HIGH−FREQ ALUMINUM ELECTROLYTIC HD SERIES SUBMINIATURE (Radial Lead, Horizontal Deflection) MECHANICAL SPECIFICATIONS (Cont’d) The NTE HD series of aluminum electrolytic non−polarized capacitors are designed specifically for horizontal deflection current correction where high frequency and high ripple current occur. RATINGS Capacitance Range: 1.0µf to 10µf Tolerance: ±20% Voltage Range: 25 Volts and 50 Volts PERFORMANCE SPECIFICATIONS Marking: Consists of series type, nominal capacitance, rated voltage, temperature range, anode and/or cathode identification, NTE identification. Recommended Cleaning Solvents: Methanol, isopropanol ethanol, isobutanol, petroleum ether, propanol and/or commercial detergents. Halogenated hydrocarbon cleaning agents such as Freon (MF, TF, or TC), trichloroethylene, trichloroethane, or methylchloride are not recommended as they may damage the capacitor. CASE SIZE AND DIMENSIONS: Operating Temperature Range: −25°C to +85°C (−13°F to +185°F) Leakage Current: I ≤ 0.2CV (measured after 5 minutes of applied rated voltage) I = Leakage Current (µA) C = Nominal Capacitance (µf) V = Rated Voltage (V) Capacitance Tolerance: ±20% (M) measured at +20°C (+68°F), 1kHZ Load Life: 1000 Hrs @ 12V DC, +70°C (+158°F), at specified ripple current Leakage Current: Initial specified value or less Dissipation Factor: < 200% of specified value Capacitance Change: Within ±15% of initial value Shelf Life: 500 Hrs @ +85°C (+185°F), no voltage applied Leakage Current: Initial specified value or less Dissipation Factor: < 200% of specified value Capacitance Change: Within ±15% of initial value ORDERING INFORMATION HD 4.7 M 50 Series Capacitance Tolerance 15.0 Min dØ L’ A ±0.5 5.0 Min D’ Ø HD Series Dimensions: Diameter (D Ø) x Length (L): mm Capacitance (µf) 1.0 2.2 3.3 4.7 5.6 6.8 8.2 10.0 25V and 50V 12.5 x 20 12.5 x 25 16 x 25 16 x 31.5 16 x 31.5 16 x 35.5 18 x 35.5 18 x 40 Ripple Current* (Ap−p) 2.0 3.0 4.0 5.0 6.0 7.0 8.0 9.0 * Allowable ripple current @ 70°C, 12V DC, and 15.75kHZ Voltage MECHANICAL SPECIFICATIONS Lead Solderability: Meets the requirements of MIL−STD 202, Method 208 36 Insulating Sleeve NTE Electronics, Inc. HD Mechanical Specs: Dimensions (mm) Outside Diameter (D Ø) Lead Spacing (A) Lead Wire (d Ø) Voice (973) 748−5089 FAX (973) 748−6224 12.5 5.0 0.6 16 7.5 0.8 18 7.5 0.8 http://www.nteinc.com