HWS466 GaAs DC-6 GHz SPDT Switch May 2011 V5 Features SON6L (2 x 3 mm) • Low Insertion Loss: 0.50 dB @ 2.7 GHz 0.60 dB @ 3.9 GHz 25.0 dB @ 2.7 GHz 25.0 dB @ 3.9 GHz • Low DC Power Consumption • Miniature SON6L (2x3 mm) Using Lead (Pb) free materials with RoHS compliant • Isolation: • PHEMT process Description The HWS466 is a GaAs PHEMT MMIC SPDT switch operating at DC-6 GHz in a low cost miniature SON6L (2 x 3 mm) plastic lead (Pb) free package. The HWS466 features low insertion loss and high linearity with very low DC power consumption. This switch can be used in WiMAX or IEEE 802.11a/b/g WLAN PC card and access point applications as transmit/receive switch, antenna diversity switch, or band-selection switch. Electrical Specifications at 25°C with 0, +3V Control Voltages Parameter Test Conditions Insertion Loss 0.10-6.00 GHz 2.30-2.70 GHz 3.30-3.90 GHz 5.15-5.88 GHz Isolation 0.10-6.00 GHz 2.30-2.70 GHz 3.30-3.90 GHz 5.15-5.88 GHz Return Loss Input Power for One dB Compression Second and Third Harmonics Input Third Order Intermodulation Intercept Point Typ. Max. Unit 0.75 0.50 0.60 0.75 0.70 0.90 1.10 dB dB dB dB 25.0 25.0 25.0 27.5 dB dB dB dB 0.10-6.00 GHz 12 dB 2.00-6.00 GHz @+3V @+5V 36 38 dBm dBm Pin=20 dBm -75 dBc 25 dBm Per Tone, 3.80 GHz @+3V @+5V 57 60 dBm dBm 50 nsec Switching Time Control Current Min. @+3V 20.0 20.0 22.0 5 100 uA Note: All measurements made in a 50 ohm system with 0/+3.0V control voltages, unless otherwise specified. Hexawave Inc. 2 Prosperity Road II, Science Park, Hsinchu, Taiwan. TEL 886-3-578-5100 FAX 886-3-577-0512 http://www.hw.com.tw All specifications are subject to change without notice. HWS466 GaAs DC-6 GHz SPDT Switch May 2011 V5 Absolute Maximum Ratings Typical Performance Data with 8pF Capacitors @ +25°C Parameter Insertion Loss vs Frequency -0.3 Insertion Loss(dB) -0.4 Absolute Maximum RF Input Power +36 dBm @ +3V Control Voltage +6V Operating Temperature -0.5 -40°C to +85°C Storage Temperature -65°C to +150°C -0.6 -0.7 Pin Out (Top View) -0.8 CB -0.9 2.0 2.5 3.0 3.5 4.0 4.5 5.0 Frequency(GHz) 5.5 6.0 RF1 6 2 5 RFC 3 4 VC2 CB GND Isolation vs Frequency VC1 1 RF2 CB -15 Isolation(dB) -20 Note: 1. DC blocking capacitors CB=8pF are required on all RF ports. 2. Exposed pad in the bottom must be connected to ground by via holes. -25 -30 -35 -40 Logic Table for Switch On-Path -45 2.0 2.5 3.0 3.5 4.0 4.5 5.0 Frequency(GHz) 5.5 6.0 Return Loss vs Frequency VC1 VC2 RFC-RF1 RFC-RF2 1 0 On Off 0 1 Off On -5 ‘1’ = +2.7V to +5V ‘0’ = 0V to +0.2V Return Loss(dB) -10 -15 -20 -25 -30 -35 2.0 2.5 3.0 3.5 4.0 4.5 5.0 Frequency(GHz) 5.5 6.0 Hexawave Inc. 2 Prosperity Road II, Science Park, Hsinchu, Taiwan. TEL 886-3-578-5100 FAX 886-3-577-0512 http://www.hw.com.tw All specifications are subject to change without notice.