GBJ2001 THRU GBJ2007 SINGLE PHASE 20.0 AMP BRIDGE RECTIFIERS VOLTAGE RANGE 50 to 1000 Volts CURRENT 20.0 Amperes GBJ FEATURES * Ideal for printed circuit board .134(3.4) .122(3.1) 1.193(30.3) 1.169(29.7) .203(5.2) .189(4.8) .150(3.8) .134(3.4) ~ ~ .165(4.2) .150(3.8) .094(2.4) .078(2.0) .043(1.1) .035(0.9) .441(11.2) .425(10.8) + * Mounting position: Any .800(20.3) .776(19.7) * Low leakage current .708(18.0) .669(17.0) .189 (4.8) * Low forward voltage .114(2.9) .098(2.5) .031(0.8) .023(0.6) .402(10.2) .303(7.7) .303(7.7) SPACING .386(9.8) .287(7.3) .287(7.3) Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Rating 25 C ambient temperature uniess otherwies specified. Single phase half wave, 60Hz, resistive or inductive load. For capacitive load, derate current by 20%. TYPE NUMBER GBJ2001 GBJ2002 GBJ2003 GBJ2004 GBJ2005 GBJ2006 GBJ2007 UNITS Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC Blocking Voltage Maximum Average Forward Current @Tc=100 C Peak Forward Surge Current, 8.3 ms single half sine-wave 50 35 50 100 70 100 200 140 200 400 280 400 600 420 600 800 560 800 1000 700 1000 V V V 20.0 A superimposed on rated load (JEDEC method) Maximum Forward Voltage Drop per Bridge Element at 10.0A D.C. Maximum DC Reverse Current Ta=25 C 240 1.05 10 A V A at Rated DC Blocking Voltage Typical Junction Capacitance (Note 1) Typical Thermal Resistance RqJC (Note 2) Operating Temperature Range, TJ Storage Temperature Range, TSTG 500 60 0.8 A PF C/W Ta=125 C -55 -55 +150 +150 NOTES: 1. Measured at 1.0MHz and applied reverse voltage of 4.0V DC. 2. Thermal Resistance from Junction to Case with device mounted on 300mm x 300mm x 1.6mm Cu Plate Heatsink. C C RATING AND CHARACTERISTIC CURVES (GBJ2001 THRU GBJ2007) FIG.2-MAXIMUM NON-REPETITIVE FORWARD SURGE CURRENT AVERAGE FORWARD CURRENT,(A) 25 20 15 Single Phase 10 Half Wave 60Hz Resistive Or Inductive Load 5 0 20 40 60 80 100 120 140 160 PEAK FORWARD SURGE CURRENT,(A) FIG.1-TYPICAL FORWARD CURRENT DERATING CURVE 250 240 200 150 Sine Wave JEDEC method 50 0 1 CASE TEMPERATURE,( C) 8.3ms Single Half Tj=25 C 100 50 10 5 100 FIG.3-TYPICAL FORWARD FIG.4-TYPICAL REVERSE CHARACTERISTICS CHARACTERISTICS 50 50 10 10 REVERSE LEAKAGE CURRENT, (mA) INSTANTANEOUS FORWARD CURRENT,(A) NUMBER OF CYCLES AT 60Hz 3.0 1.0 Tj=25 C Pulse Width 300us 1% Duty Cycle 0.1 3.0 Tj=100 C 1.0 0.1 Tj=25 C .01 0 .2 .4 .6 .8 1.0 FORWARD VOLTAGE,(V) 1.2 1.4 .01 0 20 40 60 80 100 120 140 PERCENT OF RATED PEAK REVERSE VOLTAGE, (%)