Standard RF/Microwave Amplifier

Model # TM6108
Available as:
TM6108, 4 Pin TO-8 (T4)
TN6108, 4 Pin 0.450” Sq. Surface Mount (SM3)
BX6108, SMA Connectorized Housing (H1)
Standard RF/Microwave Amplifier
Features
• Low Noise Figure: 3.3 dB
• Wide 1 – 250 MHz Bandwidth
• Environmental Screening Available
• Unconditionally Stable
Typical Intermodulation
Performance at 25 ºC
Technical Specifications
Characteristic
TYPICAL
Ta = +25 ºC
MIN/MAX
Ta = -55ºC to +85 ºC
Frequency
1 – 250 MHz
1 – 150 MHz
Gain (dB)
15
14 Min.
Power @ 1 dB Comp. (dBm)*
+25
+23.5 Min.
Reverse Isolation (dB)
-28
--
In
1.75:1
2.0:1 Max.
Note: Measured at 50 MHz at 25C.
Out
1.75:1
2.0:1 Max.
Noise Figure (dB)**
3.3
4.5 Max.
Absolute Maximum
(No Damage) Ratings
Power
Vdc
+15
+15
Operating Temperature
-55ºC to +100 ºC
mA
109
115 Max.
Storage Temperature
-62ºC to +125ºC
Case Temperature
+125 ºC
DC Voltage
+18 Volts
Continuous
RF Input Power
+17 dBm
Short Term
RF Input Power
100 Milliwatts
(1 Minute Max.)
Maximum Peak Power
0.5 Watt
(3 µsec Max.)
VSWR
1) Care should always be taken to effectively ground the case of each unit
2) Typical values are measured at 25°C, but not guaranteed.
3) Package drawings below are for reference only.
*Power Output @1 dB Compression: 1 dB lower below 2 MHz.
**Noise Figure: 10-250 MHz.
Second Order Harmonic
Intercept Point:
+66 dBm (Typ.)
Second Order Two Tone
Intercept Point:
+60 dBm (Typ.)
Third Order Two Tone
Intercept Point:
+43 dBm (Typ.)
Rev Date: 1/22/2014
© API Technologies Corp. Proprietary Information
Page # 1
|
www.apitech.com
|
micro.apitech.com
|
+1.888.553.7531
|
[email protected]
Model # TM6108
Technical Performance
Rev Date: 7/30/2015
© API Technologies Corp. Proprietary Information
Page # 2
|
www.apitech.com
|
micro.apitech.com
|
+1.888.553.7531
|
[email protected]
Model # TM6108
Instructions
Grounding Instructions
Care should be taken to effectively ground each unit.
Revisions
API reserves the right to make revisions to both product and/or the information contained within their
datasheets without advanced notice.
Min./Max. Values
Specifications are guaranteed when tested in a 50 Ω (ohm) system.
Typical performance graphs and values are measured at 25°C, but not guaranteed.
1) Outlines drawings below are for reference only.
Rev Date: 7/30/2015
© API Technologies Corp. Proprietary Information
Page # 3
|
www.apitech.com
|
micro.apitech.com
|
+1.888.553.7531
|
[email protected]