Hamamatsu C9548 High-speed gated image intensifier unit Datasheet

AR
Y
MI N
PR
ELI
HIGH-SPEED GATED
IMAGE INTENSIFIER UNITS
C9548 SERIES
OVERVIEW
Image intensifiers (I. I.) are devices capable of intensifying an image at high gain and high-speed gating (electronic shutter operation). This allows them to capture "instantaneous images" of ultrafast phenomena that occur in extremely short periods of time.
The C9548 series is an image intensifier unit which is suitable for
PIV application. It has a built-in pulse generator to allow multi-exposure (burst) operation.
The GaAsP photocathode is ideal for low-light-level imaging in the
visible region such as for fluorescence observations. The multialkali
photocathode on the other hand offers high sensitivity over a wider
spectral response range from the UV through near IR region so
observations can be made at various wavelengths.
By using a relay lens, the C9548 series can be easily connected to
various CCD cameras or high-speed cameras. The image intensifier gain, gate width and delay time can be controlled and set from a
PC through the RS-232C interface. (The image intensifier gain can
also be controlled and set from the remote controller.)
FEATURES
●Maximum Repetition Frequency: 200 kHz
●Built-in Pulse Generator
●Multi-exposure
●High-speed Gating: 10 ns minimum
●High Performance Image Intensifier
High quantum efficiency in visible range:
GaAsP photocathode type
Wide spectral response range from UV to near IR:
Multialkali photocathode type
APPLICATIONS
●Analysis of High-speed Phenomenon
PIV / Engine combustion state
Plasma emission / Discharge / Flow / Spray and so on.
SPECIFICATIONS
Parameter
Luminous Sensitivity (Typ.)
Photocathode
Radiant Sensitivity A (Typ.)
Sensitivity
Quantum Efficiency A (Typ.)
Effective Diameter
Window Material
Photocathode Material
Photocathode
Spectral Response
Peak Wavelength
Input Mount (Lens Mount)
Window Material
Phosphor
Phosphor Material
Screen
Decay Time
Luminous Gain (Typ.)
Gain
Radiant Emittance Gain A (Typ.)
Equivalent BackLuminous (Typ.)
ground Input (EBI) C Radiant A (Typ.)
Limiting Resolution (Typ.)
Image Magnification
Maximum Input
Luminous (Typ.)
Light Level D
Radiant A (Typ.)
Average of Max. Phosphor Screen Brightness
Power Requirement
Power Consumption (Max.)
Operating Ambient Temperature
Storage Temperature
Operating and Storage Humidity E
C9548-01
C9548-02
C9548-03
230
53
15
700
192
45
C9548-04
150
47
14
25 B
Borosilicate glass
Synthetic silica
GaAsP
Multialkali
280 to 720
185 to 900
530
430
F-mount (C-mount selectable)
FOP
P46 (P24 or P43 selectable)
See [Phosphor Screen Decay Characteristics]
3.3 × 103
1.0 × 106
6.6 × 103
1.5 × 106
4.2 × 103
1.0 × 106
2.0 × 103
7.0 × 105
8 × 10-12
1 × 10-11
2 × 10-15
3 × 10-14
50
36
57
32
1
1.5 × 10-3
7.0 × 10-6
5.0 × 10-3
1.6 × 10-5
4.0 × 10-10
1.6 × 10-12
8.0 × 10-10
2.4 × 10-12
10
100 to 240
12
15.6
12
15.6
0 to +40
-20 to +50
Below 70
Unit
µA/lm
mA/W
%
mm
—
—
nm
—
—
—
—
(lm/m2)/lx
(W/m2)/(W/m2)
lm/cm2
W/cm2
Lp/mm
—
lx
W/cm2
cd/m2
V
W
°C
%
NOTE: AAt wavelength of peak sensitivity
BEffective output area is 16 mm × 16 mm. Take the effective area of the camera and reduction rate of the relay lens to be used into account.
CInput illuminance (or irradiance) required to produce a luminous emittance from the phosphor screen, which is equal to that obtained when no
light is indent on the photocathode. This indicates the lower limit of detectable illuminance (or irradiance) level of an image intensifier.
