Wall HP12S26-600 Fast transient response Datasheet

HP SERIES
600 Watts
Brick Style DC/DC Converter
Single Output
Rev D
Size: 6in x 3in x 0.69in (152.4mm x 76mm x 17.4mm)
FEATURES
•
•
•
•
•
•
•
100% Burn-In
Synchronizable
Output Trim ±10%
1500VDC Isolation
Operation to No Load
600 Watt Output Power (500W below 13VDC input)
Very Low Output Ripple
•
•
•
•
•
•
•
Fast Transient Response
Output Current up to 120A
Fixed Switching Frequency
Remote Sense Compensation
Remote ON/OFF (Active High/Low)
Short Circuit and Over Temperature Protection
94% Efficient at Half Load, 92% Efficient at Full Load (Typical)
DESCRIPTION
The HP series is a high-density brick style converter that incorporates the desired features required in today’s demanding low voltage bus
applications. Its unique dual interleaved phase-shifted topology minimizes both input and output noise. When performance, reliability, and low cost
are needed, the HP series delivers.
MODEL SELECTION TABLE
Model Number(1)
HP12S12-600
HP12S15-600
HP12S20-600
HP12S24-600
HP12S26-600
HP12S28-600
HP12S48-600
11/11/2016
Input Voltage Range Output Voltage Output Current(5) Ripple & Noise No Load Input Current
12/24VDC
(10-36VDC)
12VDC
15VDC
20VDC
24VDC
26VDC
28VDC
50A
40A
30A
25A
23A
21.42A
48VDC
12.5A
1% Vout Max.
0.1A
Output Power
Efficiency
600W
92%
Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 •
Fax 603-778-9797
website: www.wallindustries.com • e-mail: [email protected]
Page 1 of 5
HP SERIES
600 Watts
Brick Style DC/DC Converter
Single Output
Rev D
SPECIFICATIONS
All specifications are based on 25°C, Nominal Input Voltage, and Maximum Output Current unless otherwise noted.
We reserve the right to change specifications based on technological advances.
SPECIFICATION
TEST CONDITIONS
INPUT SPECIFICATIONS
Input Voltage Range
UVLO Turn On at
UVLO Turn Off at
Input Surge Voltage (100ms)
Input Current (Low Line)
Input Filter
Reflected Ripple Current
Remote ON/OFF
OUTPUT SPECIFICATIONS
Output Voltage
Voltage Accuracy
Line Regulation
Load Regulation
Voltage Adjustability
Output Power (See Note 5)
Output Current
Ripple & Noise (20MHz bandwidth)
Transient Response Recovery Time
Min
Typ
10
Unit
36
VDC
10
9.5
VDC
VDC
50
VDC
70
A
1,000µF low ESR capacitor recommended
20
mA
Active High or Active Low
Nominal Vin and Full Load
See Table
±1
±0.2
±0.2
±10
600
See Table
LL to HL at FL
NL to FL
%
%
%
%
W
1
50% Load Step
% Vout
% Total
Devation
%/ºC
5
Temperature Coefficient
PROTECTION
Short Circuit Protection
Self Re-Setting
Over Temperature Protection
Self Re-Setting
Current Limit
ENVIRONMENTAL SPECIFICATIONS
Operating Case Temperature(6)
Storage Temperature
Humidity
MTBF
GENERAL SPECIFICATIONS
At Half Load
Efficiency
At Full Load
±0.02
Continuous
110ºC
130%
-40
-55
100
125
Fully Potted Construction
1, 293, 794.959 hours
94
92
Switching Frequency
Isolation Voltage
Isolation Resistance
Isolation Capacitance
PHYSICAL SPECIFICATIONS
Weight
Max
Input to Output
ºC
ºC
%
300
kHz
0.01
VDC
GΩ
µF
1500
1
19.4oz (550g)
6in x 3in x 0.69in
(152.4mm x 76mm x 17.4mm)
Aluminum Alloy
Six-Sided
Dimensions (L x W x H)
Case Material
Shielding
NOTES
(1)
(2)
(3)
(4)
(5)
(6)
Model number for Threaded Inserts shown.
Unit comes with 3M x 0.5 threaded thru inserts. For 0.125 thru-hole add a “TH” to the model part number. (Ex. HP12S12-600TH)
Pin to pin tolerance ±0.01” [±0.25mm]. Pin diameter tolerance: ±0.005” [±0.13mm]
Active High Enable is standard; for Active Low Enable add “R” suffix to the model number. (Ex: HP12S24-600R)
Due to advances in technology, specifications subject to change without notice.
Output power is limited to 500 watts minimum at 13VDC input and below.
Mi suffix is for military temp range of -55 to 100ºC
11/11/2016
Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 •
Fax 603-778-9797
website: www.wallindustries.com • e-mail: [email protected]
Page 2 of 5
Rev D
HP SERIES
600 Watts
Brick Style DC/DC Converter
Single Output
DERATING CURVES
TRIM EQUATIONS
11/11/2016
Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 •
Fax 603-778-9797
website: www.wallindustries.com • e-mail: [email protected]
Page 3 of 5
Rev D
HP SERIES
600 Watts
Brick Style DC/DC Converter
Single Output
MECHANICAL DRAWINGS
THREADED INSERTS (STANDARD)
THRU-HOLD INSERTS (“TH” SUFFIX)
11/11/2016
Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 •
Fax 603-778-9797
website: www.wallindustries.com • e-mail: [email protected]
Page 4 of 5
Rev D
HP SERIES
600 Watts
Brick Style DC/DC Converter
Single Output
COMPANY INFORMATION
Wall Industries, Inc. has created custom and modified units for over 50 years. Our in-house research and development
engineers will provide a solution that exceeds your performance requirements on-time and on budget. Our ISO9001-2008
certification is just one example of our commitment to producing a high quality, well-documented product for our customers.
Our past projects demonstrate our commitment to you, our customer. Wall Industries, Inc. has a reputation for working closely
with its customers to ensure each solution meets or exceeds form, fit and function requirements. We will continue to provide
ongoing support for your project above and beyond the design and production phases. Give us a call today to discuss your
future projects.
Contact Wall Industries for further information:
Phone:
Toll Free:
Fax:
E-mail:
Web:
Address:
11/11/2016
(603)778-2300
(888)597-9255
(603)778-9797
[email protected]
www.wallindustries.com
37 Industrial Drive
Exeter, NH 03833
Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 •
Fax 603-778-9797
website: www.wallindustries.com • e-mail: [email protected]
Page 5 of 5
Similar pages