JGC0348 Page 1 of 2 The 0348 series is designed to mount to pads on the lower side of a PCB with the LED viewed through a hole. This has the benefit of maintaining all parts of the LED below the surface of the PCB, making it especially suitable for use with membrane overlays and applications where a smooth front surface is desired. Chip PART NO. JGC0348 Lens Color Material Emitted Color AlGaInP Super Yellow Green Water Clear * Specifications subject to change without notice. Dimensions are in mm±0.1 unless stated otherwise. IDEA, Inc., 1351 Titan Way, Brea, CA 92821 Ph:714-525-3302, 800-LED-IDEA; Fax: 714-525-3304 0507 JGC0348 Page 2 of 2 Absolute Maximum Ratings at Ta = 25 °C Parameter Symbol Rating Units IF 25 mA Operating Temperature Topr -40 to +85 °C Storage Temperature Tstg -40 to +90 °C Soldering Temperature Tsol 260 (for 5 seconds) °C Electrostatic Discharge ESD 2000 V Pd 60 mW IF (Peak) 60 mA VR 5 V Forward Current Power Dissipation Peak Forward Current (Duty 1/10 @ 1KHz) Reverse Voltage Electronic Optical Characteristics Parameter Symbol Min. Typ. Max. Units Condition IV 11 16 — mcd IF = 20 mA 2θ1/2 — 130 — deg IF = 20 mA Peak Wavelength λp — 575 — nm IF = 20 mA Dominant Wavelength λd — 573 — nm IF = 20 mA Spectrum Radiation Bandwidth ∆λ — 20 — nm IF = 20 mA Forward Voltage VF — 2.0 2.4 V IF = 20 mA Reverse Current IR — — 10 µA VR = 5 V Luminous Intensity Viewing Angle * Specifications subject to change without notice. Dimensions are in mm±0.1 unless stated otherwise. IDEA, Inc., 1351 Titan Way, Brea, CA 92821 Ph:714-525-3302, 800-LED-IDEA; Fax: 714-525-3304 0507