NJM2132 SINGLE-SUPPLY LOW POWER DUAL OPERATIONAL AMPLIFIER ■ GENERAL DESCRIPTION The NJM2132 is a general purpose single supply low power dual operational amplifier. The features of low operating current,wide and low perating voltage,high input inpedance,and single supply operation are suitable for battery operated items. ■ FEATURES ● Operating Voltage ( +2.7V~+32V ) ● Low Operating Current ( 180µA typ.@ V+=5V,each amplifier ) ● Slew Rate ( 2.1V/µs typ. ) ● Gain Bandwidth Product ( 1.8MHz typ. ) ● Bipolar Technology ● Package Outline DIP8,DMP8,SSOP8 ■ PACKAGE OUTLINE NJM2132D NJM2132M NJM2132V ■ PIN CONFIGURATION NJM2132D NJM2132M NJM2132V PIN FUNCTION 1.A OUTPUT 2.A –INPUT 3.A +INPUT 4.V5.B +INPUT 6.B –INPUT 7.B OUTPUT 8.V+ ■ EQUIVALENT CIRCUIT ( 1/2 Shown ) V+ V− Ver.2013-01-22 -1- NJM2132 ■ ABSOLUTE MAXIMUM RATINGS ( Ta=25˚C ) PARAMETER Supply Voltage Differential Input Voltage Input Voltage SYMBOL V+ VID VIC Power Dissipation PD Operating Temperature Range Storage Temperature Range Topr Tstg RATINGS 36 ± 36 -0.3~+36 ( note ) ( DIP8 ) 500 ( DMP8 ) 300 ( SSOP8 ) 250 -40~+85 -50~+125 UNIT V V V mW ˚C ˚C ( note ) When the supply voltage is less than +36V, the absolute maximum input voltage is equal to the supply voltage. ■ ELECTRICAL CHARACTERISTICS ( V+/V-=±15V,Ta=25˚C ) PARAMETER Operating Voltage Input Offset Voltage VIO Drift Input Offset Current Input Bias Current Large Signal Voltage Gain Input Common Mode Voltage Range Common Mode Rejection Ratio Supply Voltage Rejection Ratio Maximum Output Voltage Swing SYMBOL V+ VIO Operating Current ∆VIO/T IIO IB AV VICM CMR SVR VOM +VOM -VOM ICC Output Source Current Output Sink Current Input Resistance Input Capacitance Close Loop Output Impedance Equivalent Input Noise Voltage Slew Rate Gain Bandwidth Product Power Bandwidth ISOURCE ISINK RIN Ci ZO en SR GB BWP Phase Margin ØM Amplitude Margin Am Total Harmonic Distortion THD Channel Separation -2- CS TEST CONDITION Single Supply RS=0Ω + V =+5V,V =0V,RS=0Ω RS=0Ω RL≥10kΩ,VO=±10V RS≤10kΩ RS=100Ω RL=10kΩ V+=+5V,V-=0V RL=10kΩ RL=∞ ( all Amp. ) V+=+5V,V-=0V VIN+=1V,VIN-=0V VIN+=0V,VIN-=1V f=1.0MHz RS=100Ω,f=1kHz RL=10kΩ f=100kHz AV=+1.0,RL=10kΩ VO=20VP-P,THD=5% RL=10kΩ RL=10kΩ,CL=100pF RL=10kΩ RL=10kΩ,CL=100pF AV=+10,RL=10kΩ f=10kHz,2≤VO≤20VP-P f=10kHz,Input Referrd MIN. +2.7 90 -15~+13.5 80 80 ± 13.6 3.5 2.2 15 - TYP. 2.0 2.5 10 5 20 100 90 100 ± 14.2 4.3 0.05 440 360 3.6 27 300 0.8 100 32 2.1 1.8 MAX. +32 4.5 5.0 20 100 0.15 500 500 - UNIT V mA mA MΩ pF Ω nV/√Hz V/µs MHz - 35 - kHz - 60 45 15 5.0 - - 0.03 - % - 120 - dB mV µV/˚C nA nA dB V dB dB V µA deg. dB Ver.2013-01-22 NJM2132 ■ TYPICAL CHARACTERISTICS Operating Current vs. Operating Voltage (Dual Supply , RL=∞ ,Ta=25℃) (Single Supply , RL=∞ ,Ta=25℃) Operating Current Icc (mA) Operating Current Icc (mA) Operating Current vs. Operating Voltage 0 ±5 ±10 ±15 + ±20 Operating Voltage V+ (V) − Operating Voltage V /V (V) Maximum Output voltage Swing vs. Operating Voltage Maximum Output voltage Swing vs. Operating Voltage (RL=10kΩ,Ta=25℃) 0 ±4 ±8 ±12 ±16 Operating Voltage V+/V− (V) Ver.2013-01-22 ±20 Maximum Output voltage Swing ±VOM (V) Maximum Output voltage Swing ±VOM (V) (RL=10kΩ,Ta=25℃) Operating Voltage V+ (V) -3- NJM2132 ■ TYPICAL CHARACTERISTICS Maximum Output voltage Swing vs. Operating Voltage Maximum Output voltage Swing ±VOM (V) + − (V /V =±15V,Ta=25℃) Load Resistance RL (kΩ) Maximum Output voltage Swing ±VOM (V) Maximum Output voltage Swing vs. Operating Voltage + (V =+5V , Ta=25℃) Load Resistance RL (kΩ) Voltage gain Av (dB) Gain Phase Frequency f (Hz) -4- Phase Margin φM (deg) Voltage gain phase vs. Frequency [CAUTION] The specifications on this databook are only given for information , without any guarantee as regards either mistakes or omissions. The application circuits in this databook are described only to show representative usages of the product and not intended for the guarantee or permission of any right including the industrial rights. Ver.2013-01-22