Willow DG81B Sub miniature automotive power relay Datasheet

DG81B
sub miniature automotive power relay
• Sub miniature - only 15.7 x 12.3 x 13.8mm
• Up to 2 x 25A SPST-NO-DM
• For flasher indicators, hazard warning
• Cost effective
• RoHS Compliant
Contacts
Contact number & arrangement
SPST-NO-DM (1 Form U)
Contact material
AgNi90/10; AgSnOInO; AgCdO
Max. switching voltage
Min. switching current / voltage
DC 16VDC (consult factory for 24VDC)
100mA/5VDC
Rated load
DC1 2 x 15A
Max. continuous current
DC1 2 x 15A (2 mins)
Max. switching current
Make 2 x 25A (lamp load inrush)
Break 2x 6A
Initial resistance
100mΩ, max. at 0.1A/6VDC
Coil
Rated voltage
DC 6...24V
Must release voltage
See coil table 1
Operating range of supply voltage
See coil table 1
Rated power consumption
DC 1W
Insulation
Insulation resistance
100MΩ at 500VDC, 50%RH
Dielectric strength
coil to contact 500Vrms, 1min
contact to contact 500Vrms, 1min
General Data
Operating time (typical)
mS 10
Release time (typical)
mS 5
Electrical Life
ops 1 x 105
Mechanical life
ops 1 x 107
Dimensions
Weight
L x W x H 15.7 x 12.3 x 13.8mm (excluding terminal pins)
6g approx.
Ambient temperature
storage -40 to 100°C
operating -40 to 85°C
Shock resistance
Functional: 10g 11mS; Destructive: 100g
Vibration resistance
DA 1.5mm 10-55Hz
Page 1 of 2
Ref: DG81B 121713JHM
www.aecsensors.com
Sales Department Tel: (888) 847-6552
DG81B
sub miniature automotive power relay
Coil Data
Table 1
Coil Voltage Code
Nominal Voltage (VDC)
Coil Resistance (Ω)
±10%
Must operate voltage
max. (VDC)
Must release voltage
min. (VDC)
1006
6
36
3.5
0.5
1009
9
81
5.2
0.7
1010
10
100
5.8
0.8
1012
12
144
6.9
1.0
1024
24
576
14.0
1.9
Ordering codes
Contact material
Type
D
G
8
1
B
-
Contact
arrangement
8
U
Cover protection
and mounting
-
5
Coil code
-
Contact material
10
-
AgCdO
20
-
AgNi (90/10)
70
-
AgSnOInO
See coil table 1
Contact arrangement
8U
-
SPST-NO-DM
Cover protection category
2
-
in cover, flux tight - IP40
3
-
in cover, sealed - IP67
Connection mode
5
-
for PCB
Overall Dimensions, PCB Mounting Holes & Wiring Diagram
12.3 max
0.4
3.0 13.8 max
15.7 max
Dimensions in mm
Notes:
1) All parameters, unless otherwise specified, are measured at an ambient temperature of 23°C.
2) Maximum make current refers to inrush current of lamp load.
3) Electrical life obtained at lamp load, at resistive load 2 x 6A, 14VDC with operating frequency of 6 ops/min.
4) Electrical life is strongly dependent of switching frequency, ON/Off ratio, environmental conditions and load type.
Specifications are subject to change without notice. E&OE.
Page 2 of 2
Ref: DG81B 121713JHM
www.aecsensors.com
Sales Department Tel: (888) 847-6552
Similar pages