1.0 Amp SURFACE MOUNT PLASTIC SILICON DIODES Data Sheet Mechanical Dimensions SMA11 . . . 110 Series Description DO-214AC (SMA) Features n LOW COST n LOW FORWARD VOLTAGE WITH LOW LEAKAGE CURRENT n HIGH CURRENT CAPABILITY n MEETS UL SPECIFICATION 94V-0 n HIGH SURGE CAPABILITY SMA11 . . . 110 Series Units SMA11 SMA12 SMA14 SMA16 SMA18 SMA110 Peak Repetitive Reverse Voltage...VRRM 100 200 400 600 800 1000 Volts RMS Reverse Voltage...VR(rms) 70 140 280 420 560 700 Volts DC Blocking Voltage...VDC 100 200 400 600 800 1000 Volts Average Forward Rectified Current...IF(av) ............................................. 1.0 ............................................... Amps Non-Repetitive Peak Forward Surge Current...IFSM ............................................. 3 0 ............................................... Amps Operating & Storage Temperature Range...TJ, TSTRG ......................................... -65 to 175 .......................................... °C Maximum Forward Voltage @ 1.0A...VF ............................................. 1.1 ............................................... Volts Maximum Full Load Reverse Current...IR(av) ............................................. 3 0 ............................................... µAmps Maximum Ratings Electrical Characteristics Maximum DC Reverse Current...IR @ Rated DC Blocking Voltage TC = 25°C TC = 75°C Typical Junction Capacitance...CJ (Note 1) Page 10-24 ............................................. 5.0 ............................................... µAmps ............................................. 5 0 ............................................... µAmps ............................................. 3 0 ............................................... pF SMA11 . . . 110 Series 1.0 Amp SURFACE MOUNT PLASTIC SILICON DIODES Data Sheet Junction Capacitance (pF) Typical Junction Capacitance Forward Current Derating Curve Non-Repetitive Peak Forward Surge Current Average Forward Current (A) Peak Fprward Surge Current (A) Reverse Voltage (V) Lead Temperature (°°C) Number of Cycles @ 60 Hz Typical Instantaneous Forward Characteristics Amps Recommended Soldering Pad Layout Ratings at 25 Deg. C ambient temperature unless otherwise specified. Single Phase Half Wave, 60 Hz Resistive or Inductive Load. Forward Voltage (V) NOTES: 1. Measured @ 1 MHz and applied reverse voltage of 4.0V. For Capacitive Load, Derate Current by 20%. Page 10-25