TOSHIBA TLP706F

TLP706F
TOSHIBA PHOTOCOUPLER
GaAℓAs IRED & PHOTO-IC
TLP706F
Intelligent power module signal isolation
Industrial inverters
Motor drive
Unit in mm
4.58±0.25
6 5 4
1.27±0.2
Buffer logic type ( totem pole output )
z
Pb Free
z
Guaranteed performance over temperature : −40~100°C
z
Power supply voltage : 4.5~20 V
z
Input current: IFHL = 5 mA (max.)
z
Switching time ( tpLH / tpHL) : 600 ns (max.)
1
z
Common-mode transient immunity : ±10 kV/μs (min)
2
z
Isolation voltage : 5000 Vrms (min)
+0.25
3.9 −0.15
7.62±0.25
0.75±0.25
11.7±0.3
0.4±0.1
11-5J101
TOSHIBA
z
−0.05
1 2 3
0.25± +0.10
+0.15
3.65 −0.25
6.8±0.25
The Toshiba TLP706F consists of a GaAℓAs light-emitting diode and an
integrated high-gain, high-speed photodetector. The TLP706F is suitable for
isolating input control signals to intelligent power modules. This unit is a 6-pin
SDIP. The TLP706F is 50% smaller than the 8-PIN DIP and meets the
reinforced insulation class requirements of international safety standards.
Therefore the mounting area can be reduced in equipment requiring safety
standard certification.
The detector has a totem pole output stage to provide both source and sink
driving.The detector IC has an internal shield that provides a guaranteed
common-mode transient immunity of 10 kV/μs.
The TLP706F is buffer logic type. For inverter logic type, the TLP702F is in
line-up.
Absolute Maxmum ratings and electrical characteristics are the same as
The TLP706 technical data sheets.
11-5J101
Weight:0.26 g (t yp .)
Pin Configuration (Top View)
z
UL Recognized :UL1577, File No.E67349
z
Option (D4)
VCC
6
5
GND
3
SHIELD
1:ANODE
2:N.C.
3:CATHODE
4:GND
4
5:Vo
6:Vcc
TÜV Approved : DIN EN60747-5-2
No.R50033433
Maximum Operating Insulation Voltage : 1140VPK
Highest Permissible Over Voltage
Schematic
ICC
: 8000VPK
6
(Note) : When a EN60747-5-2 approved type is needed,
IF
Please designate “Option(D4)”
z
Creepage Distance
Clearance
Insulation Thickness
Tr1
1+
Construction Mechanical Rating
IO
VF
8.0 mm (min)
8.0 mm (min)
0.4 mm (min)
3-
Tr2
Truth Table
Input
H
L
LED
ON
OFF
Tr1
ON
OFF
Tr2
OFF
ON
5
4
SHIELD
Output
H
L
VCC
VO
GND
0.1 μF bypass capacitor must be
connected between pins 6 and 4. (Note 4)
1
2007-10-01
TLP706F
RESTRICTIONS ON PRODUCT USE
20070701-EN
• The information contained herein is subject to change without notice.
• TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor
devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical
stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of
safety in making a safe design for the entire system, and to avoid situations in which a malfunction or failure of
such TOSHIBA products could cause loss of human life, bodily injury or damage to property.
In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as
set forth in the most recent TOSHIBA products specifications. Also, please keep in mind the precautions and
conditions set forth in the “Handling Guide for Semiconductor Devices,” or “TOSHIBA Semiconductor Reliability
Handbook” etc.
• The TOSHIBA products listed in this document are intended for usage in general electronics applications
(computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances,
etc.).These TOSHIBA products are neither intended nor warranted for usage in equipment that requires
extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or
bodily injury (“Unintended Usage”). Unintended Usage include atomic energy control instruments, airplane or
spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments,
medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in his
document shall be made at the customer’s own risk.
• The products described in this document shall not be used or embedded to any downstream products of which
manufacture, use and/or sale are prohibited under any applicable laws and regulations.
• The information contained herein is presented only as a guide for the applications of our products. No
responsibility is assumed by TOSHIBA for any infringements of patents or other rights of the third parties which
may result from its use. No license is granted by implication or otherwise under any patents or other rights of
TOSHIBA or the third parties.
• GaAs(Gallium Arsenide) is used in this product. The dust or vapor is harmful to the human body. Do not break,
cut, crush or dissolve chemically.
• Please contact your sales representative for product-by-product details in this document regarding RoHS
compatibility. Please use these products in this document in compliance with all applicable laws and regulations
that regulate the inclusion or use of controlled substances. Toshiba assumes no liability for damage or losses
occurring as a result of noncompliance with applicable laws and regulations.
2
2007-10-01