UTC-IC US3X77XG-SM1-T

UNISONIC TECHNOLOGIES CO., LTD
US3X77
CMOS IC
POWER DISTRIBUTION SWITCH
„
DESCRIPTION
The UTC US3X77 is a power distribution switch and particularly
designed for self-powered and bus-powered Universal Serial Bus
(USB) applications.
The UTC US3X77 incorporates protection circuits including
current limiting circuit with foldback function, thermal shutdown circuit
designed to prevent catastrophic switch failure due to increasing
power dissipation when continuous heavy loads or short circuit
occurs. Besides, a built-in charge pump is used to drive the
N-channel MOSFET that is free of parasitic body diode to eliminate
any reversed current flow across the switch when it is powered off.
The RDS(ON) of the MOSFET switch is as low as 100mΩ. OC is
open-drain output report over-current or over-temperature event
which has deglitch typical 9ms timeout period typically 9ms.
The UTC US3X77 is applied in high-side power protection
switch, USB power management, USB host and self-powered bubs,
USB bus-powered hubs, hot plug-in power supplies, battery-charger
circuits.
„
FEATURES
* 100mΩ High-Side MOSFET
* Supply Current:
Switch on : 65μA(Typ)
Switch off : 1μA (Max)
* Accurate Current Limit with Foldback
* Deglitched Open-Drain Over-Current Flag Output (OC)
* No Reverse Current when Power Off
* Under voltage Lockout
* Operating Range:2.7V ~ 5.5V
* Output Shutdown Pull-low Resistor
„
ORDERING INFORMATION
Ordering Number
Lead Free
Halogen Free
US3X77XL-S08-R
US3X77XG-S08-R
US3X77XL-S08-T
US3X77XG-S08-T
Package
Packing
SOP-8
SOP-8
Tape Reel
Tube
US3X77XL-SM1-R
US3X77XG-SM1-R
MSOP-8
Tape Reel
US3X77XL-SM1-T
US3X77XG-SM1-T
MSOP-8
Tube
www.unisonic.com.tw
Copyright © 2011 Unisonic Technologies Co., Ltd
1 of 10
QW-R502-568.B
US3X77
„
CMOS IC
PIN CONFIGURATION
1
8
OUT
IN 2
7
OUT
IN 3
6
NC
EN(EN) 4
5
OC
GND
„
PIN DESCRIPTION
PIN NO.
1
PIN NAME
GND
2, 3
IN
4
5
6
EN(EN)
OC
NC
7, 8
OUT
DESCRIPTION
Ground
Input Supply: Output MOSFET Drain, which also supplies IC's internal circuitry.
Connect to positive supply.
Enable: Logic level enable input. Make sure EN pin never floating.
Over-Current: Open-Drain OC output.
No connection.
Switch Output: Output MOSFET Source of switch. Typically connect to switched side of
load.
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
2 of 10
QW-R502-568.B
US3X77
„
CMOS IC
BLOCK DIAGRAM
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
3 of 10
QW-R502-568.B
US3X77
„
CMOS IC
ABSOLUTE MAXIMUM RATING (TA = 25°C, unless otherwise specified)
PARAMETER
SYMBOL
RATINGS
UNIT
Supply Voltage
VIN
6
V
Output Voltage
VOUT
6
V
Enable Input
VEN
-0.3 ~ 6
V
Output Current
IOUT
Internally Limited
A
Storage Temperature
TSTG
-65~ +150
℃
Reflow Temperature (Soldering, 10sec)
260
℃
ESD Protection
2
kV
Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged.
Absolute maximum ratings are stress ratings only and functional device operation is not implied.
„
OPERATING RATINGS
PARAMETER
Supply Voltage
Operating Temperature
„
SYMBOL
VIN
TA
RATINGS
+3 ~ +5.5
-40 ~ +85
UNIT
V
°C
ELECTRICAL CHARACTERISTICS
(VIN = 5V, CIN=1µF, COUT=1µF, RL=10Ω, TA = 25°C, unless otherwise specified)
PARAMETER
SYMBOL
TEST CONDITIONS
Input Voltage
VIN
US3477, IOUT=1.5A
US3377, IOUT=1.0A
Output MOS RDS(ON)
US3277, IOUT=0.5A
US3177, IOUT=0.3A
Supply Current
IIN
Output Turn-on Rising Time
RL=10Ω, 90% Settling
US3477
US3377
Current Limit Threshold
ITHD(LIMIT)
VOUT=4V
US3277
US3177
US3477
VOUT=0V,
US3377
Short-Circuit Current
ISC
2.7V<VIN<5.5V
US3277
US3177
EN Input Threshold
Shutdown Supply Current
Shutdown Pull Low Resistance
Output Leakage Current
VIN Under Voltage Lockout
VIN Under Voltage Hysteresis
Thermal Limit
Thermal Limit Hysteresis
OC Deglitch
OC Output Low Voltage
OC Off-State Current
MIN
2.7
2
1.6
1.2
0.75
0.2
0.2
0.2
0.2
1
ISHDN
IO(LEAK)
EN=”0”, VOUT=0V
2.2
OC assertion or deassertion
IOC= 5mA
VOC = 5V
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
4
TYP
MAX UNIT
5.5
V
100
115
65
400
2.5
2
1.5
1
1.7
1.3
1
0.7
1.6
0.1
75
0.5
2.5
200
135
20
9
mΩ
µA
µs
3.3
2.6
1.9
1.45
2.3
1.7
1.3
0.9
1.8
1
150
1
2.7
15
0.4
1
A
A
V
µA
Ω
µA
V
mV
℃
℃
ms
V
µA
4 of 10
QW-R502-568.B
US3X77
„
CMOS IC
FUNCTIONAL DESCRIPTION
OVERCURRENT PROTECTION
When the output load exceeds the current-limit threshold, The Over Current Protection will be triggered. The
typical current limit value of UTC US3077/US3277/US3377/US3477 is 1A, 1.5A, 2A, 2.5A. There is foldback of
current limit when short-circuit being encountered.
