www.niccomp.com/pcn | Technical Support: [email protected] June 15th 2011 SUB: PCN – Product Change Notification Product Type: SMT Power Inductors NIC Series: NPI_P Specification: www.niccomp.com/catalog/npi_p.pdf THE FOLLOWING IS NOTICE OF SPECIFICATION CHANGE ON BELOW REFERENCED NIC COMPONENTS PRODUCTS. EFFECTIVE: Immediately with transition completed September 1st 2011 REASON FOR CHANGE: Standardize construction to industry standards 1.) Dimensions: • Dimensions changed as shown in below table NPI31P Dimension Legacy Comp Width “A” 9.91 Comp Length “B” 13.5 Comp Height “C” 6.35 Land Pad Gap “G” 8.36 Land Pad Width “H” 5.0 Land Pad Length “I” 1.8 NPI52P Dimension Legacy Comp Width “A” 16.26 Comp Length “B” 22.35 Land Pad Gap “G” 14.35 Land Pad Width “H” 8.64 Land Pad Length “I” 3.18 Dimensions “D” and “F” removed from NPI_P specification New 9.9 Max. 13.2 Max. 6.4 Max. 8.6 Typ. 4.1 Typ. 1.6 Typ. New 15.2 Max. 18.5 Max. 14.0 Typ. 6.4 Typ. 1.9 Typ. I S O 9 0 0 1: 2 0 0 8 R E G I S T E R E D www.niccomp.com/pcn | Technical Support: [email protected] 2.) The following part numbers are going EOL effective September 1st 2011 Suggested Alternate & EOL Part Number Inductance (uH) Replacement Part Numbers See NIC QuickBuilder / www.niccomp.com/QB NPI31P5R6MTRF 5.6uH See NIC QuickBuilder / www.niccomp.com/QB NPI31P6R8MTRF 6.8uH See NIC QuickBuilder / www.niccomp.com/QB NPI31P8R2MTRF 8.2uH See NIC QuickBuilder / www.niccomp.com/QB NPI31P100MTRF 10uH Prepared by: Technical Product Marketing Group / [email protected] ÎFollow NIC PCN alerts to get email notifications of EOL and PCN announcements at www.niccomp.com/pcn I S O 9 0 0 1: 2 0 0 8 R E G I S T E R E D