Available as: RF AMPLIFIER MODEL CZ8110 Features Typical Intermodulation Performance at 25 º C Replacement for the Motorola MWA 110 Low Noise Figure: <4 dB Typical Operating Temp. -55 ºC to +125 ºC Environmental Screening Available Second Order Harmonic Intercept Point ...... +15 dBm (Typ.) Second Order Two Tone Intercept Point ....... + 8 dBm (Typ.) Third Order Two Tone Intercept Point ........... +10 dBm (Typ.) Absolute Maximum (No Damage) Ratings Specifications CHARACTERISTIC Frequency CZ8110, 3 Pin TO-39 (T10) TYPICAL Ta= 25 ºC 100 kHz - 400 MHz Gain (dB) Power @ 1 dB Comp. (dBm) Reverse Isolation (dB) VSWR In Out Noise figure (dB) Power Vdc mA MIN/MAX Ta = -55 ºC to +125ºC 100 kHz - 400 MHz 15 13.0 Min. -0.2 -5.0 Min. -19 <1.5:1 <2.0:1 -18 Max. 2.5:1 Max. 2.5:1 Max. <4.0 +3 10 5.5 Max. +3 12 Max. Ambient Operating Temperature .............. -55ºC to + 125 ºC Storage Temperature ............................... -62ºC to + 150 ºC Case Temperature ................................................. + 125 ºC DC Voltage ........................................................... + 6 Volts DC Current .............................................................. 25 mA Continuous RF Input Power ................................... + 6 dBm Short Term RF Input Power ...... 50 Milliwatts (1 Minute Max.) Maximum Peak Power ................... 0.5 Watt ( 3 μsec Max.) Revision 6/2/2012 Decoupling Impedance is 1 kOhm Note: Care should always be taken to effectively ground the case of each unit. Typical Performance Data Gain (dB) 17 0 Reverse Isolation (dB) 15 - 10 - 20 4 14 - 30 3 16 13 Start 100 kHz Stop 400 MHz 1 dB Comp. (dBm) +2 - 40 Noise Figure (dB) 6 5 2 Start 100 kHz Stop 400 MHz Input VSWR 2.0 Start 100 kHz Stop 400 MHz Output VSWR 3.0 0 -2 -4 -6 2.0 1.5 Start 100 kHz Legend Stop 400 MHz +25 ºC 1.0 Start 100 kHz Stop 400 MHz 1.0 Start 100 kHz Stop 400 MHz +125 ºC - - - - - - -55 ºC Application Information The CZ82X0 Series Amplifiers are designed for application in 50 ohm systems. Three external capacitors and a decoupling impedance are required. The decoupling impedance must be large in comparison to the 50 ohm load to minimize gain reduction. Data sheet curves are based on the noted decoupling impedance. The external capacitors determine the low frequency recponse of the Amplifier. Schematic Diagram CZ Series Amp 50 Ohm Input +Vcc Decoupling Impedance 50 Ohm Output Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, Florida 32905 · PH (888) 553-7531 · Fax (888) 553-7532 www.SpectrumMicrowave.com Spectrum Microwave · 2707 Black Lake Place · Philadelphia, Pwnnsylvania 19154 · PH (215) 464-4000 · Fax (215) 464-4001