STEVAL-ISB009V1 Li-Ion battery monitoring and gas-gauge demonstration board based on the STC3100 Data brief Features ■ Accurate battery voltage measurement ■ Coulomb counter to keep track of the battery’s state-of-charge ■ Internal temperature sensor ■ Internal or external 32 kHz time base ■ I2C interface for battery monitoring and device control ■ 0.5 % battery voltage accuracy ■ 1 % Coulomb counter accuracy using an external RTC signal (3.5 % using the internal time base). ■ Low power consumption: 100 µA in operating conditions, 2 µA in stand-by mode ■ RoHS compliant STEVAL-ISB009V1 Description The STEVAL-ISB009V1 demonstration board, based on the STC3100, is able to monitor the critical parameters of a single-cell Li-Ion battery (voltage, temperature, and current) and includes hardware functions to implement a gas-gauge for battery charge monitoring, based on a programmable 12-bit to 14-bit A/D converter. The battery current can be up to 2.5 A and the accumulator system provides a capacity up to +/7000 mAh with a resolution of 0.2 mAh. The device is programmable through an I2C interface. November 2010 Doc ID 18142 Rev 1 For further information contact your local STMicroelectronics sales office. 1/4 www.st.com 4 Circuit schematic STEVAL-ISB009V1 1 Circuit schematic Figure 1. STEVAL-ISB009V1 demonstration board schematic # 04?2/3# 04?3$! 04?3#, 6). 2/3# 6## 3$! 3#, #' '.$ # & )/ 04?6## #' ! 04?#' 2CG + M 2OSC 0- 04?)/ 2 04?6). )# 34# 0?'.$ 04?'.$ !- 2/4 Doc ID 18142 Rev 1 STEVAL-ISB009V1 2 Revision history Revision history Table 1. Document revision history Date Revision 05-Nov-2010 1 Changes Initial release. Doc ID 18142 Rev 1 3/4 STEVAL-ISB009V1 Please Read Carefully: Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any time, without notice. All ST products are sold pursuant to ST’s terms and conditions of sale. Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no liability whatsoever relating to the choice, selection or use of the ST products and services described herein. No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such third party products or services or any intellectual property contained therein. UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT. UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY, DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK. Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any liability of ST. ST and the ST logo are trademarks or registered trademarks of ST in various countries. Information in this document supersedes and replaces all information previously supplied. The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners. © 2010 STMicroelectronics - All rights reserved STMicroelectronics group of companies Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan Malaysia - Malta - Morocco - Philippines - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America www.st.com 4/4 Doc ID 18142 Rev 1