Xeon 1 Power Blue LED OSB4XNE1E1E VER C.2 ■Features ■Outline ● Highest Luminous Flux ● Super energy efficiency ● Long Lifetime Operation ● Built-in Zener Diode For ESD Protection Dimension 3.6 BackView Anode ■Applications ● Read lights (car, bus, aircraft) ● Portable (flashlight, bicycle) ● Bollards / Security / Garden ● Traffic signaling / Beacons ● In door / Out door Commercial lights ● Automotive Ext ESD Protection Diode Unit:mm Tolerance:±0.30mm ■Absolute Maximum Rating Item ■Directivity (Ta=25℃) 25℃) (Ta= Symbol Value Unit DC Forward Current IF 400 mA Pulse Forward Current* IFP 500 mA Reverse Voltage VR 5 V Power Dissipation PD 1600 mW Operating Temperature Topr -30 ~ +85 Storage Temperature Tstg -40~ +100 Lead Soldering Temperature Tsol 260 DC Forward Voltage Symbol VF DC Reverse Current Domi. Wavelength 0 ℃ ℃ ℃/5sec - Duty ratio max 1/10 ■Electrical -Optical Characteristics Item 0 IR λD Luminous Flux Φv 50% Power Angle 2θ1/2 Condition IF=350mA VR=5V ■Forward Operating Current (DC) (Ta=25℃ (Ta=25℃) Min. 3.0 - Typ. 3.3 - Max. Unit 4.0 10 V µA IF=350mA 455 460 465 nm IF=350mA 15 20 - lm IF=350mA - 140 - deg 400 Forward Current, IF (mA) *Pulse width Max.10ms Cathode 350 300 250 ℃ ℃ ℃ ℃ 200 150 100 50 RJ-A=60 /W RJ-A=50 /W RJ-A=40 /W RJ-A=30 /W 0 0 25 50 75 100 125 ℃ Ambient Temperature, TA ( ) Note: Don’t drive at rated current more than 5s without heat sink for Xeon 1 emitter series. LED & Application Technologies http://www.optosupply.com 1/2 VER C.0 Xeon 1 Power Blue LED OSB4XNE1E1E VER C.2 ■ Soldering Heat Reliability : Reflow soldering Profile · Reflow soldering should not be done more than two times. · When soldering, do not put stress on the LEDs during heating. · After soldering, do not warp the circuit board. · Repairing should not be done after the LEDs have been soldered. When repairing is unavoidable, a double-head soldering iron should be used. It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing. Solder Average ramp-up rate = 3ºC/sec. max. Preheat temperature: 150º~180ºC Preheat time = 120 sec. max. Ramp-down rate = 6ºC/sec. max. Peak temperature = 220ºC max. Time within 3ºC of actual peak temperature = 25 sec. max. Duration above 200ºC is 40 sec. max. LED & Application Technologies http://www.optosupply.com 2/2 VER C.0