PI5C3303 SOTiny™ 2:1 Mux/DeMux Bus Switch Features Description • Near-Zero propagation delay Pericom Semiconductor’s PI5C3303 is a single 2:1 Mux/DeMux digital switch designed with a fast enable. When enabled using the Bus Enable (BE) pin, the “A” or “B” pin is directly connected to the “C” pin. The bus switch introduces no additional propagation delay or additional ground bounce noise. • 5Ω switches connect inputs to outputs • Direct bus connection when switches are ON • Ultra Low Quiescent Power (0.1µA typical) – Ideally suited for notebook applications The PI5C3303 device has an active HIGH enable. • Packaging (Pb-free & Green available): – 6-pin plastic S0T23 (T) Block Diagram Pin Configuration A C BE BE 1 6 A VCC 2 5 C GND 3 4 B B Truth Table(1, 2) Pin Description BE A B C Function Pin Name L C X A Connect A & C BE Switch Enable H X C B Connect B & C A Bus A at pin 6 B Bus B at pin 4 C Bus C at pin 5 Notes: 1. H = High Voltage Level L = Low Voltage Level X = Don’t Care 2. A = I/O at pin 6 B = I/O at pin 4 C = I/O at pin 5 09-0001 1 Description VCC Power GND Ground PS8367F 10/26/09 PI5C3303 SOTiny™ 2:1 Mux/DeMux Bus Switch Maximum Ratings (Above which the useful life may be impaired. For user guidelines, not tested.) Note: Stresses greater than those listed under MAXIMUM RATINGS may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability. Storage Temperature...........................................................–65°C to +150°C Ambient Temperature with Power Applied..........................–40°C to +85°C Supply Voltage to Ground Potential.......................................–0.5V to +7.0V DC Input Voltage...................................................................–0.5V to +7.0V DC Output Current..............................................................................120mA Power Dissipation..................................................................................0.5W DC Electrical Characteristics (Over the Operating Range, TA = –40°C to +85°C, VCC = 5V ± 10%) Parameters Test Conditions(1) Description Min. Typ.(2) Max. VIH Input HIGH Voltage Guaranteed Logic HIGH Level 2.0 VIL Input LOW Voltage Guaranteed Logic LOW Level –0.5 IIH Input HIGH Current VCC = Max., VIN = VCC ±1 IIL Input LOW Current VCC = Max., VIN = GND ±1 IOZ High Impedence Output Current VCC = Max., VOUT = 0V or VCC ±1 Switch On-Resistance(3) RON Units V 0.8 VCC = 4V, VIN = 2.4V, ION = –15mA 10 20 VCC = 4.5V, VIN = 0V, ION = 30mA or 64mA 4 7 VCC = 4.5V, VIN = 2.4V, ION = –15mA 7 15 µA Ω Notes: 1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type. 2. Typical values are at VCC = 5.0V, TA = 25°C ambient and maximum loading. 3. Measured by the voltage drop between A and B pin at indicated current through the switch. On-Resistance is determined by the lower of the voltages on the two (A, B) pins. Capacitance (TA = 25°C, f = 1 MHz) Parameters(1) CIN Description Test Conditions Input Capacitance COFF A/B Capacitance, Switch Off CON A/B Capacitance, Switch On Typ.(4) Units 3 VIN = 0V 5 pF 12 Notes: 1. This parameter is determined by device characterization but is not production tested. 09-0001 2 PS8367F 10/26/09 PI5C3303 SOTiny™ 2:1 Mux/DeMux Bus Switch Power Supply Characteristics Test Conditions(1) Parameters Description Min. ICC Quiescent Power Supply Current VCC = Max. VIN = GND or VCC ∆ICC Supply Current per Input @ TTL HIGH VCC = Max. VIN = 3.4V(3) Typ.(2) Max. Units 0.1 3.0 µA 2.5 mA Notes: 1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device. 2. Typical values are at VCC = 5.0V, +25°C ambient. 3. Per TTL driven input (VIN = 3.4V, control inputs only); A and B pins do not contribute to ICC. Switching Characteristics over Operating Range Parameters Description tPLH tPHL Propagation Delay(1, 2) A to B, B to A tPZH tPZL Bus Enable Time tPHZ tPLZ Bus Disable Time Test Conditions(3) CL = 50pF RL = 500Ω VCC = 4.5V Min. Max. VCC = 4V Min. Max. 0.25 0.25 1.0 4.9 5.5 1.0 4.2 4.5 Units ns Notes: 1. This parameter is guaranteed but not tested on Propagation Delays. 2. The bus switch contributes no propagational delay other than the RC delay of the On-Resistance of the switch and the load capacitance. The time constant for the switch alone is of the order of 0.25ns for 50pF load. Since his time constant is much smaller than the rise/fall times of typical driving signals, it adds very little propagational delay to the system. Propagational delay of the bus switch when used in a system is determined by the driving circuit on the driving side of the switch and its interaction with the load on the driven side. 3. See test circuit and waveforms. 09-0001 3 PS8367F 10/26/09 PI5C3303 SOTiny™ 2:1 Mux/DeMux Bus Switch Test Circuit VCC 7.0V 500Ω VIN VOUT Pulse Generator D.U.T 50pF 500Ω RT CL Switch Positions(1) Test Switch Open Drain Disable LOW Enable LOW 7V All Other Inputs Open Notes: 1. CL = Load Capacitance: inlcudes jig and proble capacitance. RT = Termination Resistance: should be equal to the ZOUT of the Pulse Generator. Enable and Disable Timing Enable Disable Control Input Output tPZL Switch 3V 1.5V 0V tPLZ 3V 1.5V 0.3V tPHZ tPZH Output Normally High 3V 0.3V 1.5V 0V VOL VOH 0V Notes: • Input Control Enable = Low; Input Control Disable = High • Pulse Generator for All Pulses: Rate ≤ 1.0 MHz; ZOUT ≤ 50Ω; tF, tR, ≤ 2.5ns 09-0001 4 PS8367F 10/26/09 PI5C3303 SOTiny™ 2:1 Mux/DeMux Bus Switch Packaging Mechanical: 6-Pin Plastic SOT23 (T) 1 DATE: 10/19/09 DESCRIPTION: 6-pin, Small Outline Transistor Plastic Package (SOT23) PACKAGE CODE: T (T6) DOCUMENT CONTROL #: PD-1912 REVISION: C 09-0131 Note: • For latest package info, please check: http://www.pericom.com/products/packaging/mechanicals.php Ordering Information Ordering Code PI5C3303TEX Package Code T Package Description Pb-free & Green, 6-Pin Plastic SOT23 Notes: • Thermal characteristics can be found on the company web site at www.pericom.com/packaging/ • E = Pb-free & Green • X suffix = Tape/Reel Pericom Semiconductor Corporation • 1-800-435-2336 • www.pericom.com 09-0001 5 PS8367F 10/26/09