technology, Inc. 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 www.optekinc.com | www.ttelectronics.com Issue A 08/2016 Page 1 PIN Silicon Photodiode OP913 Series Electrical Specifications Absolute Maximum Ratings (TA = 25° C unless otherwise noted) Storage Temperature Range -65°C to +150°C Operating Temperature Range -65°C to +125°C Reverse Voltage 32 V 260°C(1) Lead Soldering Temperature [ 1/16 inch (1.6 mm) from the case for 5 seconds with soldering iron] 150 mW(2) Power Dissipation Electrical Characteristics (TA = 25° C unless otherwise noted) SYMBOL PARAMETER MIN TYP MAX UNITS TEST CONDITIONS IL Reverse Light Current: OP913SL OP913WSL 120 40 - - μA VR = 5 V, EE = 5 mW/cm2 (3)(4) ID Reverse Dark Current - - 25 nA VR = 10 V, EE = 0(3) VCC Open Circuit Voltage: OP913SL OP913WSL - 400 300 - mW EE = 5 mW/cm2(4) ISC Short Circuit Current: OP913SL OP913WSL 120 40 - - V EE = 5 mW/cm2(4) VBR Reverse Breakdown Voltage 32 - - V EE = 100 µA CT Total Capacitance - - 150 pF VR = 0, EE = 0, F = 1 MHz Turn On / Turn Off Time - 50 - ns VR = 10 V, RL = 1 kΩ tON, tOFF Notes: (1) (2) (3) (4) (5) (6) RMA flux is recommended. Dura on can be extended to a maximum of 10 seconds when flow soldering. Derate linearly 1.5 mW/° C above 25° C. Junc on temperature for all devices in this data sheet is maintained at 25° C. Light source is an unfiltered tungsten bulb opera ng at CT = 2870 K or equivalent infrared source. At any par cular wavelength the flux responsively, Rθ is related to quantum efficiency by: Rθ = ηq (λ/1240), where ηq is the quantum efficiency in electrons per photon and λ is the wavelength in nanometers; thus at 900 nm, 0.60 A/W corresponds to a quantum efficiency of 83%. NEP is the radiant flux at a specified wavelength, required for unity signal-to-noise ra o normalized for bandwidth. NEP calcula on is made using responsivity at peak sensi vity wavelength, with spot noise measurement at 1000 Hz in a noise bandwidth of 6 Hz. (λ, f, ∆ f) = (λp, 1000 Hz, 6 Hz). General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. © TT electronics plc OPTEK Technology, Inc. 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 www.optekinc.com | www.ttelectronics.com Issue A 08/2016 Page 2 PIN Silicon Photodiode OP913 Series Performance OP913SL, OP913WSL General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. © TT electronics plc OPTEK Technology, Inc. 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 www.optekinc.com | www.ttelectronics.com Issue A 08/2016 Page 3