FD series Double icon illuminated pushbuttons - bushing Ø 24 or 26 mm - momentary or latching Distinctive features and specifications FD1506-A ❑ Double icon actuator ❑ Snap-in and threaded bushing models ❑ Suited for integrated designs ❑ Large but lightweight ❑ Sealed to IP69K (threaded bushing version) ELECTRICAL SPECIFICATIONS MATERIALS • Max. current/voltage rating with resistive load : - silver contacts (code 2) : 4A 12VDC - gold plated contacts (code 4) : 200mA 12VDC • Initial contact resistance : 50 mΩ max. • Insulation resistance : 1 GΩ min. at 500VDC • Dielectric strength : 1.000 Vrms 50 Hz min. • Electrical life at full load : - Momentary models : 1 million cycles (gold plated contacts) 400.000 cycles (silver contacts) - Latching models : 200.000 cycles • Case : PA46 • Actuator : PA12 • Bushing/ bezel : PA66 • Contacts : silver (code 2) or silver, gold plated (code 4) WIRING DIAGRAM ➞ Flat POLE 2 + LED GENERAL SPECIFICATIONS • Front panel sealing : - Threaded bushing version : IP69K according to DIN 40050-9 - Snap-in version : IP54 according to IEC 60529 with panel gasket and 2 mm panel thickness • Panel thickness : - Snap-in version : 1,5 (.059) to 2 mm (.078) with panel gasket 2 (.078) to 2,5 mm (.885) without panel gasket - Threaded bushing version :1(.039) to 18 mm (.708) max. • Total travel : 2,5 mm ± 0,5 mm • Typical operating force : 8N ± 2N • Low level or mechanical life : - Momentary models : 1 million cycles - Latching models : 200.000 cycles • Torque : 3 Nm max. applied to nut • Operating temperature : -40°C to +75°C - LED POLE 1 CFP24W-A FICHIE ECHEL indice A le 25/09 The company reserves the right to change specifications without notice. APEM www.apem.com 1 FD series Double icon illuminated pushbuttons - bushing Ø 24 or 26 mm - momentary or latching Overview FD Actuator SERIES Models A B P Terminals Electrical function Round, flat 1 3 1 Solder lugs OFF - ON Normally open (NO) Threaded bushing, dia. 24 mm Snap-in, dia. 26 mm LED control and No of poles C Independent LED, 1 pole D Independent LED, 2 poles F LED linked to actuator, green if switch in ON position, single pole G LED linked to actuator, red if switch in ON position, single pole F and G for OFF - ON models only. Contact material 2 4 Silver Silver, gold plated Actuator color 8 Smoke black Bezel color 2 Black LED colors F Red/green 0 1 2 LED resistor Symbols No resistor supplied 12V resistor 24V resistor See end of series ABOUT THIS SERIES On the following pages, you will find successively : model structure of switches and options in the same order as in above chart Dimensions : first dimensions are in mm while inches are shown as bracketed numbers. NOTICE : please note that not all combinations of above numbers are available. Refer to the following pages for further information. Mounting accessories : Standard hardware supplied : 1 hex nut (threaded bushing version) and 1 panel gasket Packaging unit : 20 pieces 2 www.apem.com APEM FD series Double icon illuminated pushbuttons - bushing Ø 24 or 26 mm - momentary or latching • Solder lugs • Flat actuator To order a product, replace • with one of the codes selected under “LED control and number of poles” below, then add the desired options. MODEL STRUCTURE ➞ Flat Mounting by threaded bushing - Ø 24 mm LATCHING OFF FDAP1•1 ON MOMENTARY (NO) FDAP3•1 ➞ Flat Snap-in mounting - Ø 26 mm LATCHING OFF FDBP1•1 ON MOMENTARY (NO) FDBP3•1 LED CONTROL AND NUMBER OF POLES Complete the model numbers above with one of the following codes. Function 1 (latching) Independent LED single pole C Independent LED double pole D APEM Function 3 (momentary) Function 1 (latching) Green LED in ON position single pole F Red LED in ON position single pole dotted line = jumper to be wired by the user. LED- has to be wired to one pin of pole 2. G www.apem.com 3 FD series Double icon illuminated pushbuttons - bushing Ø 24 or 26 mm - momentary or latching Options CONTACT MATERIALS 2 4 Silver Silver, gold plated ACTUATOR COLOR 8 Smoke black BEZEL COLOR 2 Black LED COLOR F Red/green LED RESISTOR 0 1 2 No resistor supplied 12V resistor 24V resistor SYMBOLS 3 5 4 ➞ Flat ON (green) / OFF ( red) with ring ➞ I (green) / O ( red) with ring www.apem.com FD1506-A 4 START (green) / STOP (red) with ring APEM