G1033-032, 1490 nm GPON Laser Diode Chip DATASHEET | SEPTEMBER 2015 EMCORE's G1033-032, 1490 nm GPON distributed feedback DFB laser chip is designed to provide the source laser for the uncooled PON applications. Applications • Uncooled PON Applications • FTTx Networks FIBER OPTICS Performance Highlights Parameter Wavelength Features Operating Temperature Range • Advanced Digital Chip Design Optical Output Power • Wide Operating Temperature Range: -40 to +85°C Side Mode Suppression Ratio (SMSR) • Telcordia Technologies™ 468 Compliant • RoHS Compliant Min Typical Max Units 1470 1490 1510 nm -40 +25 +85 °C - - 50 mW 30 40 - dB Absolute Maximum Ratings Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only and functional operation of the device at these or any other conditions beyond those indicated for extended periods of time may effect device reliability. Parameter Symbol Condition - Min Max Unit -40 +85 °C -40 +100 °C Operating Temperature Range Top Storage Temperature Range TSTG Optical Output Power Po Continuous - 50 mW Laser Reverse Voltage Vr Continuous - 1 V Continuous Operating Current Iop Continuous - 200 mA - - - 500 V 1 ESD Susceptibility Continuous 1 Based on human-body model of R = 1500 Ohm and C = 100 pF. In general, ESD precautions should be taken to avoid damage to the device | REV 2015.09 Information contained herein is deemed reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specification at any time without notice. G1033-032, 1490 nm GPON Laser Diode Chip FIBER OPTICS DATASHEET | SEPTEMBER 2015 Chip Electrical/Optical Performance Characteristics Parameter Symbol Condition Min Typ Max Unit Operating Temperature Top - 0 +25 +85 °C Threshold Current ITH +25°C +85°C - 7 26 20 45 mA Slope Efficiency QE +25°C +85°C 0.30 0.20 0.36 - mW/mA +25°C - - 4.5 12 Ω VOP - 1.3 1.5 V nm DC Resistance R Operating Voltage Central Wavelength 1 λ At Ith+20mA 1470 1490 1510 SMSR - 30 40 - dB - Full Width, Half Max - 32 36 deg Beam Divergence Angle, Horizontal - Full Width, Half Max - 27 30 deg Laser Reverse Voltage Vr - 1 - - V Iop +25°C - - 100 mA Side Mode Suppression Ratio Beam Divergence Angle, Vertical Laser Operating Current 2 1 Unless otherwise specified 2 DC Outline Drawing Figure 1: Drawing of 1490nm DFB laser diode chip. Top view and cross-sectional views are shown. | REV 2015.09 Information contained herein is deemed reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specification at any time without notice. G1033-032, 1490 nm GPON Laser Diode Chip DATASHEET | SEPTEMBER 2015 FIBER OPTICS Ordering Information Part Number: G1033-032 Laser Safety This product meets the appropriate standard in Title 21 of the Code of Federal Regulations (CFR). FDA/CDRH Class 1M laser product. This device has been classified with the FDA/CDRH under accession number 0220309. All Versions of this laser are Class 1M laser product, tested according to IEC 60825-1:2007/EN 60825-1:2007 Single-mode fiber pigtail with SC/APC connectors (standard). Wavelength = 1.5 μm. Maximum power = 30 mW. Because of size constraints, laser safety labeling (including an FDA class 1M label) is not affixed to the module, but attached to the outside of the shipping carton. Product is not shipped with power supply. Caution: Use of controls, adjustments and procedures other than those specified herein may result in hazardous laser radiation exposure. | REV 2015.09 Information contained herein is deemed reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specification at any time without notice.