4+2CH serial input motor driver IC for DSC

G2009
Global Mixed-mode Technology Inc.
4+2CH serial input motor driver IC for DSC
Features
General Description
„ Built in 3 full-swing/constant voltage drivers
G2009 is a 4+2-channel H-Bridge motor drivers IC for the
digital camera and so on. It has three full-swing/constant
voltage drivers and one full-swing/constant current drivers.
G2009 can be operated in serial control mode or partial
exterior control mode. When operating in partial exterior
control mode, the mode of each CH is fixed by initial
serial control setting. When operating in serial control
mode, the mode of each driver can be setting by serial
control.
„
„
„
„
„
„
„
„
„
„
switched by serial control with brake function.
Built in 1 constant current drivers for shutter or
IRIS.
Low on-resistance (1.2Ω, sum of on-resistance of
upside and bottom side).
Output current:Iout<=0.8A(max.) for each channel.
Build-in thermal shutdown (TSD, 150°C).
CH1/2 corresponds to STM control of 2-2 phase or
1-2 phase.
Built in exclusive control mode: CH13/23 Æ the
combination control mode of 5CH is set.
Built in exclusive control mode: CH3/4(for DCM)
Æ the combination control mode of 6CH is set.
Power save mode corresponds by serial control
setup.
PI (photo interrupter drive) 3 channel built-in.
Small 20TQFN (3×3mm) is adopted.
Ordering Information
ORDER
NUMBER
MARKING
G2009RZ1U
2009
TEMP.
RANGE
PACKAGE
(Green)
-20°C to +85°C TQFN3X3-20
Note: RZ: TQFN3X3-20
1: Bonding Code
U: Tape & Reel
Applications
„ Stepping motor driver/ DC motor driver for DSC
Pin Configurations
OUT1B
1
OUT2A
2
OUT1A
SLD
SCLK
SDAT
IN1
20
19
18
17
16
TOP VIEW
21 GND
Thermal
Pad (EP)
15
IN2
14
IN3
13
VCC
10
PI2
PI1
11
9
5
OUT4B
OUT3A
8
PI3
RNF4
12
7
4
OUT4A
VM
6
3
OUT3B
OUT2B
CH1~3ÆCV/FS
CH4 Æ4A:CC/CV/FS
4B:CC/FS
G2009 TQFN3X3-20
Note: Recommend connecting the Thermal Pad to
the Ground for excellent power dissipation.
TEL: 886-3-5788833
http://www.gmt.com.tw
Ver: 0.1
Jun 29, 2010
1