OC RESPONSE
The OC open-drain output is asserted (active low) when an over current or over-temperature shutdown condition
is encountered after a 9-ms deglitch timeout. The output remains asserted until the over-current or over-temperature
condition is removed.
THERMAL SHUTDOWN
Thermal shutdown protects UTC US3X77 from excessive power dissipation. If the die temperature exceeds 135°C,
the MOSFET switch is shut off. 20°C of hysteresis prevents the switch from turning on until the die temperature
drops to 115°C. Thermal shutdown circuit functions only when the switch is enabled.
UNDERVOLTAGE LOCKOUT (UVLO)
UVLO (under-voltage lockout) prevents the output MOSFET from turning on until IN (input voltage) exceeds 2.5V
typically. After the switch turns on, if the voltage drops below 2.3V typically, UVLO shuts off the output MOSFET.
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
5 of 10
QW-R502-568.B
US3X77
„
CMOS IC
TEST CIRCUITS
RFG
VIN
IN
OC
UTC
US3X77
CI
Chip
Enable
OUT
EN
GND
VFLG
S1
A
IOUT
VOUT
CO
RL
IL
Turn-On & Off Response, Flag Response
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
6 of 10
QW-R502-568.B
US3X77
„
CMOS IC
TYPICAL APPLICATION CIRCUIT
Pull-Up Resistor (10K ~ 100K)
RFG
Supply Voltage 5V
10K
IN
OC
USB
Controller
Over Current
0.1µF
UTC
US3X77
1µF
Chip Enable
Flag Transient Filtering
EN
VBUS
D+
DGND
OUT
GND
0.1µF
150µF
Ferrite Beades
Data
Note. A low-ESR 150μF aluminum electrolytic or tantalum between VOUT and GND is strongly recommended to meet
the 330mV maximum droop requirement in the hub VBUS.
POWER SUPPLY CONSIDERATIONS
A 1μF bypass capacitor on IN pins, a high value capacitor and a 0.1uF bypass capacitor on OUT pins, are
strongly recommended, because this precaution can reduce a poor risk that an output short may cause
sufficient ringing on the input to damage internal control circuitry.
Input transients must not exceed the absolute maximum supply voltage (6V) even for a short duration.
ENABLE INPUT
EN must be driven logic high or logic low for a clearly defined input. Floating the input may cause unpredictable
operation. EN should not be allowed to go negative with respect to GND.
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
7 of 10
QW-R502-568.B
US3X77
CMOS IC
„
TYPICAL CHARACTERISTICS
(TA=25°C, VIN= 5V, 3275H, CIN=1μF, COUT=1μF, VEN=0V, unless otherwise specified.)
Turn on delay time and rise time
Turn off delay time and fall time
8V
8V
VIN=5V
CL=120μF
6V
6V
RL=5Ω
4V
4V
2V
2V
0
0
10V
10V
5V
5V
VIN=5V
CL=120μF
RL=5Ω
0
0
VOC
1A
IOUT
0.5A
0
0
5V
5V
0
VIN=5V
RL=5Ω
2000
5V
VOC
VOC
2000
4000
Thermal Shutdown Response
10V
VIN=5V
CL=47μF
RL=1Ω
CL=220μF
VOUT
1A
0.5A
IOUT
IOUT
VIN=5V
RL=5Ω
Time (400μs/div)
Inrush Current With Different Load Capacitance
0
5V
0
VEN
VEN
0
0
4000
Time (400μs/div)
0
CL=120μF
1A
0.5A
0
10
Inrush Current With Different
Load Capacitance
0
CL=10μF
5
Time (1ms/div)
5V
VEN
VOC
0
10V
5V
0
IOUT
4000
Inrush Current With Different
Load Capacitance
10V
VEN
2000
Time (400μs/div)
0
VIN=5V
RL=5Ω
0
5
10
Time (1ms/div)
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
8 of 10
QW-R502-568.B
US3X77
CMOS IC
TYPICAL CHARACTERISTICS (Cont.)
VOUT
VIN
VIN
VOUT
„
Short-circuit current, device
enable into short
Short circuit response at start up
CL=47μF
IOUT
2A
0
1A
10V
0
5V
VOC
IOUT
2A
5V
5V
VEN
0
VIN
10V
0
0
500
VIN=5V
CIN=47μF
CL=47μF
0
0
1000
2000
4000
Time (400ms/div)
IOUT
IOUT
VOUT
VIN VOC
VIN
VOUT
Time (100ms/div)
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
9 of 10
QW-R502-568.B
US3X77
CMOS IC
TYPICAL CHARACTERISTICS (Cont.)
IOUT
VIN VOC
VOUT
„
UTC assumes no responsibility for equipment failures that result from using products at values that
exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or
other parameters) listed in products specifications of any and all UTC products described or contained
herein. UTC products are not designed for use in life support appliances, devices or systems where
malfunction of these products can be reasonably expected to result in personal injury. Reproduction in
whole or in part is prohibited without the prior written consent of the copyright owner. The information
presented in this document does not form part of any quotation or contract, is believed to be accurate
and reliable and may be changed without notice.
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
10 of 10
QW-R502-568.B