DDuring normal (continuous) mode at maximum gain
ENo condensation
Protection Circuit
Reset
NOTE: *The LED on near of head can be turned out by control software.
Gate Specifications
Parameter
Operation Mode
Single
Gate
Mode
Gate time *
Repetition Frequency (Max.)
Delay Time *
Pulse Interval * (Min.)
Burst
Number of Exposures (Max.)
Gate
Exposure Time * (Min.)
Mode
Repetition Cycle (Min.)
Gate Trigger Level
Input
Input Impedance
Gate
Basic Delay Time
Output Gate Jitter (Max.)
Gate
Output Level
Time
Pulse Width
Monitor Output Impedance
NOTE: * Setting resolution is 10 ns.
C9548 Series
Normal (continuous) mode /
Single gate mode / Burst gate mode
10 ns to 9.99 ms
200 kHz (protection circuit incorporated)
10 ns to 9.99 ms
500 ns
16
10 ns
100 µs
TTL positive logic
1 kΩ
92 ns ± 2 ns
2 ns (10 ns maximum when gate time is set to 10 µs or more)
2 V positive logic
Gate time width (FWHM)
200 Ω
TIME SEQUENCE
DELAY TIME: 92 ns ± 2 ns
GATE
TRIGGER
INPUT
0
GATE TRIGGER
INPUT PULSE
WIDTH (50 ns Min.)
to 1.5 V
Excessive
Warning
Light
Protection
Shut off
C9548 Series
200 kHz
Red LED is lit continuously *
Shuts off operation during excessive light
Red LED flashes *
(on rear of head and remote controller operation panel)
Red LED is lit continuously *
(on rear of head and remote controller operation panel)
Reset switch on the remote controller
or sending command via RS-232C interface
GATE TIME (FWHM)
2 V (at 50 Ω)
Parameter
Repetition Max.
Rate
Display
MORE THAN
2V
Protective Functions
GATE
TIME
MONITOR
PULSE
0
GATE
PULSE
OFF
32 ns±2 ns
OFF
GATE TIME
10 ns to 9.99 ms
MULTI-EXPOSURE COUNT: 16 (Max.)
GATE
PULSE
EXPOSURE TIME: 10 ns (Min.)
PULSE INTERVAL: 500 ns (Min.)
REPETITION CYCLE: 100 µs (Min.)
TAPPC0144EA
CHARACTERISTICS
●Typical Spectral Response
●Typical Phosphor Screen Spectral Emission
100
●Typical Phosphor Screen Decay Characteristics
TAPPB0080EB
102
TAPPB0081EB
C9548-01/-02
GaAsP
PHOTOCATHODE
P43
102
101
80
RELATIVE INTENSITY (%)
C9548-03/-04
MULTIALKALI
PHOTOCATHODE
RELATIVE INTENSITY (%)
CATHODE RADIANT SENSITIVITY (mA/W)
QUANTUM EFFICIENCY (%)
TAPPB0093EA
103
P24
60
P43
40
P46
20
P24
101
P46
100 ns
100
10 µs
100 ns
100 ns
1 ms
1 ms
INPUT LIGHT
PULSE WIDTH
100
0
350
400
450
500
550
600
650
10-1
700
10-8
10-7
10-6
10-5
10-4
10-3
10-2
DECAY TIME (s)
WAVELENGTH (nm)
CATHODE RADIANT SENSITIVITY
QUANTUM EFFICIENCY
1 ms
10-1
100 200 300 400 500 600 700 800 900 1000
WAVELENGTH (nm)
DIMENSIONAL OUTLINES (Unit: mm)
●Head (F-mount Type)
●Remote Controller
80
CONNECTION CABLE
TO HEAD
(27)
33.3
80
OUTPUT
WINDOW
4-M3
2000
67
48
0.5
F-MOUNT
41
REAR VIEW
159
GAIN
ADJUSTMENT KNOB
GATE TIME MONITOR
OUTPUT (BNC)
POWER/PROTECTION
DISPLAY LED
77
POWER/PROTECTION
DISPLAY LED
RESET SWITCH
1
AC ADAPTER
CONNECTOR
90
REAR VIEW
50
30
GATE TRIGGER
INPUT (BNC)
SIDE VIEW
111
POWER SWITCH
