ADL ADLPS35-150-104MT Power supply Datasheet

Embedded Solutions
Power Supplies
ADLPS35-150, 150W 2”x4” ATX Power Supply
Features



Small 2”x4” (50mm x 102mm) Footprint

Voltage and Current Specifications (common all variants):
Maximum Input Current = 15A
Maximum Power = 150W Combined
Available Output Current: 5VS/5A, 5V/20A, 3.3V/5A, 12V/10A

Input Protection:
Overcurrent
Overvoltage / Undervoltage / Surge
Reverse Voltage

Output Protection:
Voltage Out of Range (monitored via PWRGD)
Short-circuit



ATX Compliant Signals Available (PS-ON, PWRGD etc.)
Chassis and PC/104 Mounting Plates Optional
Two Variants Available:
ADLPS35-150-5: Input: 7-36V, Output: 5V, 5VS, 3.3V
ADLPS35-150-12: Input: 14-36V, Output: 5V, 5VS, 3.3V, 12V
Temperature Range: -40C to +85C
Minimal Cooling Required: Chassis Heatspreader or PC/104 Mounting Plate Provide Sufficient Cooling for –40C to +85C Operation
Ordering Information
Description
Item Code
Part #
Description
ADLPS35-150-5
293023
ADLPS35-150-5, 5V, 5VS, 3.3V, ET
ADLPS35-150-12
293024
ADLPS35-150-12, 5V, 5VS, 12V, 3,3V, ET
*input connector included.
Accessories
ADLPS35-150-104MT
293029
ADLPS35-150 PC/104 mounting plate with
hardware kit
ADLPC35-150-HSP
293027
ADLPS35-150 Heat spreader for chassis mount
with hardware kit
ADLPS35CB-XPWR-5
100-9870
ADLPS35-150, 16P to 10P uFit conn, 5V ATX
Power Cable
ADLPS35CB-XPWR-12
100-9871
ADLPS35-150, 16P to 10P uFit conn, 5V/12V
ATX Power Cable
MILCOTS-FILTER
293031
MIL-STD 704/1275/461 Input Filter; 120w max.
The ADLPS35-150 power supply board is designed to meet the
needs of industrial and embedded motherboards by providing
robust ATX voltages (5V, 5VS, 3.3V, 12V) in a small form factor
power supply designed for -40C to +85C operation. Its small
2”x4” size (50mm x 102mm) allows it to fit many space limited
applications. As well, the ADLPS35-150 is tailored to sit side-by
-side with our 3.5-inch product line of motherboards and can
also be adapted to a PC/104 stack via an optional mounting
plate.
The power supply features ATX compliant signaling to allow
ACPI/APM power management from within compliant operating
systems. At 150 Watts total power and just 50mm x 102mm in
size, this small and rugged power supply will fit into most embedded applications. The ADLPS35-150 is available in two variants, one allowing an input voltage range of 7-36V but providing
only the 5V, 5VS, and 3.3V outputs, the other with a narrower
input voltage range of 14-36V but providing 5V, 5VS, 3.3V and
12V outputs.
The board is protected against many types of input power
anomalies, such as over-currents, voltage deviations and voltage surge. Short bursts of over-current are simply filtered out.
Should overvoltage or under voltage situation persist too long,
the power supply shuts off. Noise interference is dampened by
up to 35dB. The output is protected against reverse voltage and
short-circuit.
Data subject to change without notice.
ADL Embedded Solutions GmbH, Eiserfelder Straße 316 D-57080 Siegen,
Germany P. +49 (0) 271 250 810 0 F. +49 (0) 271 250 810 20
e-mail: [email protected]; web: www.adl-europe.com
ADL Embedded Solutions, Inc. 4411 Morena Blvd., Suite 101
San Diego, CA 92117-4345 P. +1 858 490-0597 F. +1 858 490-0599
e-mail: [email protected]; web: www.adl-usa.com
Embedded Solutions
Power Supplies
ADLPS35-150, 150W 2”x4” ATX Power Supply
P400 - Power Output
P401 - Power Input
Description
Signal
Pin
Pin
Signal
Description
Description
Signal
5 Volts DC
5 Volts DC
Ground
Ground
12 Volts DC
VCC
VCC
GND
GND
12V
1
2
3
4
5
9
10
11
12
13
VCC
VCC
GND
GND
12V
5 Volts DC
5 Volts DC
Ground
Ground
12 Volts DC
Not Connected
NC
1
Not Connected
NC
2
Not Connected
NC
3
Standby 5 Volts
DC
SVCC
6
14
PWRBTN#
ATX Power
Button
Shield Ground
Power Ground
DC Power In
S_GND
P_GND
P_Vin
4
5
6
ATX Power
Good
PWRBTN#
7
7
15
PS_ON
ATX Control
Line
ATX Power Button
ATX_PWRGD
3.3 Volts DC
3.3V
8
16
3.3V
3.3 Volts DC
Power Status
1A Fused DC Out**
PWRSTAT
8
Pin
**This pin will output 12V or 5V at 1A (fused) depending
on whether the power supply is 5V only output.
Data subject to change without notice.
ADL Embedded Solutions GmbH, Eiserfelder Straße 316 D-57080 Siegen,
Germany P. +49 (0) 271 250 810 0 F. +49 (0) 271 250 810 20
e-mail: [email protected]; web: www.adl-europe.com
ADL Embedded Solutions, Inc. 4411 Morena Blvd., Suite 101
San Diego, CA 92117-4345 P. +1 858 490-0597 F. +1 858 490-0599
e-mail: [email protected]; web: www.adl-usa.com
Similar pages