Wall DTAM-165A-1Y48H Up to 165 watts, medical ac - dc desktop power supply Datasheet

DTAM165 SERIES
Up to 165 Watts, Medical AC/DC Desktop Power Supplies
Rev A
Wall Industries, Inc.
FEATURES
• RoHS Compliant
• No Load Power Consumption < 500mW
• PF > 0.9 at 230VAC
• Single Outputs Ranging from 12VDC to 48VDC
• Up to 165 Watts Output Power
• Over Voltage, Over Load, and Short Circuit Protection
• 90~264 VAC Input Voltage Range
• CSA-C22.2 601.1-M90, NEMKO EN60601-1, & CB IEC60601-1
• High Efficiency up to 87%
Size:
6.69 x 3.35 x 1.73 inches
170.0 x 85.0 x 44.0 mm
3rd Edition Medical Approvals
• MTBF > 100,000 Hours
• Fully Meets CEC, ERP, EISA Efficiency Level V Requirements
• IEC-320-C14 AC Inlet
• 100% Burn-in and Hi-pot Tested
DESCRIPTION
The DTAM165 series of medical AC/DC desktop power supplies provides up to 165 Watts of output
power in a 6.69” x 3.35” x 1.73” package. This series consists of 12V, 15V, 19V, 24V, 28V, 36V, and 48VDC
single output models with a 90-264VAC wide input range and an IEC-320-C14 AC inlet connector. This
series also feature a high efficiency up to 87% and a power factor > 0.9 at 230VAC. These supplies are
also protected against short circuit, over voltage, and over load conditions. The DTAM165 series has CSAC22.2 NO.601.1-M90, Nemko EN60601-1, and CB IEC60601-1 3rd edition medical approvals. This series is
also CE marked and meets EN55011 Class B, FCC Part 18 Class B, and EN60601-1-2 EMC standards.
MODEL SELECTION TABLE
Model Number
Input Voltage Range
Output Voltage
Output Current
Ripple & Noise
Output Regulation
Output Power
DTAM-160A-1Y12H
12 VDC
13.33A
120mVp-p
±5%
160W
DTAM-160A-1Y15H
15 VDC
10.67A
150mVp-p
±5%
160W
DTAM-160A-1Y19H
19 VDC
8.42A
190mVp-p
±5%
160W
24 VDC
6.88A
240mVp-p
±3%
165W
DTAM-165A-1Y28H
28 VDC
5.89A
280mVp-p
±3%
165W
DTAM-165A-1Y36H
36 VDC
4.58A
360mVp-p
±3%
165W
DTAM-165A-1Y48H
48 VDC
3.44A
480mVp-p
±3%
165W
90 - 264 VAC
DTAM-165A-1Y24H
DERATING CURVE
Output Power (%)
120
Convection Cooling:
100
0 to +60°C derating linearly 2.5% per °C from +41°C to +60°C
80
60
40
20
0
0
10
20
30
40
50
60
70
Ambient Temperature (°C)
08/14/2013
Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797
website: www.wallindustries.com • e-mail: [email protected]
Page 1 of 3
Rev A
Wall Industries, Inc.
DTAM165 SERIES
Up to 165 Watts, Medical AC/DC Desktop Power Supplies
TECHNICAL SPECIFICATIONS: DTAM165 SERIES
All specifications are based on 25°C, Nominal Input Voltage, and Maximum Output Current unless otherwise noted.
We reserve the right to change specifications based on technological advances.
SPECIFICATION
TEST CONDITIONS
Min
Typ
Max
Unit
INPUT SPECIFICATIONS
Input Voltage Range
90
264
VAC
Input Frequency
47
63
Hz
Input Current (rms)
Inrush Current
90VAC
2.5
264VAC
1.0
115VAC, cold start, 25°C
65
115VAC, cold start, 25°C
130
No Load Power Consumption
Power Factor Correction
A
Apeak
500
115VAC and full load
0.95
230VAV and full load
0.90
mW
OUTPUT SPECIFICATIONS
Output Voltage
See Table
Output Regulation
See Table
Output Power
See Table
Output Current
See Table
Minimum Load
0
Ripple & Noise
Measured at 20MHz limited bandwidth and with 0.1μF ceramic
and 10μF electrolytic capacitors in parallel across the output
Hold-up Time
115VAC and full load
%
1.0
%
10
ms
PROTECTION
Over Voltage Protection
Over Load Protection
Shutdown and latch off, AC recycle
Automatic recovery
Automatic recovery
Short Circuit Protection
Automatic recovery
GENERAL SPECIFICATIONS
Efficiency
115/230VAC and average load
87
%
ENVIRONMENTAL SPECIFICATIONS
Operating Temperature
Derating linearly 2.5% per °C from +41°C to +60°C
Storage Temperature Range
Humidity
Non-condensing
0
+60
°C
-10
+80
°C
0
90
%
Cooling
Free air convection
MTBF
Full load, 25°C ambient temperature
100,000
hours
PHYSICAL SPECIFICATIONS
Weight
1.73 lbs (790g)
Dimensions (L x W x H)
AC Inlet
Output Connector
6.69 x 3.35 x 1.73 in (170.0 x 85.0 x 44.0 mm)
IEC-320-C14
Several options available
SAFETY & EMC
Safety Approvals
EMC Standards
08/14/2013
CSA C22.2 601.1-M90: 3rd edition, NEMKO EN60601-1: 3rd edition, CB IEC60601-1: 3rd edition
EN60601-1-2, EN55011 Class B, FCC Part 18 Class B, CE
Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797
website: www.wallindustries.com • e-mail: [email protected]
Page 2 of 3
Rev A
Wall Industries, Inc.
DTAM165 SERIES
Up to 165 Watts, Medical AC/DC Desktop Power Supplies
MECHANICAL DRAWING
Top View
6.69 (170.0)
Rear View
3.35 (85.0)
DC Output Cable
Front View
Side View
1.73 (44.0)
4X Rubber Foot
Label Area
Bottom View
0.08 (2.0)
NOTES
1. Unit: inches (mm)
2. AC Inlet: IEC-320-C14
3. Plastic Case Color: Black
4. Tolerance: ±0.5mm
5. Several output connector options available
6. All dimensions are for reference only
Standard output cable: AWM 2464 #16 AWG / 3C + SHIELDING, UL 80°C 300V VW-1, 1050mm
COMPANY INFORMATION
Wall Industries, Inc. has created custom and modified units for over 50 years. Our in-house research and development engineers will
provide a solution that exceeds your performance requirements on-time and on budget. Our ISO9001-2008 certification is just one
example of our commitment to producing a high quality, well-documented product for our customers.
Our past projects demonstrate our commitment to you, our customer. Wall Industries, Inc. has a reputation for working closely with its
customers to ensure each solution meets or exceeds form, fit and function requirements. We will continue to provide ongoing
support for your project above and beyond the design and production phases. Give us a call today to discuss your future projects.
Contact Wall Industries for further information:
Phone: (603)778-2300
E-mail: [email protected]
08/14/2013
Toll Free: (888)597-9255
Web: www.wallindustries.com
Fax: (603)778-9797
Address: 37 Industrial Drive, Exeter, NH 03833
Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797
website: www.wallindustries.com • e-mail: [email protected]
Page 3 of 3
Similar pages