Xeon 20V Pure White LED OS4WNNE1E1E ■Features ■Outline ● Highest Luminous Flux ● Super Energy Efficiency ● Long Lifetime Operation ● Superior UV Resistance Dimension 3.6 BackView ■Applications ● Read lights (car, bus, aircraft) ● Portable (flashlight, bicycle) ● Bollards / Security / Garden ● Traffic signaling / Beacons ● In door / Out door Commercial lights ● Automotive Ext Unit:mm Tolerance:±0.30mm Tolerances are for reference only ■Absolute Maximum Rating Item (Ta=25℃) ■Directivity Symbol Value Unit DC Forward Current IF 30 mA Pulse Forward Current* IFP 50 mA Reverse Voltage VR 25 V Power Dissipation PD 660 mW Operating Temperature Topr -30 ~ +85 ℃ Storage Temperature Tstg -40~ +100 ℃ Lead Soldering Temperature Tsol 260℃/5sec - Duty ratio max 1/10 ■Electrical -Optical Characteristics ■Forward Operating Current (DC) (Ta=25℃) Item Symbol Condition Min. Typ. Max. Unit DC Forward Voltage VF IF=30mA 18 20 22 V DC Reverse Current IR VR=25V - - 10 µA Luminous Flux Φv IF=30mA 60 75 - lm Color Temperature CCT IF=30mA - 6500 - K Chromaticity x IF=30mA - 0.31 - - Coordinates* y IF=30mA - 0.33 - - 2θ1/2 IF=30mA - 140 - deg 50% Power Angle 0 400 Forward Current, IF (mA) *Pulse width Max.10ms 0 350 300 250 200 150 100 50 RJ-A=60℃/W RJ-A=50℃/W RJ-A=40℃/W RJ-A=30℃/W 0 0 25 50 100 75 Ambient Temperature, TA (℃) Note: Don’t drive at rated current more than 5s without heat sink for Xeon 1 emitter series. LED & Application Technologies http://www.optosupply.com VER C.0 125 Xeon 20V Pure White LED OS4WNNE1E1E Product development ■ Soldering Heat Reliability (DIP): Reflow soldering Profile · Reflow soldering should not be done more than two times. · When soldering, do not put stress on the LEDs during heating. · After soldering, do not warp the circuit board. · Repairing should not be done after the LEDs have been soldered. When repairing is unavoidable, a double-head soldering iron should be used. It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing. Solder Average ramp-up rate = 3ºC/sec. max. Preheat temperature: 150º~180ºC Preheat time = 120 sec. max. Ramp-down rate = 6ºC/sec. max. Peak temperature = 220ºC max. Time within 3ºC of actual peak temperature = 25 sec. max. Duration above 200ºC is 40 sec. max. LED & Application Technologies http://www.optosupply.com VER C.0