OPERATION SWITCH
(ON / OFF)
RS-232C CONNECTOR
CONNECTOR (AUX) FOR
REMOTE CONTROLLER
REMOTE CONTROLLER
1/4"-20UNC
70
29
TOP VIEW
SIDE VIEW
50
30
(Weight: Approx. 300 g)
TAPPA0086EA
●Relay Lens Adapter A9549 (Sold Separately)
(Weight: Approx. 1.1 Kg)
45
4-M3 D8
24
BOTTOM VIEW
4- 3.2 COUNTERSINKING
3
2
TAPPA0085EA
67
41
40
M59 P=1
R
R6
80
REAR VIEW
SIDE VIEW
TAPPA0087EA
SETUP EXAMPLE WITH OPTICAL ACCESSORIES
2: 1 RELAY LENS
A2098
DIGITAL CCD CAMERA
C9548 SERIES
3: 2 RELAY LENS
A5309
C-MOUNT B
OBJECTIVE LENS
WITH C-MOUNT
F-MOUNT B
F-MOUNT LENS
HIGH-SPEED CAMERA A
1: 1 RELAY LENS
A4539
RELAY LENS
ADAPTER A9549
STROBE PULSE
... C9548 SERIES
OSCILLOSCOPE
AC ADAPTER
REMOTE CONTROLLER
REMOTE CONTROLLER
... ACCESSORIES
(SOLD SEPARATELY)
HEAD
AC CABLE
AC100 V to 240 V
CD-ROM
CONTROL
SOFTWARE
RS-232C CABLE 5 m
PC
(RS-232C)
NOTE: AConnection to a high-speed camera may not be possible depending on the readout frame rate. Always consult us before placing an order.
BSelect C-mount or F-mount at ordering.
TAPPC0145EB
Subject to local technical requirements and regulations, availability of products included in this promotional material may vary. Please consult with our sales office.
Information furnished by HAMAMATSU is believed to be reliable. However, no responsibility is assumed for possible inaccuracies or omissions. Specifications are
subject to change without notice. No patent rights are granted to any of the circuits described herein. ©2006 Hamamatsu Photonics K.K.
WEB SITE www.hamamatsu.com
HAMAMATSU PHOTONICS K.K., Electron Tube Division
314-5, Shimokanzo, Iwata City, Shizuoka Pref., 438-0193, Japan, Telephone: (81)539/62-5248, Fax: (81)539/62-2205
U.S.A.: Hamamatsu Corporation: 360 Foothill Road, P. O. Box 6910, Bridgewater. N.J. 08807-0910, U.S.A., Telephone: (1)908-231-0960, Fax: (1)908-231-1218 E-mail: [email protected]
Germany: Hamamatsu Photonics Deutschland GmbH: Arzbergerstr. 10, D-82211 Herrsching am Ammersee, Germany, Telephone: (49)8152-375-0, Fax: (49)8152-2658 E-mail: [email protected]
France: Hamamatsu Photonics France S.A.R.L.: 19, Rue du Saule Trapu, Parc du Moulin de Massy, 91882 Massy Cedex, France, Telephone: (33)1 69 53 71 00, Fax: (33)1 69 53 71 10 E-mail: [email protected]
United Kingdom: Hamamatsu Photonics UK Limited: 2 Howard Court, 10 Tewin Road Welwyn Garden City Hertfordshire AL7 1BW, United Kingdom, Telephone: 44-(0)1707-294888, Fax: 44(0)1707-325777 E-mail: [email protected]
North Europe: Hamamatsu Photonics Norden AB: Smidesvägen 12, SE-171-41 SOLNA, Sweden, Telephone: (46)8-509-031-00, Fax: (46)8-509-031-01 E-mail: [email protected]
TAPP1060E01
Italy: Hamamatsu Photonics Italia: S.R.L.: Strada della Moia, 1/E, 20020 Arese, (Milano), Italy, Telephone: (39)02-935 81 733, Fax: (39)02-935 81 741 E-mail: [email protected]
SEPT. 2006 IP
Similar pages