Tyco / Electronics Raychem Circuit Protection 308 Constitution Drive Menlo Park, Ca 94025-1164 Phone: 800-227-4856 FAX 800-227-4866 PRODUCT: TSM600-250-RA PolySwitch® PTC Devices DOCUMENT: SCD 24939 PCN: 644560 REV LETTER: B REV DATE: APRIL 16, 2002 PAGE NO.: 1 OF 1 Overcurrent Protection Device Specification Status: RELEASED Max Electrical Rating at 20°°C Operating Voltage: 250VDC Fault Voltage: 600VRMS Interrupt Current: 3ARMS Lead Material: Tin plated brass Configuration: Two PPTC devices per TSM600 part Case Material: Nylon Resin (UL94 V-0) 1000V dielectric rating Marking: Raychem Logo TSM600 Part Identification Lot Identification Terminal Description: T1 = Tip In T4 = Tip Out R2 = Ring In R3 = Ring Out TABLE I. DIMENSIONS: A B C D E F G MIN MAX MIN MAX MIN MAX MIN MAX MIN MAX MIN MAX MIN MAX mm: 17.0 17.6 11.2 11.7 10.4 11.2 4.8 5.2 2.5 2.8 0.6 1.0 2.0 3.1 in: (0.671) (0.691) (0.440) (0.460) (0.410) (0.440) (0.187) (0.203) (0.099) (0.111) (0.022) (0.038) (0.080) (0.122) TABLE II. PERFORMANCE RATINGS @ 20°°C (unless otherwise noted): R MIN R TYP R1 MAX* TYP MAX MIN MAX Tripped State Power Dissipation @ 250V (Watts) TYPICAL 1.0 3.0 5.0 1 6 -40 85 2 IHOLD (mA) 20°C 250 TIME TO TRIP @3A (Seconds) RESISTANCE (Ω)** @ 20° C 60°C 140 OPERATING TEMPERATURE (°C) * Maximum device resistance, measured 1-hour post reflow or post trip. ** Resistance per PPTC device. Additional Ratings @ 20°C Resistance Matched: Line Balance: 0.5 Ohm measured 24 hours after reflow installation 0.5 Ohm, 59 dB @ 4 kHz minimum*** Storage Temperature: -40° to 85° C Per IPC/JEDEC J-STD-020A Level 2a ***Tested in accordance with IEEE 455 with a device having a series longitudinal balance value of at least 60dB. Agency Recognition: Reference Documents: Precedence: Effectivity: Storage Humidity: UL, CSA PS300 This specification takes precedence over documents referenced herein. Reference documents shall be the issue in effect on the date of invitation for bid.